Instrukcja obsługi Dimplex SKG20BLN

Dimplex piekarnik SKG20BLN

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dimplex SKG20BLN (5 stron) w kategorii piekarnik. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/5
Contact Details
Pleasenotethat some contact ofthe details on 
thisPDFdocumentmaynotbe current.
Pleaseuse  the following detailsifyouneedto
contactus:
Telephone:0844 879 3588
Email:customer.services@gdcgroup.co.uk
The widecustomer alsosupportsection websiteofour  features a
rangeof ofinformationwhichmaybe use availabletoyouandis 
24 ahours day.Itincludes:
• Operating  and installation instructions
• Easy   ‘How to use’ guides for storage heaters
• Service  and repairs
• Wheretobuyourproducts
• Literature downloads
• Heating  requirement calculator
 ‐Visit www.dimplex.co.uk/support
A division of GDC Group Ltd
Millbrook House Grange Drive Hedge End Southampton SO30 2DF
www.dimplex.co.uk
Re
g
istered No: 1313016 En
g
land
VAT GB 287 1315 50004
EEE Producer Registration Number –
WEE/GE0057TS
Paper from sustainable sources
640
620 390
Dimensions
(millimetres)
Installation and Operating Instructions
08/50672/1 Issue 1
Dimplex Stockbridge Stove
Model: SKG20BL
Important Safety Advice:
When using electrical appliances, Basic precautions
should always be followed to reduce the risk of fire,
electrical shock, and injury to persons, including the
following:
If the appliance is damaged, check with the supplier
before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a bath,
shower or swimming pool.
Do not locate the heater immediately below a fixed
socket outlet or connection box.
Do not cover the heater. Do not place material or
garments on the heater, or obstruct the air circulation
around the heater, for instance by curtains or furniture,
as this could cause overheating and a fire risk.
This appliance is not intended for use by children or
other persons without assistance or supervision if
their physical, sensory or mental capabilities prevent
them from using it safely. Children should be
supervised to ensure that they do not play with the
appliance.
Do not use this heater in series with a thermal control,
a program controller, a timer or any other device that
switches on the heat automatically, since a fire risk
exists when the heater is accidentally covered or
displaced.
Ensure that furniture, curtains or other combustible
material are positioned no closer than 1 metre from
the heater.
In the event of a fault unplug the heater.
Unplug the heater when not required for long periods.
Although this heater complies with safety standards,
we do not recommend its use on deep pile carpets or
on long hair type of rugs.
The appliance must be positioned so that the plug is
accessible.
If the supply cord is damaged it must be replaced by
the manufacturer or service agent or a similarly
qualified person in order to avoid a hazard.
Keep the supply cord away from the front of the heater.
Introduction
These fires incorporate a flame effect, which can be used
with or without heating, so that the comforting effect may be
enjoyed at any time of the year. The flame effect is provided
by a low wattage motor and two 60 watt lamps. Using the
flame effect on its own, therefore, requires little electricity.
The manual controls are located behind the firebox doors.
The remote control is packed separately in the carton. A choice
of 1kw or 2kw heat output is provided by the fan heater, which
is concealed beneath the unit.
These models are designed to be free standing and are
normally positioned against a wall.
Please note: Used in an environment where background
noise is very low, it may be possible to hear a sound which
is related to the operation of the flame effect. This is normal
and should not be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the
voltage marked on the heater must correspond to the supply
voltage.
Before switching on, please read the safety warnings and
operating instructions.
In the event of replacing the fuse in the plug supplied, a 13
amp fuse approved by ASTA to BS1362 must be used.
Fig. 1
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Operation
The controls are located behind the doors (see Fig. 2).
Connect the fire to your electricity supply.
Fig. 2
Note: When either the remote control or the manual controls
are used, the neon’s will come on for 3 seconds indicating
the relevant setting (see fig. 3).
neon’s for indicating
the operation level
Fig. 3
1. Slide open the battery cover on the back of the remote
control
2. Install two AAA batteries into the remote control (see
Fig. 4)
3. Replace the battery cover.
Battery information
Fig. 4
Batteries
Discard leaky batteries
Dispose of batteries in the proper manner according to
Provincial and local regulations. Any battery may leak electrolyte
if mixed with a different battery type, if inserted incorrectly, if all
the batteries are not replaced at the same time, if disposed of
in a fire or if an attempt is made to charge a battery not intended
to be recharged.
Fig. 5
Manual or Remote Operation
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to
prevent damage due to overheating.
This can happen if the heat outlet was restricted in any way.
The heater will switch on once the obstruction has been
removed and the heater has cooled. If the cut-out continues
to operate intermittently, the heater should be switched off
and a service agent contacted.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Remote Control
Warning: it takes time for
the receiver to respond
to the transmitter. Do not
press the buttons more
than once within two
seconds for correct
operation.
To turn off any of the
settings
Press the button once
Setting Operation Indication
Flame effect Press the ‘I’ button once Bottom Neon
Flame effect & 1kW heat Press the ‘I’ button again Bottom &
Middle Neon
Flame effect & 2kW heat Press the ‘I’ button again All 3 Neon’s
= Standby
= On
OF
F
ON
Note : The ON/OFF Switch must first be turned on to
operate either the manual or the remote controls.
Thermostat (T) - see Fig. 2
In order to maintain a certain room temperature, set
thecontroller to ‘max.’. Operate the appliance at full power
untilthe required room temperature is reached. Set back
thethermostatic controller until the appliance switches off
withan audible “click”. This temperature will be kept
almostconstant by the thermostatic control switching on
and offautomatically.Please note that the appliance can
only beswitched on when the thermostat setting is higher
then theroom temperature.
T
Controls

Specyfikacje produktu

Marka: Dimplex
Kategoria: piekarnik
Model: SKG20BLN

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Dimplex SKG20BLN, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje piekarnik Dimplex

Dimplex

Dimplex SKG20BLN Instrukcja

15 Sierpnia 2024

Instrukcje piekarnik

Najnowsze instrukcje dla piekarnik

Siemens

Siemens HE230210 Instrukcja

14 Stycznia 2025
Whirlpool

Whirlpool AKP 745 Instrukcja

14 Stycznia 2025
Delta

Delta GT-MO-06 Instrukcja

14 Stycznia 2025
Siemens

Siemens hb 66555 Instrukcja

14 Stycznia 2025
Bauknecht

Bauknecht SPC 3035 Instrukcja

14 Stycznia 2025
AEG

AEG Competence 54081 B b Instrukcja

14 Stycznia 2025
AEG

AEG EE4013031M Instrukcja

14 Stycznia 2025
Bartscher

Bartscher Pizzaoven NT 501 Instrukcja

14 Stycznia 2025
Siemens

Siemens hb 76r651 f 76l651 f Instrukcja

14 Stycznia 2025
Beko

Beko BIM22303XP Instrukcja

14 Stycznia 2025