Instrukcja obsługi Dension Gateway 500S

Dension Radia samochodowe Gateway 500S

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dension Gateway 500S (4 stron) w kategorii Radia samochodowe. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/4
INSTALL GUIDE
ice4Link Gateway 500 MOST
State of the art car integration
for media players, USB and
Bluetooth devices
GW5-9210-8
Set the DIP switches to the following
position and install the Gateway
500 as illustrated below:
2
3.
Car side
CDC
1a.
Remove the blue locking clip from the
middle of the bre optic housing.
Strain the hook carefully with a
sharp tool, while pulling out the
optical bre from the housing.
1b.
1c.
Installation Type 1:
Vehicles supporting multiple CD changers
and equipped with a CD changer
• Audi A4/S4/RS4/A5/A6/S6/RS6/A8/Q7
with MMI-2 High (colour)
These vehicles allow selection of Gateway audio sources
and the original CD changer through the existing car audio
controls.
1
Introduction
Gateway 500 emulates a CD changer and uses CD changer controls to access
oboard audio sources including iPod, USB devices and Dension Gateway
accessories. If your car is not already equipped with a CD changer, it may be
necessary to have the car programmed by your dealer in order to use the
GW500 with it.
Programming the car for GW500
Audi
No programming required
BMW non iDrive-4
If original CD changer tted and MP3 capability is available: no programming
is required.
If original CD changer tted and no MP3 capability is available:
a) Retrot “KMP3” option with service computer
b) Used in non text capable BMW mode
If original CD changer not tted or E60 M-ASK used: install GW500 and retrot
“IPOD option with service computer
BMW with iDrive-4
If original CD changer tted: no programming is required
If original CD changer not tted: install an original BMW CD changer and
retrot “CD Changer” temporarily option with service computer
Mercedes
Generally no programming is required but in some cases (e.g. no device was
connected onto the optical ring) it is needed to enable a CD changer with the
service computer.
Porsche
Generally it is needed to enable a CD changer with the service computer but
in rare cases the PCM accept the GW500 without this enabling process.
Saab 9-3
It is needed to enable a CD changer with the service computer using an
original CD changer.
Installation Type 2a:
Vehicles with an existing CD changer
These vehicles allow selection of Gateway audio sources and
the original CD changer by switching the mode between CD
Changer and Gateway mode.
Audi (MMI-2 Basic Monochrome)
Saab 9-3 (Rear CDC)
Porsche (CDR 23/24 and PCM I/II/2.1)
for longer CDC and car side cable use
FOA1PO1
Mercedes (NTG1-, NTG2- Audio 20/50 and
Comand)
CDR PCM
Text capable BMW E87, E90, E91, E92, E93,
E60/61, E63/E64, E65/E66 (03/2005-), E70
and Mini (non iDrive-4)
Non text capable BMW E65/E66 (-03/2005)
(non iDrive-4)
3
Package Content & Electrical Installation
1
2
3
DIP switch
Car side
CDC side
Power
harness
4
Power harness:
-red wire
(+12V non switched)
-black (GND)
Car side CDC side
BMW E90, E91, E92, E93 with iDrive-4
You must set the mode selector switch
to service mode (bypass, CD Changer)
position otherwise the service
computer may detect an unknown
device in the bre optic system which
can lead to errors reported.
i
Service/CDC
mode
When servicing your vehicle
Text Conguration
Saab & Mercedes vehicles require
nal conguration of the Gateway as
not all of the radios in these vehicles
support text display. After Gateway
500 has been installed, toggle the
mode selector switch six times (three
times on/o) and a conguration
menu will appear on the radio
display. Select the conguration
mode according to your head unit
listed in the conguration table. To
conrm the selection press and hold
; to discard the selection press
and hold
Track # Cong Mercedes
Command
Saab
Text
# 1 NO TEXT D D
# 2 Timeout - -
# 3 Text - -
# 4 +Cache - -
# 5 +Paging R R
# 6 +Select - R
For detailed information visit:
http://support.dension.com
D: Default, R: Recommended
7
i
HU
Car side
Installation Type 3a:
Vehicles with no existing CD changer
Set the DIP switches as shown below.
Text capable BMW E87, E90, E91, E92, E93, E60/61,
E63/E64, E65/E66 (03/2005-), E70
and Mini (non iDrive-4)
Audi (MMI-2 Basic Monochrome)
Saab 9-3 (Rear CDC)
Porsche (CDR 23/24 and PCM I/II/2.1)
Mercedes (NTG1-, NTG2- Audio 20/50 and
Comand)
If you are connecting Gateway 500 to the back
of the head unit, use this diagram:
CDR PCM
Non text capable BMW E65/E66 (-03/2005)
(non iDrive-4)
Car side
Installation Type 3b:
If you are installing to a free bre optic connector in the car
(CDC preparation) use this method:
654
Volvo S40/V50 - MY 2004-2007 with Basic and
High Performance sound system, without AUX in-
put, with CDC
Installation Type 2b:
ICM
(Display)
Car side
LED
Volvo XC90 - MY 2002-2006, with High Perfor-
mance and Premium sound system,
without AUX input, with CDC
Saab 9-3 (Front CDC)
BMW E90, E91, E92, E93 with iDrive-4
Use a CDC for enabling
Saab 9-3 (Front CDC)
The LED (arrowed) indicates
the current operating mode
ò= GW5 (Blue LED Solid)
ö = Service/CDC
(Blue LED Flashing)
LED


Specyfikacje produktu

Marka: Dension
Kategoria: Radia samochodowe
Model: Gateway 500S

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Dension Gateway 500S, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Radia samochodowe Dension

Instrukcje Radia samochodowe

Najnowsze instrukcje dla Radia samochodowe

JVC

JVC KD-R90BT Instrukcja

15 Października 2024
Kenwood

Kenwood KMM-X705 Instrukcja

15 Października 2024
Alpine

Alpine CDM-7870R Instrukcja

14 Października 2024
Hyundai

Hyundai H-CMD2009 Instrukcja

14 Października 2024
Dual

Dual XC4100 Instrukcja

13 Października 2024
Audiovox

Audiovox VXE 3010 Instrukcja

13 Października 2024
MB Quart

MB Quart PAB 5400 Instrukcja

13 Października 2024
Hyundai

Hyundai H-CDM8023 Instrukcja

13 Października 2024
Caliber

Caliber RCD110B Instrukcja

13 Października 2024
JVC

JVC KD-X30 Instrukcja

13 Października 2024