Instrukcja obsługi Dcybel Liberty

Dcybel Słuchawki Liberty

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dcybel Liberty (13 stron) w kategorii Słuchawki. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/13
MODEL Liberty
MODÈLE Liberty
MODEL Liberty
FOLDABLE BLUETOOTH HEADPHONES
CASQUE BLUETOOTH PLIABLE
OPVOUWBARE BLUETOOTH-KOPTELEFOON
INSTRUCTION MANUAL
MANUEL D’INSTRUCTIONS
GEBRUIKSAANWIJZING
Downloaded from www.vandenborre.be
WARNINGS
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
SYMBOL
This mark is applied to show the equipment conforms to European safety
and electro-magnetic compatibility standards.
BATTERY HANDLING AND USAGE
The product is supplied with one rechargeable Lithium 3.7V 300mAh battery incorporated in the
product which is not accessible and cannot be replaced. Therefore when the product reaches the
end of its useful life it must be disposed of at a recycling centre.
IMPORTANT SAFETY INSTRUCTIONS
• Read these instructions and keep them for future reference.
• Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry
tub, in a wet basement or near a swimming pool.
• Do not drop, throw or crush the headphones.
• Do not expose the headphones to humidity, dust or high temperature.
• Only use accessories specified by the manufacturer.
• Do not disassemble, modify, or attempt to repair the product.
• Check the laws and regulations on the use of mobile phones and hands-free equipment in the
areas where you drive. Always give full attention to driving and pull off the road and park before
making or answering a call if driving conditions require.
• Do not allow children to play with the headphones as it contains small parts that may cause a
choking hazard.
Turn off your headphones when pumping gas, handling flammable materials, or in any area with a
risk of explosion.
EN-1
1. Power button: Press and hold this button for about 2 seconds to turn on or off the
headphones.
2. Play/Pause, Call answer/end/reject button
3. Volume up / next track button
4. Volume down / previous track button
5. Indicator light
6. Microphone
7. Micro USB charging port
8. Socket for audio cable
OVERVIEW
Downloaded from www.vandenborre.be
CHARGING THE HEADPHONES
Before you use the headset for the first time, fully charge the battery for approximately 3 hours.
Charging the battery fully will help you get the longest possible playback and standby time.
Included with the headphones:
EN-2
PARING THE HEADPHONES TO YOUR BLUETOOTH DEVICE
1. Turn on the headphones by pressing and holding for about 2 seconds until the indicator
light flashes red and blue alternately .
The headphones will enter the pairing mode.
2. To pair, go to Bluetooth settings on your Bluetooth-enabled device and connect to “Liberty”.
3. When the headphones are paired, the indicator light will flash blue.
NOTE:
• If the headphones loses the connection (e.g. if your device is out of range), it will reconnect
automatically to your device if your device is back in range.
• Bluetooth devices have a maximum operating range of 10 metres and the actual range will vary
depending on current conditions (obstacles, battery power, interference, etc.).
To reset the Bluetooth connection with a new device, first disconnect the paired device by pressing
and holding for about 2 seconds.
NOTE: Do not attempt to pair or use the headphones while it is charging.
1. Connect the small end of the supplied micro USB cable into the charging port of the speaker.
Connect the other end of the cable into the USB port on your computer.
The charging indicator light will illuminate red.
2. When the battery is fully charged, the red indicator light will go out.
3. After charging, remove the micro USB cable.
Battery life
The fully-charged battery will provide about 8 hours of playback time depending on genres of music
and volume.
Low battery warning: When the indicator light flashes red at regular intervals, please recharge the
headphones.
1 x micro USB charging cable 1 x 3.5mm audio cable
To prevent possible hearing damage,
do not listen at high volume levels for long periods.
When the USB cable is used as the disconnect device, the disconnect device shall remain readily
operable.
Downloaded from www.vandenborre.be


Specyfikacje produktu

Marka: Dcybel
Kategoria: Słuchawki
Model: Liberty

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Dcybel Liberty, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Słuchawki Dcybel

Dcybel

Dcybel Liberty Instrukcja

2 Października 2024

Instrukcje Słuchawki

Najnowsze instrukcje dla Słuchawki

Klipsch

Klipsch R6i Instrukcja

15 Października 2024
Vakoss

Vakoss MH954 Instrukcja

14 Października 2024
Skullcandy

Skullcandy Cassette Instrukcja

14 Października 2024
Jabra

Jabra Wave Corded Instrukcja

14 Października 2024
Manta

Manta MM65 Instrukcja

14 Października 2024
AKG

AKG Y600NC Instrukcja

14 Października 2024
Audio-Technica

Audio-Technica ATH-ANC29 Instrukcja

13 Października 2024
Daewoo

Daewoo AVS1421 Instrukcja

13 Października 2024
Vakoss

Vakoss MH942 Instrukcja

13 Października 2024
SuperTooth

SuperTooth Freedom Instrukcja

13 Października 2024