Instrukcja obsługi Datel ps3 wireless gaming headset
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Datel ps3 wireless gaming headset (4 stron) w kategorii Dźwięk. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/4
Wireless Gaming Headset™
User Guide
Introduction
Congratulations on your purchase of Datel’s Wireless Gaming Headset. This headset has been specifically
developed for maximum performance and comfort in the heat of gaming battle.
The headset uses genuine Bluetooth wireless technology to communicate with your PS3. Before you can use
the headset you must first charge it and then register it with your console. Please read and follow this user
guide for information on how to do this.
Safety Information
Hearing Loss
Prolonged exposure to loud volumes may result in temporary or permanent damage to your
hearing. Be careful to not set the volume level too high on your headset. Always take regular breaks
when gaming or chatting.
The Headset
Indicator Light Used to communicate a number of
functions/states.
Volume
Controls +/-
Press (+) to increase and (-) to decrease
the earpiece volume.
Function
Button
Use to turn the headset on and off, pair
the headset and answer/end a call.
USB Charging
Jack
Remove the rubber cover then connect
this Jack to your PS3 to charge the
headset.
Speaker High quality over-the-ear speaker for
crystal clear audio.
Microphone Noise cancelling microphone should be
positioned slightly to the side of your
mouth.
Charging the Headset
The Wireless Gaming Headset comes with a built in Lithium Polymer battery that needs to be charged before
first use.
To charge the headset:
• Plug the USB charging cable (supplied) into any USB port on your PS3 and the other end into the USB
Charging Jack on the headset (you will need to remove the rubber cover first).
• Whilst charging, the Indicator Light will turn red.
• When charging is complete the Indicator Light will go off or flash red to alert you that the unit is fully
charged and ready to use.
Important charging advice:
• Before using the headset for the first time, be sure to charge it for at least 4 hours. Ideally, charge it
overnight (8-10hrs).
• For safety reasons, and to prevent damage to the headset, do not use the headset whilst it is
charging.
• Only use the original USB charger cable that came with the headset to charge it.
• Please recharge the Wireless Gaming Headset at normal room temperature.
When to recharge:
If the red light flashes during usage or when on standby, the battery is low and you should recharge the
headset as soon as possible. To avoid this happening, regularly recharge the headset between gaming
sessions.
Turning the Headset On/Off
To turn the headset on, press and hold the Function Button for 5 seconds. The Indicator Light will flash blue
3 times to confirm that the headset is now on. Whilst the headset remains on, the Indicator Light will flash
once every 10 seconds.
IMPORTANT: When using the headset with your PS3 console, press the Function Button once after switching
the headset on to activate it. Until you do this, some games or applications will not use the headset, even
though it is turned on.
To turn the headset off, press and hold the Function Button again for 5 seconds until the Indicator Light
flashes red 3 times.
Registering the Headset with your PS3
The first time you use the headset with your PS3 you will need to register it with the console and then select
it as an Audio Device. Follow these steps:
Registering the Bluetooth® Device
1. Ensure the headset is charged.
2. On your PS3’s browser menu go to ‘Settings’ then ‘Accessory Settings’ and finally ‘Register Bluetooth
Device’.
3. Select ‘Register Headset/Microphone/Headphones’. If prompted you will need to choose ‘Yes’ to
register a new Bluetooth device.
4. To put your headset in registration mode start with it switched off (see previous section). Next turn
it on by pressing and holding the Function Button for around 8 seconds until the Indicator Light
flashes continuously, alternating between blue and red.
5. Press ‘X’ on your controller to start scanning. Your PS3 should find a device called ‘BTH 068’. Click ‘X’
again to select this device.
6. When prompted for a Pass Key, enter “0000” and choose ‘OK’.
7. Registration is now complete.
Selecting the Headset as an Audio Device
1. On your PS3’s browser menu go to ‘Settings’ then ‘Accessory Settings’.
2. Under ‘Input Device’ select the device ‘BTH 068’ as Input and Output Device and choose OK. You
should see the microphone level displayed on screen confirming the headset is working correctly.
3. You are now ready to start your game or chat session.
Wearing the Headset
The headset can be worn on either ear. Rotate the
headset arm over the top of the headset to change ear
as shown.
Adjust the head band by sliding it out to achieve a
comfortable fit.
Position the mouthpiece so that it is close to your
mouth without being directly in front of it. This will
allow the mic to pick up your voice clearly without
picking up your breathing.
Using the Headset with your Games
Read the manual that came with your game for information on how to use the chat feature in your chosen
software. Where applicable, ensure that you select ‘BTH 068’ as your chosen input device from within the
game. If you want to hear through the headset’s speaker, choose the ‘BTH 068’ as your output device too.
Technical Support / Customer Services
Before contacting Datel’s customer service department, please ensure that you have read through and
understood the information in this manual.
Please ensure that you have information on when and where you purchased this product to hand.
DATEL CUSTOMER SERVICES EUROPE:
Specyfikacje produktu
| Marka: | Datel |
| Kategoria: | Dźwięk |
| Model: | ps3 wireless gaming headset |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Datel ps3 wireless gaming headset, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Dźwięk Datel
20 Września 2024
Instrukcje Dźwięk
- Dźwięk Sony
- Dźwięk Yamaha
- Dźwięk Logitech
- Dźwięk Philips
- Dźwięk JBL
- Dźwięk Roland
- Dźwięk Geemarc
- Dźwięk Nokia
- Dźwięk Bose
- Dźwięk Behringer
- Dźwięk Profoon
- Dźwięk DAP-Audio
- Dźwięk Kenwood
- Dźwięk Trust
- Dźwięk Focusrite
- Dźwięk Velleman
- Dźwięk Korg
- Dźwięk Zoom
- Dźwięk Sennheiser
- Dźwięk Jabra
- Dźwięk Samson
- Dźwięk Olympus
- Dźwięk ION
- Dźwięk TC Helicon
- Dźwięk NEC
- Dźwięk Fender
- Dźwięk Power Dynamics
- Dźwięk Advanced Bionics
- Dźwięk Amplicom
- Dźwięk Alto Professional
- Dźwięk Sony Ericsson
- Dźwięk Speedlink
- Dźwięk Envivo
- Dźwięk Aliph
- Dźwięk Sweex
- Dźwięk Phonak
- Dźwięk Mr Handsfree
- Dźwięk Gear4
- Dźwięk T-Mobile
- Dźwięk Bluetrek
- Dźwięk Starkey
- Dźwięk Iqua
- Dźwięk Bellman Symfon
- Dźwięk HUMANTECHNIK
- Dźwięk Griffin
- Dźwięk Native
- Dźwięk Inakustik
- Dźwięk Plextor
- Dźwięk MCS
- Dźwięk Velodyne
- Dźwięk Bang Olufsen
- Dźwięk Bellman
- Dźwięk Konig Electronic
- Dźwięk Xqisit
Najnowsze instrukcje dla Dźwięk
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024