Instrukcja obsługi CyberPower BAS34U24V

CyberPower UPS BAS34U24V

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla CyberPower BAS34U24V (2 stron) w kategorii UPS. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

BAS34U24V

CyberShield UPSs are designed to provide a local power solution for

cable telephony, wireless local loop (WLL), and fiber to the home

(FTTH) broadband equipment.

IMPORTANT SAFETY WARNINGS

(SAVE THESE INSTRUCTIONS)

This manual contains important instructions regarding the installation and operation of this device.

Read this manual thoroughly before attempting to unpack, install, or operate this device.

OVERVIEW

LED INDICATOR

LED Indicator

Ethernet Port LED Indicator

AC Power Cord Connector

DC Output Connector (5W/0.21A)

Universal (Serial) Port

Ethernet Port

External Battery Connector

DC Output Connector(24W/1A)

Rail Slot

Locking Clip

4 5 6 7 8

BATTERY REPLACEMENT AND INSTALLATION

BAS34U24V AND MOUNTING DETAILS

Step 1:

a. Upside down the unit.

b. Loosen four screws from enclosure.

Step 2:

a. Tack away the battery cover.

Step 3:

a. Remove the battery from enclosure.

Step 4:

a. Disconnect the battery cable connector.

b. Install a new battery by connecting the

cable connector.

Step 5:

a. Put the battery back into the compartment.

Step 6:

a. Replace the battery cover.

Step 7:

a. Tighten up four screws from the enclosure.

Mounting on DIN Rail Removing from DIN Rail

Step 8:

a. Upside down the unit to resume normal

operation.

Step 9:

a. Connect the AC cable to activate the unit.

User’s Manual for

CyberShield

STATUS

BATTERY

ETHERNET

PORT

Green

Red

Green

Indicates normal mode of operation.

Indicates the battery is supplying the power.

1.Battery mode : LED is on.

2.Line mode : LED is off.

3.Low battery : LED is blinking.

1.Battery replacement required : LED is on.

2.Battery is absent : LED is blinking.

Yellow The Remote Management Card is connected to the Network.

Indicates the Remote Management Card power.

1.Power on : LED is on.

2.Power off : LED is off.

3.Receiving/transmitting data packet : LED is blinking.

4.Reset finished : LED is blinking.

CAUTION!

Do not store batteries or battery-powered devices in hot places — elevated temperatures

can lead to capacity loss, leakage, or rupture.

Do not dispose of batteries in a fire. The battery may explode if improperly disposed.

Recycle the battery in accordance with local regulations.

When replacing the battery, the replacement should have the same rating as followers,

18650 Lithium-ion Rechargeable Battery, 14.8V/6500mAh.

Do not remove the cover, except to service the battery, to reduce the risk of electric shock.

To reduce the risk of electric shock, do not remove the cover. No user serviceable parts

inside including the battery. Please contact us or our dealer directly.

Do not disassemble, crush, puncture, or otherwise damage batteries. This can result in

leakage or rupture.

Do not open or mutilate the battery. Released material is harmful to the skin and eyes. It

maybe toxic.

Never block or insert any objects into the keyholes or other openings of the UPS.

To prevent the risk of fire or electric shock, install in a temperature and humidity controlled

indoor area, free of conductive contaminants. (Please see specifications for acceptable

temperature and humidity range).

This unit must be DIN rail. Do not use the unit unless it is mounted correctly.

The unit is for indoor use only. Please avoid direct sunlight exposure.

Runtimes based on testing fully-charged, new batteries at normal operating conditions.

Runtime curve is approximate and varies based on battery age, level of charge at test,

environment, and other variables.

As long as utility power is on, you may leave the UPS and connected equipment on while replacing

a new battery. (For service personnel reference only)

Indicator Color

DescriptionNumber

Condition

LIMITED WARRANTY

CyberPower warrants to you, the Initial Purchaser, that the Product will be free from defects in material and workmanship for three years from the date

Warranty. This Limited Warranty gives you specific rights, and you may have other rights, which vary from State to State or Province to Province.

Any Implied Warranty of Merchantability or for Fitness for a Particular Purpose, if applicable to the Product, is limited in duration to three years. This pr

Merchantability or of Fitness for a Particular Purpose that would not otherwise apply to the Product. NOTE: Some States and Provinces do not allow

so the above limitation may not apply to you.

To be covered you must still be the owner of the Product at the time of the failure that results in the claim made under this Limited Warranty. Your sole

Limited Warranty. This exclusion of other express warranties applies to written and oral express warranties. CyberPower excludes any liability for perso

indirect, special, incidental, or consequential damages, whether for damage to or loss of property, loss of profits, business interruption, information or d

is caused by negligence or other fault. NOTE: Some States or Provinces do not allow the exclusion or limitation of incidental or consequential damage

DO NOT USE FOR MEDICAL OR LIFE SUPPO EQUIPMENT OR OTHER HIGH RISK ACTIVITIES.RT

CyberPower does not sell the PRODUCT for use in high-risk activities. The PRODUCT is not designed or intended for use in hazardous environments

of nuclear facilities, aircraft navigation or communication systems, air traffic control, weapons systems, life support or medical applications or for use in

could lead directly to death, personal injury, or severe physical or property damage, or that would affect operation or safety of any medical or life suppo

CyberPower expressly disclaims any express or implied warranty of fitness for High Risk Activities. CyberPower does not authorize use of any PRODU

ANY SUCH USE IS IMPROPER AND IS MISUSE OF CHARTER PRODUCT. A A

The Limited Warranty is governed by the laws of the United States, without reference to conflict of law principles. The application of the United Nations

Sale of Goods is expressly excluded.

FCC NOTICE :

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are

harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

(2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the re

experienced radio/TV technician for help.

CAUTION: Shielded signal cables must be used with this device to ensure compliance with Class A FCC limits.