Instrukcja obsługi CRUX RVCCH-75WTC

CRUX kamera cofania RVCCH-75WTC

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla CRUX RVCCH-75WTC (3 stron) w kategorii kamera cofania. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/3
- Interface includes Audio / V eo I t to co ect an extra A/V source. id npu nn
- Spare Tire mo t reverse amera inc ed. un c lud
- tes MYGIG Screen for enabli Video features. Ac�va ng
- Su orts vehicles with ma pp nual transmission. See note below.
- Plug and Play co ec ons for ease of use. nn
NOTE: Does not supply +12V Reverse Trigger on vehicles with manual transmission. Camera power
must be tapped from the + V reverse light wire ins ad12 te . Video in Mo�on will not work for
manual transmissions.
- MyGig Naviga on Radio
CH- WT MODULE 75
CH- WT HARNESS 75
CH- S CAMERA 01
Rev.092617
1 / 3
1. Remove the outside mounted spare re.
2. Mount the metal bracket onto the spare re bolts and secure with the star washers. camera’s
3. Route the cable towards the radio and make the power and video connecons.
4. Remove the factory radio to gain access to the factory connectors.
5. Plug in the T-harness with WHITE and GRAY connectors. (See Wiring Diagram above)
6. Connect the 8-pin Molex connector from the T-harness with GRAY connectors to the CAN Interface.
7. Use the WHITE 12V Reverse Output wire to power the camera (see Wiring Diagram above). DO NOT
connect the red power wire, near the camera, insulate this red wire to avoid to the reverse light and
from shorng. the vehicle has a manual transmission, the camera power must be tapped to the If
+12V reverse light wire instead. In this case the WHITE 12V Reverse Output wire is not used and
should be insulated to avoid from shorng.
8. Plug in the YELLOW MALE RCA from the camera cable to the YELLOW FEMALE RCA of the T-Harness
with WHITE connectors.
9. Connect GREEN wire to +12V for non permanent Video in Moon feature. a
10. Set the proper DIP Switch sengs on the CAN Interface. (See Chart above)
11. Cut the thin white wire on the camera cable to enable the parking guide lines.
12. Test the camera before re-installing the radio.
Rev.0926 17
2 / 3
Please note that the WHITE 12V
Reverse Output wire does not
supply power on vehicles with
manual transmission and should
be insulated to avoid from
shorng. Connect the camera
power to the OE reverse light
+12V wire instead.
DIP SWITCH SETTING
DIP 1
VIM Disable
DIP 2
Rear-View Camera Enable
DIP 3
N/A
DIP 4
Opon for GREEN Wire
DIP 5
CAN Terminaon Radio Side
DIP 6
CAN Terminaon Car Side
The parking lines are there to assist you while reversing. To acvate the parking lines simply cut/disconnect the
WHITE loop wire located near the 4 pin camera connector.
What the Lines mean:
Green Line: CLEAR
Yellow Line: GETTING CLOSE
Red Line: WARNING - VERY CLOSE
VES will be your source for the AV Input.
To access the VES buon, press the RADIO/MEDIA buon on the le side of the radio. The VES buon is only
acve aer the interface is properly installed.
JEEP
2007 2017 WRANGLER
MyGig Radio
Rev.0926 17
3 / 3
GREEN
YELLOW
RED


Specyfikacje produktu

Marka: CRUX
Kategoria: kamera cofania
Model: RVCCH-75WTC

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z CRUX RVCCH-75WTC, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje kamera cofania CRUX

CRUX

CRUX RVCCH-75WTC Instrukcja

16 Września 2024
CRUX

CRUX CNS-03V Instrukcja

16 Września 2024
CRUX

CRUX CVW-07G Instrukcja

15 Września 2024
CRUX

CRUX RVCCH-75EC Instrukcja

15 Września 2024
CRUX

CRUX CNS-01N Instrukcja

14 Września 2024
CRUX

CRUX CLR-10 Instrukcja

13 Września 2024
CRUX

CRUX CGM-01S Instrukcja

12 Września 2024
CRUX

CRUX LVCB-07 Instrukcja

12 Września 2024
CRUX

CRUX CS-MB45 Instrukcja

12 Września 2024
CRUX

CRUX CBM-01T Instrukcja

12 Września 2024

Instrukcje kamera cofania

Najnowsze instrukcje dla kamera cofania