Instrukcja obsługi CRUX CGM-01S

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla CRUX CGM-01S (2 stron) w kategorii Achteruitrijcamera. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/2
CGM-01S
Tailgate Handle Camera for
CHEVROLET SILVERADO and GMC SIERRA 2014 - 2017
- Replaces the factory tailgate handle and adds a backup camera.
- 170 degree wide view angle for excellent visibility.
- Super CMOS technology provides a sharper picture day and night.
- Maintains the OEM look.
PRODUCT FEATURES:
PARTS INCLUDED:
R
INTERFACING SOLUTIONS
Sightline
CAMERAS
1. Tailgate handle camera
2. 26’ extension cable
INSTALLATION INSTRUCTIONS:
1. Start by lowering the tailgate of the truck. Remove the screws that secure the tailgate cover.
2. Aer removing the tailgate cover you will have access to the backside of the factory tailgate handle. Using a
10mm socket, remove the (2) nuts holding the tailgate handle in place. Undo the tailgate latch rods. Li up on
the latch to release the (2) tailgate handle studs and remove the tailgate handle.
3. On the lock cylinder, remove the metal clip that holds the locking mechanism in place. Re-Install the lock cylinder
onto the new tailgate handle.
4. Re-assemble the new tailgate handle into the tailgate in reverse order. Do not put back the tailgate cover unl
aer tesng the camera. Decide whether the parking guide lines will be used. See next page for instrucons on
how to turn ON/OFF the parking guide lines.
5. Route the Video and Power cables from the tailgate to the boom of the truck. Route the the camera power
wires to the tail light assembly. Tap the RED wire to the +12V reverse light wire and the BLACK wire to ground.
Connue to route the video cable towards the radio and plug in the video RCA to the back of the aermarket
radio of back up camera interface reverse camera input.
6. Test the camera for funconality then put back the tailgate cover.
Tip: There should be an opening (covered by a rubber boot) between the cabin and the bed of the truck where you
can insert the cables into the cabin area. You can run the video cable under the door sill cover.
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.020419
1
CGM-01S
R
INTERFACING SOLUTIONS
Sightline
CAMERAS
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.020419
VEHICLE APPLICATIONS:
2014 - 2017 Silverado
CHEVROLET
2 of 2
20 Ft. Coax Cable
RED wire (B)*
Ground (Black wire)
RED wire (A)*
To Aftermarket Radio
Backup Camera Input
OR
Reverse Camera Interface
Backup Camera Input
WHITE Wire
Parking Guideline
WIRING DIAGRAM:
2014 - 2017 Sierra
GMC
*NOTE: To power the camera, use RED Wire A or B. If tapping power from the radio or RVC Interface, make sure to
insulate RED Wire A to avoid it from shorng. If you will be tapping power from the reverse light +12V, insulate RED
Wire B to avoid it from shorng. With either connecon the Black GROUND wire needs to be connected to a solid chassis
ground. For vehicles with manual transmission, we recommend tapping +12V power from the reverse light.
WHITE Wire: Connect to show parking guide line. Disconnect to remove. Insulate with tape to avoid from shorng.
Note: Cycle the camera power aer connecng or disconnecng the control wire.
Tailgate Handle Camera for
CHEVROLET SILVERADO and GMC SIERRA 2014 - 2017

Specyfikacje produktu

Marka: CRUX
Kategoria: Achteruitrijcamera
Model: CGM-01S

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z CRUX CGM-01S, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Achteruitrijcamera CRUX

CRUX

CRUX CNS-01N Instrukcja

14 Września 2024
CRUX

CRUX CGM-01S Instrukcja

12 Września 2024
CRUX

CRUX LVCB-07 Instrukcja

12 Września 2024
CRUX

CRUX CVL-02 Instrukcja

11 Września 2024
CRUX

CRUX CS-BMW6 Instrukcja

9 Września 2024
CRUX

CRUX CCH-01W Instrukcja

9 Września 2024
CRUX

CRUX RVCFD-79 Instrukcja

8 Września 2024
CRUX

CRUX RVCTY-71 Instrukcja

8 Września 2024
CRUX

CRUX RVCTY-71D Instrukcja

7 Września 2024
CRUX

CRUX CMB-18S Instrukcja

7 Września 2024

Instrukcje Achteruitrijcamera

Najnowsze instrukcje dla Achteruitrijcamera

Marquant

Marquant MRD-7 Instrukcja

18 Września 2024
Pyle

Pyle PLCM7800 Instrukcja

6 Września 2024
Pyle

Pyle PLCMTR74 Instrukcja

1 Września 2024
Pyle

Pyle PLCM35 Instrukcja

30 Sierpnia 2024
Pyle

Pyle PLCMTR92.5 Instrukcja

29 Sierpnia 2024
Pyle

Pyle PLCM4560 Instrukcja

26 Sierpnia 2024
Pyle

Pyle PLCM4500 Instrukcja

25 Sierpnia 2024
Pyle

Pyle PLCMTRS77 Instrukcja

24 Sierpnia 2024