Instrukcja obsługi Claro Whisper AC

Claro Wentylator Whisper AC

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Claro Whisper AC (14 stron) w kategorii Wentylator. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/14
WHISPER AC
VER 0.1
Ceiling Fan Instruction Booklet
Thank you for purchasing your Claro Whisper AC Ceiling Fan. Please read all instructions carefully
before assembly and use.
IMPORTANT SAFEGUARDS
Read all instructions carefully, even if you feel you are quite familiar with this type of appliance. When
using electrical appliances, in order to reduce the risk of re, electric shock, and/or injury, these
basic safety precautions should always be followed:
1. All wiring must be done by a licenced electrician as on-site warranty may be voided if proof
cannot be provided. This ceiling fan MUST be installed by a Qualied Electrical Contractor in
accordance with the local regulations, and all local, state and national electrical codes. Any
alterations or additions to building wiring must be completed by a licensed electrical contractor, or
person authorised by legislation to work on the xed wiring of any electrical installation.
2. The fan must be connected to a 240V AC 50Hz power supply.
3. All electrical work must only be undertaken after disconnection of the power by removing fuses
or turning o the circuit breaker, to ensure all pole isolation of the electrical supply.
4. The fan must be earthed.
5. The fan must be installed so that the blades are at least 2.1 metres above the oor.
6. The ceiling fan weight is max. 9 kg. The structure that the ceiling fan is mounted to must be
capable of supporting a weight of at least 45 kg. The xing must be able to support the moving
weight of the fan and must not twist or work loose.
7. Make sure that the installation site will not allow the rotating fan blades to come into contact with
any object and that there is enough space from the blade tip to the wall or ceiling. Please note that
insucient clearance distances might cause wobbling and the bigger this clearance is the better the
airow from your fan will be.
8. This product can be installed in a position where it is covered or enclosed al fresco areas and
there is a minimum clearance of 1.50 m from the blade tip to all edges of the roof or positions where
could be exposed to water, moisture or other dangerous external elements.
9. DO NOT connect the fan motor to a dimmer switch. This may give an unsatisfactory performance
(motor hum) and cause damage to the motor and/or controller. Use ONLY the provided wall control.
10. This appliance is not intended for use by young children or inrm persons without supervision.
11. Young children should be supervised to ensure that they DO NOT play with the appliance.
12. It is NOT recommended that ceiling fans and gas appliances be operated in the same room at
the same time.
13. The fan must be turned o and stopped completely before reversing the fan direction. This will
prevent any damage to the motor of the fan or controller.
14. Do not insert anything into the fan blades whilst they are spinning. This will damage the blades
and upset the balance of the fan causing the unit to wobble.
15. After the fan is completely installed make sure that all base and fan blade xings are secured and
tightened to prevent any problems.
1
16. Because of the fan’s natural movement, some connections may loosen. Check the support
connections, brackets and blade attachments twice a year to make sure they remain secured. If any
are loose, tighten.
17. If unusual oscillating movement is observed, immediately stop using the ceiling fan and contact
the manufacturer, its service agent or suitably qualied persons.
18. The replacement of parts of the safety suspension system device shall be performed by the
manufacturer, its service agent or suitably qualied persons.
19. If it is necessary to replace the live or neutral brushes to ensure operation of the motor then
both brushes and the earth brush shall be replaced at the same time. The brushes shall only be
replaced by a suitably qualied person.
20. An all-pole disconnection incorporated in the xed wiring is to be provided, such as an all-pole
switch or a supply cord tted with a plug.
21. The light source in light kit is not replaceable; when the light source reaches its end of life the
whole light kit shall be replaced by manufacture, his service agent or a qualied person.
22. The max operating temperature for the fan is 40 degree °C. Keep the fan away from any heat
sources, like re place, heater and stove.
23. This product is not intended or recommended for, and is therefore not warranted for coastal use
IMPORTANT NOTE:
The important safeguards and instructions given in this manual are not meant to cover all
possible conditions and situations that may occur. It must be understood that common sense,
caution and care are factors which cannot be built into any product.
FAULT FINDER:
Always check the “Trouble Shooting Checklist” included in this booklet before seeking warranty
claim.
Mechanical noise may be noticed on installation. Allow at least 8 hours settling-in period.
Some fans may wobble more than others, even if they are identical. This does not necessarily
indicate a fault.
PREPARATION:
1. Unpack your ceiling fan carefully, then remove all parts and components, and lay on a cloth or soft
surface to avoid damage. DO NOT lay the motor housing on its side, the housing may get damaged.
2. Before commencing installation, check that all parts are included.
NB: You may need to remove all foam packaging material to ensure there are no missing parts.
2

Specyfikacje produktu

Marka: Claro
Kategoria: Wentylator
Model: Whisper AC

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Claro Whisper AC, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Wentylator Claro

Claro

Claro Whisper AC Instrukcja

14 Września 2024
Claro

Claro Whisper DC Instrukcja

14 Września 2024

Instrukcje Wentylator

Najnowsze instrukcje dla Wentylator

Windmill

Windmill FC07W3 Instrukcja

21 Grudnia 2024
Windmill

Windmill FC07W1 Instrukcja

21 Grudnia 2024
Windmill

Windmill FC07W2 Instrukcja

21 Grudnia 2024
Windmill

Windmill FC07W5 Instrukcja

21 Grudnia 2024
SVAN

SVAN SVP401600MOBA Instrukcja

21 Grudnia 2024
NewAir

NewAir NFN12AWH00 Instrukcja

20 Grudnia 2024
NewAir

NewAir AF-600 Instrukcja

20 Grudnia 2024
Livoo

Livoo DOM510 Instrukcja

20 Grudnia 2024
SVAN

SVAN SVP401600OBA Instrukcja

20 Grudnia 2024
Yamazen

Yamazen FCR-D408 Instrukcja

19 Grudnia 2024