Instrukcja obsługi Chief SSM152
Chief
akcesorium do projektora
SSM152
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chief SSM152 (1 stron) w kategorii akcesorium do projektora. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000222 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-152, SSM-152, SLB-152 and SLM-152 Interface Brackets
SSB-152, SSM-152, SLB-152 and SLM-152 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place interface bracket onto projector bottom and align mounting holes in bracket with threaded inserts in projector.
4. Using M8 x 20mm hex head screws and flat washers, secure interface bracket to projector and tighten all fasteners at this time.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (4) Screw, Hex Head Cap, Machine, M8 x 20mm
(6) 10-24 Thumb Nuts ** (4) Washer, Flat, M8
(1) All-Points Security Kit
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-152 SLM-152
Towards front of
projector
Towards front of
projector
(Note: SSM-style interface bracket connection
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(
Note: SSB-style
interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
Specyfikacje produktu
| Marka: | Chief |
| Kategoria: | akcesorium do projektora |
| Model: | SSM152 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Chief SSM152, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje akcesorium do projektora Chief
22 Września 2024
20 Września 2024
20 Września 2024
17 Września 2024
Instrukcje akcesorium do projektora
Najnowsze instrukcje dla akcesorium do projektora
7 Września 2024