Instrukcja obsługi CDA TV5CH
CDA
bateria łazienkowa
TV5CH
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla CDA TV5CH (2 stron) w kategorii bateria łazienkowa. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/2
5 Year warranty:
All CDA taps are covered by a 5 year parts guarantee. Labour & fitting costs are not included except under exceptional
circumstances. Decorative surface finishes and O-rings are guaranteed for ONE year from the date of purchase provided
that our advice concerning care has been observed. This is provided that the mixer has been used for normal domestic
purposes in the UK and that the care, installation and maintenance instructions have been observed. The warranty
extends to the original purchaser only. You should retain a copy of your dated invoice as proof of purchase to validate
any claims under this guarantee.
Care Instructions for your Tap:
To maintain the appearance of this tap, ensure that it is regularly cleaned only using a clean, soft damp cloth. A solution of
warm water and a mild liquid detergent may be used where necessary, and then the fitting rinsed thoroughly and wiped
dry. Any other cleaning action will invalidate your warranty.
If the tap has a diffuser it should be cleaned periodically. Abrasive cleaners, scouring cleaners and acidic cleaners must not
be used under any circumstances. Avoid contact with all solvents (including chlorinated solvents, ketones or acetones as
these may result in surface deterioration or etching). Also avoid contact with any harsh household chemicals such as oven
cleaners, drain cleaners, rust removers, paint strippers and toilet bowl cleaners, bar keepers friend or Brasso.
Important Technical Data:
*If these temperatures or pressures are exceeded, even for short periods, damage can result.
CDA taps are either WRAS approved or manufactured in accordance with recognised European standards. Please ensure that
your tap is fitted in accordance with Local Water Byelaws.
These installation guidelines have been prepared for your direction and you must exercise due care at all times. We do not
accept responsibility for problems that may occur through improper installation. Whilst assembling the tap take care not to
accidentally loosen any screwed assemblies.
TV5CH Contemporary side single
lever tap
Minimum operating pressure 0.5 bar Maximum hot water temperature 90 °C*
Maximum operating pressure 12 bar*
Installation Preparation:
Before installing a new tap it is essential that you thoroughly flush through the supply pipes in order to remove any
remaining solder, swarf or impurities from your system. Failure to carry out this simple procedure could cause problems
or damage to the internal components of the tap.
We strongly recommend installing particle filter strainers and isolation valves to both the hot and cold feed pipes in an
accessible position. This will help to prevent premature failure of the valves and ease any future maintenance.
All parts should be removed from their packaging and inspected for any transport damage prior to installation.
Turn off and drain the water supply to the sink, unless there are isolation valves fitted.
This tap requires a 35mmø tap hole. If replacing an existing tap, remove the tap and clean the end of the feed pipes using
wire wool the tap hole area should be free from dirt and sealant. Loosely position the tap and tail pipes to check if any
alteration to the existing pipework is required, if this is the case do this now.
Installation:
After installation:
Once you have visually checked the new fittings and connections, turn the water
supply back on and check all fittings carefully for leaks. Then turn the tap back on
and check there are no leaks from the body or valve area.
Clean the tap to remove any marks created during installation as instructed then
replace the bag that has been provided to protect the tap until it is ready for use.
TV5CH Contemporary side single
lever tap
KEY DESCRIPTION QUANTITY
A Tap body 1
B Upper sink/worktop seal 1
C Horseshoe washer 1
D Horseshoe washer 1
E Studded rod 1
F Fixing nut 1
G Inlet pipe (offset) 1
H Inlet pipe 1
Specyfikacje produktu
| Marka: | CDA |
| Kategoria: | bateria łazienkowa |
| Model: | TV5CH |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z CDA TV5CH, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje bateria łazienkowa CDA
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
Instrukcje bateria łazienkowa
- bateria łazienkowa Ikea
- bateria łazienkowa Teka
- bateria łazienkowa Nodor
- bateria łazienkowa Grohe
- bateria łazienkowa Delta
- bateria łazienkowa Sussex
- bateria łazienkowa Miomare
- bateria łazienkowa Omnires
- bateria łazienkowa Billi
Najnowsze instrukcje dla bateria łazienkowa
24 Września 2024
24 Września 2024
24 Września 2024
24 Września 2024
21 Września 2024
21 Września 2024
21 Września 2024
21 Września 2024
21 Września 2024
21 Września 2024