Instrukcja obsługi Buchla & TipTop Audio Model 242t


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Buchla & TipTop Audio Model 242t (1 stron) w kategorii Nie skategoryzowane. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/1
PROGRAMMABLE PULSER - MODEL 242t
Pulses 4 x 12 matrix can be programmed using the .
The “n row selects the number of consecutive stages for rows A,
B and C. Rows A, B and C can independently programmed using
the two encoder knobs.
Eurorack 200 series
on/off
s si l starttop ngle pu se
PROGRAMMABLE PULSER MODEL 242
.002 OFF
10
PERIOD
INP RIXUTS TER MA TAL ALL OUT
A
B
C
stop
start
period
1 2 3 4 5 6 7 8 9 10 11 12
C
B
A
n
CLK
IN
RST
IN
The , lower left knob scrolls through the vertical rows the lower
right knob horizontal rows on/o buttonscrolls through the . The
activates or clears the chosen pulse point and a long press clears
the matrix.
Above the matrix are manual , and buttons. stop single pulse start
The “period” section controls the rate/speed of the internal clock
which drives the pulse matrix.
Incoming CV to the left hand attenuverter knob can increase or
decrease the rate selected by the right hand oset knob.
The oset rate goes from audio rate speed (.002) to 10 seconds (or
much longer) per stage.
The 242t can be externally clocked using the red jack. External pulses can also reset the end stage using the red “clk in” “rst in jack.
ALL OUT sends out a continuous pulse train no matter what is programmed in the matrix. It is a direct output of the pulser.
“MATRIX” sends out individual pulse patterns as programmed in the matrix.
ALTER” these two jacks send out alternating pulses—great for ping ponging.
The gray jack sends out a continuous ramp wave generated by the pulser,
great to send to open a 292t.
“INPUTS” These top two jacks can receive an external pulse to
either or the internal clock. start stop
Notes:
When the external clock (Clock In) is active, the “ramp” and "all out“
outputs remain controlled by the internal clock, as defined in the Period
section.
At the back of the module, a jumper sets the pulse length: "Short" uses the
pulser’s brief internal pulse width or the CLK input pulse width, while
"Long" fixes it to 1 millisecond. The factory default is "Long," recommended
for compatibility with most Eurorack modules.
Size: 16HP - Depth: 45mm - Power: +12V 130mA / -12V 19mA


Specyfikacje produktu

Marka: Buchla & TipTop Audio
Kategoria: Nie skategoryzowane
Model: Model 242t

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Buchla & TipTop Audio Model 242t, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Nie skategoryzowane Buchla & TipTop Audio

Instrukcje Nie skategoryzowane

Najnowsze instrukcje dla Nie skategoryzowane