Instrukcja obsługi Brula D plus - tief - deep
Brula
Stwardnieć
D plus - tief - deep
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Brula D plus - tief - deep (19 stron) w kategorii Stwardnieć. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/19
2
General
Introduction
You have opted for a BRULA basic stove firebox. We would like to congratulate you
on your choice and thank you for showing confidence in our product.
With this product you are getting premium quality basic stove technology for a
healthy radiant heat and stylish heating.
We hope you enjoy using our "fiery" products.
These assembly and operating instructions serve to familiarise you with the
assembly and correct handling of this fireplace in order to ensure smooth operation.
Please take the time to read these assembly and operating instructions carefully.
Our warranty and guarantee only apply if all points for the correct assembly and
operation of the fireplace are observed as described below.
Keep the assembly and installation instructions in a safe place so you can refer to
how to operate the fireplace correctly time and time again (e.g., at the start of a new
heating period).
The basic stove principle
The basic stove (also known as a storage stove) is synonymous with long-lasting
and healthy heating. And these are precisely the advantages offered by this stove
system. Compared to a hot air system which uses the principle of convection and
essentially only heats up the air, a basic stove emits warmth into the room slowly
and evenly in the form of healthy radiant heat, something which is valued in
particular by allergy sufferers.
And this is how it works:
Once the fire has been lit in the combustion chamber, the heating gases are drawn
through a draught system made of firebricks which absorb and store the heat. The
draught system is designed so that the heating gases must firstly pass through the
entire stove before escaping through the chimney. This means that the generated
heat is emitted by the stove over a long period of time. The radiant heat created in
this way does not heat up the air but rather the objects which it encounters, just like
a ray of sun.
BRULA GmbH
Weidacher Str. 17
87471 Durach/Allgäu, Germany
Tel. +49(0)831-564070
Fax +49(0)831-56407-50
info@brula.de
3
Operating instructions
General requirements
Please note that national and local provisions must be satisfied when installing the
BRULA basic stove firebox.
Please consult your competent district master chimney sweep about this prior to
installation. He will advise you on the suitable chimney as well as all other
requirements which are of relevance for the setup and commissioning of your basic
stove. A sufficient combustion air supply must be ensured in particular, especially
with a very well sealed building shell, flat ventilation systems etc. in order to
guarantee smooth operation.
Your chimney sweep will be able to help here too. He will also check that the
fireplace has been connected properly. The basic stove firebox described here is
tested according to EN 15250 BlmschV (level 2) (German Federal Immission
Protection Ordinance) and may be attached to a chimney with multiple connections
provided that the chimney's technical conditions allow this. If the basic stove is
attached to a chimney with multiple connections, the heating door used must be self-
closing. This ensures that the door closes automatically after adding more fuel and
thus the supply pressure of the chimney is not affected.
Installation site / fire protection regulations
When setting up the basic stove, the valid fire protection regulations of the German
Fire Code Ordinance (FeuVo) and the specifications of the stove and air heating
construction trade (TROL) with respect to fire and heat protection must be observed.
The specified minimum distances to combustible objects and walls must be
maintained and the flooring must also be protected.
Note:
Only set up the fireplace on surfaces with a sufficient load bearing capacity. If the
load bearing capacity is not sufficient, suitable measures must be taken (e.g., plate
for load distribution) to remedy this.
Connection to the chimney
All connections from the stove to the chimney must be tight and firm. Always use a
wall lining to connect the connecting piece to the chimney.
Specyfikacje produktu
| Marka: | Brula |
| Kategoria: | Stwardnieć |
| Model: | D plus - tief - deep |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Brula D plus - tief - deep, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Stwardnieć Brula
15 Września 2024
13 Września 2024
12 Września 2024
9 Sierpnia 2024
Instrukcje Stwardnieć
- Stwardnieć Perel
- Stwardnieć Qlima
- Stwardnieć Landmann
- Stwardnieć Dimplex
- Stwardnieć Napoleon
- Stwardnieć Blumfeldt
- Stwardnieć Edilkamin
- Stwardnieć Altech
- Stwardnieć Toolland
- Stwardnieć Well Straler
- Stwardnieć Barbecook
- Stwardnieć Dovre
- Stwardnieć Faber
- Stwardnieć Manor House
- Stwardnieć Hwam
- Stwardnieć Bellfires
- Stwardnieć Xaralyn
- Stwardnieć Livin Flame
- Stwardnieć Spartherm
- Stwardnieć Stuv
- Stwardnieć Haas-Sohn
- Stwardnieć Austroflamm
- Stwardnieć Thermorossi
- Stwardnieć Saey
- Stwardnieć M-design
- Stwardnieć Element4
- Stwardnieć Norsk Kleber
- Stwardnieć Wanders
- Stwardnieć Blackline
- Stwardnieć Kago
- Stwardnieć Italiana Camini
- Stwardnieć Olsberg
- Stwardnieć DRU
- Stwardnieć Hergom
- Stwardnieć Ruby Fires
- Stwardnieć Global Fires
- Stwardnieć Mondena
- Stwardnieć Godin
- Stwardnieć Franco Belge
- Stwardnieć Kalfire
- Stwardnieć Barbas
- Stwardnieć Icon Fires
- Stwardnieć Big Fire
- Stwardnieć Thermocet
- Stwardnieć Jydepejsen
Najnowsze instrukcje dla Stwardnieć
5 Października 2024
29 Września 2024
29 Września 2024
29 Września 2024
29 Września 2024
29 Września 2024
29 Września 2024
29 Września 2024
29 Września 2024
28 Września 2024