Instrukcja obsługi Brondi FX-400 Twin


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Brondi FX-400 Twin (11 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/11
FX-4 Twin
PMR446
Private mobile radio
Instruction manual – English
1. LCD Screen
Channel Number. Changes from 1 to
8 as selected by the user.
CTCSS Code. Changes from 1 to 38
as selected by the user.
Displays the Battery change level.
When the bars are reduced, the
battery needs recharging.
TX Displayed when transmitting a signal.
RX Displayed when receiving a signal.
DCM Displayed when the Dual Watch function is turned ON.
VOX Displayed when the VOX feature is enabled.
SC Displays when the PMR is scanning all channels.
Displayed when the Key Lock feature is activated.
Displays the current Speaker volume level.
Displays when the call signal is ON.
Displays when the vibrator function is activated.
Antenna
LCD Screen
- Displays the
current channel
selection and other
radio s
y
mbols.
PTT (PUSH to
TALK) button
Press and hold to
transmit.
CALL button
-Press to send
ringing tone to
other PMR units.
MENU Button
-Press to change
to switch between
modes.
S
p
eake
r
PWR(POWER)
ButtonPress
and hold to turn
the unit ON or
OFF.
MIC
(
Micro
p
hone
)
UP/DOWN
Buttons –
Press to change
channels, volume,
and to select
Ear/Mic/Charger
jack
2. Installation
2.1 Removing the Belt Clip
a. Pull the Belt Clip latch forward
(away from the FX-400)
b. While pulling the Belt Clip
latch, push up the Belt Clip as
shown in Figure1.
2.2 Installing the Belt Clip
a. Slide the Belt Clip into the
slot as shown in Figure2.
b. A “click” indicates the Belt
Clip is locked into position.
2.3 Installing the Batteries
Caution: Observe the proper battery polarity orientation when
installing batteries. Incorrect positioning can damage both the
batteries and the unit.
a. Pull up the battery cover latch, Lift up Battery Compartment Cover.
b. Install the rechargeable batteries by following the orientation as
shown in Figure 3 (the arrow is showing and pointing upward.)
c. Replace the Battery Compartment Cover. See Figure 4.
Important
Read these Safety Warnings before you charge the batteries.
When placing the FX-400 in the charger, use only the rechargeable
batteries supplied with the FX-400.
Don’t try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in
place when you are charging the batteries.
Dispose of used batteries safely and in a way that will not harm
the environment- never try to burn them or put them anywhere, they
could get burnt or punctured.
Don’t leave dead batteries in your FX-400 units.
They might leak if you do.
2.4 Charging the batteries using direct charger
a. Lift up the Mic/Ear/Charger cover, insert the round connector at
the side of the unit.
b. Plug in the mains adaptor into a 240V AC, 50Hz main socket with
the switch on the socket set to OFF.
c. Switch ON the main socket.
d. It takes about 10 hours to fully recharge the batteries if they are
completely run down. New batteries take up to 14 hours to fully
charge.
Belt Cli
p
latch
Fi
g
ure 1 Fi
g
ure 2
Fi
g
ure 3 Fi
g
ure 4


Specyfikacje produktu

Marka: Brondi
Kategoria: Niesklasyfikowane
Model: FX-400 Twin

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Brondi FX-400 Twin, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane Brondi

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024