Instrukcja obsługi Broan E6430SS

Broan Okap wyciągowy E6430SS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Broan E6430SS (48 stron) w kategorii Okap wyciągowy. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/48

E64000 SERIES

INTENDED FOR DOMESTIC COOKING ONLY

INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.

HOMEOWNER: USE AND CARE INFORMATION ON PAGES 13 AND 14.

Broan-NuTone LLC; Hartford, Wisconsin www.broan.com 800-558-1711

Broan-NuTone Canada; Mississauga, Ontario www.broan.ca 877-896-1119

SV08341 rev. D

HB0072

INSTALLATION INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

WARNING WARNING

- 2 -

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK OR INJURY TO PERSONS, OBSERVE THE

FOLLOWING:

1. Use this unit only in the manner intended by the

manufacturer. If you have questions, contact the

manufacturer at the address or telephone number

listed in the warranty.

2. Before servicing or cleaning unit, switch power

off at service panel and lock service disconnecting

means to prevent power from being switched on

accidentally. When the service disconnecting means

cannot be locked, securely fasten a prominent

warning device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be

done by qualified personnel in accordance with all

applicable codes and standards, including fire-rated

construction codes and standards.

4. Sufficient air is needed for proper combustion and

exhausting of gases through the flue (chimney) of fuel

burning equipment to prevent backdrafting. Follow the

heating equipment manufacturer’s guidelines and

safety standards such as those published by the

National Fire Protection Association (NFPA), and the

American Society for Heating, Refrigeration and

Air Conditioning Engineers (ASHRAE), and the local

code authorities.

5. When cutting or drilling into wall or ceiling, do not

damage electrical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. Do not use this unit with any additional solid-state

speed control device.

8. To reduce the risk of fire, use only steel ductwork.

9. This unit must be grounded.

10.

When applicable local regulations comprise more

restrictive installation and/or certification requirements,

the aforementioned requirements prevail on those of

this document and the installer agrees to conform

to these at his own expenses.

TO REDUCE THE RISK OF A RANGE TOP

GREASE FIRE:

a) Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that

may ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or

when flambeing food (i.e.: Crêpes Suzette, Cherries

Jubilee, Peppercorn Beef Flambé).

c) Clean ventilating fans frequently. Grease should not

be allowed to accumulate on fan or filters.

d) Use proper pan size. Always use cookware appropriate

for the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS

IN THE EVENT OF A RANGE TOP GREASE FIRE,

OBSERVE THE FOLLOWING*:

1. SMOTHER FLAMES with a close-fitting lid, cookie

sheet or metal tray, then turn off the burner. BE

CAREFUL TO PREVENT BURNS. IF THE FLAMES

DO NOT GO OUT IMMEDIATELY, EVACUATE AND

CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN – You may be

burned.

3. DO NOT USE WATER, including wet dishcloths or

towels – This could cause a violent steam explosion.

4. Use an extinguisher ONLY if:

A. You own a Class ABC extinguisher and you know

how to operate it.

B. The fire is small and contained in the area where

it started.

C. The fire department has been called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

CAUTION

1. For indoor use only.

2. For general ventilating use only. Do not use to exhaust

hazardous or explosive materials and vapors.

3. To avoid motor bearing damage and noisy and/or

unbalanced impellers, keep drywall spray, construction

dust, etc. off power unit.

4. Your hood motor has a thermal overload which will

automatically shut off the motor if it becomes overheated.

The motor will restart when it will be cooled down. If

the motor continues to shut off and restart, have the

hood serviced.

5. For best capture of cooking impurities, the bottom of

the hood should be at a minimum of 24’’ and at a

maximum of 30” above the cooking surface.

6. Two installers are recommended because of the large

size and weight of this hood.

7. To reduce the risk of fire and to properly exhaust air,

be sure to duct air outside – Do not exhaust air into

spaces within walls or ceiling or into attics, crawl

space or garage.

8. This product is equipped with a thermostat which may

start blower automatically. To reduce the risk of injury

and to prevent power from being switched on

accidentally, switch power off at service panel and

lock or tag service panel.

9. Because of the high exhausting capacity of this hood,

you should make sure enough air is entering the house to

replace exhausted air.

Use an appropriate make-up

air device or open a window close to or in the kitchen.

10. To reduce the risk of fire and electric shock, the

Broan Elite E64E Series hood must be installed

with

one Broan exterior blower model 331H, 332H,

335 or 336; or one Broan in-line blower models

HLB3, HLB6, HLB9, HLB11.

Other blowers cannot

be substituted. (Exterior or in-line blowers are sold

separately.)

11. Please read specification label on product for further

information and requirements.

HL0097

- 3 -

RMP SERIES BACKSPLASH

(STAINLESS TEEL WALL COVERINGS

WITH WARMING SHELVES.

OPTIONAL.)

8” ROUND

ADJUSTABLE ELBOW

MODEL 412

TRANSITION

(3¼” 10” X TO 7”)

ADAPTER /DAMPER

3¼’’ 10’’X

(SUPPLIED WITH

SINGLE BLOWER HOOD)

ADAPTER 4½” 18½”X

(SUPPLIED WITH

DOUBLE BLOWER HOOD)

STANDARD

DUCT

(3¼” 10”)X

DOUBLE LOWERB (1200 CFM)

48” ONLY

E64000 SERIES HOOD

- E64000 SERIES RANGE HOOD SYSTEM -

INTERNAL BLOWERS

MODEL 647

(7” ROUND

WALL C )AP MODEL 634

OR 644

(ROOF C )AP

MODEL 643

(8” ROUND

WALL C )AP

8” ROUND

STANDARD

DUCT

MODEL 407

(7” ROUND -

2 FT. SECTIONS)

MODEL 413

TRANSITION

(3¼” 10” X TO 8”)

SINGLE CFMBLOWER (600 )

RECIRCULATION KIT

ANKE60 SERIES

MODEL 415

7” ROUND

ADJUSTABLE ELBOW

MODEL 437

(HIGH CAPACITY ROOF C )AP

MODEL 441

(10” ROUND

WALL C )AP

MODEL 427

(4½” 18½” X

TO 10” ROUND,

6” HIGH - LATERAL

MODEL 423

(4½” 18½” X

TO 10” ROUND -

VERTICAL

MODEL 424

(4½” 18½” X

TO 10” ROUND - HORIZ.

FRONT/REAR

MODEL 454

(4½” 18½” X

TO 10” ROUND -

HORIZ. /RIGHT

MODEL 453

(4½” 18½” X

TO 10” ROUND -

HORIZ. /LEFT

MODEL 410

(10” ROUND UCTD —2 FT. SECTIONS)

MODEL 418

(10” ROUND ADJUSTABLE ELBOW)

MODEL 421

(10” ROUND ERTICALV

I - DN LINE AMPER MODEL 639

(3¼” 10”X

WALL C )AP

Specyfikacje produktu

Marka:	Broan
Kategoria:	Okap wyciągowy
Model:	E6430SS

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Broan E6430SS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Okap wyciągowy Broan

Broan Elite RMIP45 Instrukcja

4 Października 2024

Broan Elite 619004 Instrukcja

4 Października 2024

Broan BWS1304SS Instrukcja

4 Października 2024

Broan EWS1306BLS Instrukcja

4 Października 2024

Broan BWP1304SS Instrukcja

4 Października 2024

Broan PM250 Instrukcja

4 Października 2024

Broan Elite 614804EX Instrukcja

4 Października 2024

Broan BWP1364SS Instrukcja

4 Października 2024

Broan BC4130SS Instrukcja

4 Października 2024

Broan BBN3306SSC Instrukcja

4 Października 2024

Instrukcje Okap wyciągowy

Najnowsze instrukcje dla Okap wyciągowy

Pelgrim ISW990 Instrukcja

15 Października 2024

PKM 6080X Instrukcja

15 Października 2024

M-System MSPK 761 IX Instrukcja

15 Października 2024

Pelgrim ISWA991RVS Instrukcja

15 Października 2024

Pelgrim ISW751RVS Instrukcja

15 Października 2024

Pelgrim ISW771RVS Instrukcja

15 Października 2024

Amana WVW53UC6HV Instrukcja

15 Października 2024

Haier HPH60IMB2 Instrukcja

15 Października 2024

Haier HC60BMB2 Instrukcja

15 Października 2024

Haier HPH90IMB2 Instrukcja

15 Października 2024