Instrukcja obsługi Boss Dual Cube Bass LX
Boss
Wzmacniacz do gitary basowej
Dual Cube Bass LX
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Boss Dual Cube Bass LX (12 stron) w kategorii Wzmacniacz do gitary basowej. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/12
Owner’s Manual
Bass Amplier
Before using this unit, carefully read “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (leaet “USING THE UNIT SAFELY” and Owner’s Manual (p. 12)). After reading, keep
the document(s) where it will be available for immediate reference.
© 2022 Roland Corporation
2
Panel Descriptions
1 INPUT jack
Connect your bass guitar here.
2 [COMP/DRIVE] button
Sets the comp and distortion eects.
If this is “OFF”, these eects are not applied.
[DRIVE] button
To use the distortion eects, press the [DRIVE] button to make it
light up.
3 [AMP TYPE] knob
Selects the amp type.
Type Explanation
SUPER FLAT An amp with at tonal characteristics.
FLAT An amp with a classic bass sound.
VINTAGE An amp with a fat but sweet vintage sound.
MODERN An amp with a tight low end and a crisp high end.
ROCK An amp with a characteristic overdrive sound.
4 [MEMORY] button
Use the memory feature to store three dierent sets of knob
congurations for each amp type (p. 6).
5 [GAIN] knob
Adjusts the gain (amount of distortion).
6 [VOLUME] knob
Adjusts the volume before equalization and eects are applied.
7 EQUALIZER
[BASS] knob
Adjusts the sound level of the low-frequency range.
[MIDDLE] knob
Adjusts the sound level of the middle-frequency range.
[TREBLE] knob
Adjusts the sound level of the high-frequency range.
8 [EFFECTS] knob
Use this knob to switch between eects such as chorus or anger,
depending on the knob’s position.
Type Explanation
OFF Eects are not applied.
CHORUS
Chorus is an eect that creates a beautiful tonal
spaciousness and depth by adding a slightly
modulated sound.
FLANGER Gives a twisting, anged character to the sound.
T-WAH You can produce a wah eect with the lter
changing in response to the bass level.
9 [DELAY/REVERB] knob
Use this knob to switch between eects such as delay or reverb,
depending on the knob’s position.
Type Explanation
OFF Eects are not applied.
DELAY Changes the delay time and eect.
REVERB Adjusts the volume of the reverb.
Top Panel
7 10
2
8 9
1 43 65 12 13 14 1511
3
Panel Descriptions
10 RHYTHM GUIDE
The rhythm guide built into this amp features drum and percussion
rhythm patterns that are useful when you’re practicing by yourself.
Set this to the pattern you like when you practice, or use it as a
metronome (p. 6).
[PATTERN] knob
Selects the genre of the rhythm pattern.
[START/STOP] button
Starts/stops the rhythm guide. When you start the rhythm guide,
the [START/STOP] button blinks in time with the tempo.
[TAP TEMPO] button
Sets the tempo for the rhythm guide. Press this button twice at
the tempo you desire to make the rhythm guide play back at that
tempo.
[VARIATION] button
Selects the rhythm pattern variation. There are three types of
rhythm variations available for each genre.
The [VARIATION] button color changes from green unlitÓredÓ
with each press, and the variation changes accordingly.
[VOLUME] knob
Adjusts the volume of the rhythm guide.
11 PHONES/REC OUT jack
Connect your headphones or headset mic here.
Adjust the headset mic volume with the [MIC VOL] knob.
* No sound is played through the unit’s speaker while the PHONES/
REC OUT jack is in use.
* You may hear feedback with some headset mics if you raise the
volume too much. Also keep in mind that feedback may occur
between the headset mic and the speakers connected to the LINE
OUT jacks.
* Turn down the [MIC VOL] knob when plugging or unplugging a
cable into the PHONES/REC OUT jack. Also, make sure that the plug
is inserted fully into the jack. If a plug is not fully inserted with the
volume turned up, an unpleasant loud noise may be heard.
* Pin arrangement for PHONES/REC OUT jack (stereo, CTIA)
L
R
GND
MIC
12 LOOPER indicator
You can use the looper by connecting a footswitch (FS-5U, FS-6,
FS-7; sold separately) to the FOOT SW jack (p. 7).
13 [MASTER] knob
Adjusts the output volume.
14 POWER indicator
This indicator lights when the unit is turned on.
* When operating on battery power, the unit’s POWER indicator
blinks if the batteries are nearly depleted. Replace the batteries as
soon as possible (p. 5).
15 [POWER] switch
Turns the power of this unit on/o (p. 5).
Specyfikacje produktu
| Marka: | Boss |
| Kategoria: | Wzmacniacz do gitary basowej |
| Model: | Dual Cube Bass LX |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Boss Dual Cube Bass LX, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Wzmacniacz do gitary basowej Boss
15 Grudnia 2024
15 Grudnia 2024
5 Października 2024
Instrukcje Wzmacniacz do gitary basowej
- Wzmacniacz do gitary basowej Roland
- Wzmacniacz do gitary basowej Peavey
- Wzmacniacz do gitary basowej Ampeg
Najnowsze instrukcje dla Wzmacniacz do gitary basowej
12 Stycznia 2025
22 Września 2024
9 Września 2024
9 Września 2024
24 Sierpnia 2024
24 Sierpnia 2024
23 Sierpnia 2024
23 Sierpnia 2024
18 Sierpnia 2024
6 Sierpnia 2024