Instrukcja obsługi Boss BCB-30X

Boss odbiornik BCB-30X

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Boss BCB-30X (1 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/1
English
Owner’s Manual
BCB-30X Pedal Board Before using this unit, carefully read “USING THE UNIT SAFELY” and “IMPORTANT NOTES.” After reading, keep the document(s)
where it will be available for immediate reference.
© 2020 Roland Corporation
Eect Unit Installation Examples
By cutting the included holding pad to match the shape of the products that you want to install, you can hide the cabling and create a clean layout.
Example 1 Example 2 Example 3
USING THE UNIT SAFELY
Used for instructions intended to alert the
user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic animals
or pets.
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
The symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In the
case of the symbol at left, it means that the power-cord
plug must be unplugged from the outlet.
The symbol alerts the user to important instructions or
warnings.The specific meaning of the symbol is
determined by the design contained within the triangle. In
the case of the symbol at left, it is used for general
cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never be
carried out (are forbidden). The specific thing that must
not be done is indicated by the design contained within
the circle. In the case of the symbol at left, it means that
the unit must never be disassembled.
About WARNING and CAUTION Notices About the Symbols
ALWAYS OBSERVE THE FOLLOWING
Do It Yourself 1 (Cutting the Holding Pad)
When installing stompboxes, you can save layout time by using the existing pre-cuts in the holding pad to
remove unneeded portions.
The cutouts at the left and right of the holding pad indicate the positions that are above the cable guides
(places to conceal long cables) when it is placed in the case. Use these cutouts when deciding where to
position your eect units, and cut the holding pad so that cables can be accommodated neatly when the
eect units are installed.
* If you use a knife to cut the holding pad, take care not to injure yourself.
* When cutting the cutouts, take care not to damage nearby equipment with the knife.
Holding pad
Cutouts
Cable guide
Do It Yourself 2 (Keeping the Cables Neat)
If the power supply parallel cable and long patch cables are aligned with the cable guide, the cables can be
managed neatly.
Cable guide
MEMO
To detach the lid, lift it to the position shown in the illustration, and then press in the direction of the arrow.
Making Connections
* To prevent malfunctions or speaker damage, be sure to minimize the volume of all devices and power them o before
you make connections.
* After you have made connections correctly, you must observe the following procedure when turning on the power
Malfunctions or speaker damage might occur if you fail to observe the correct order.
Main Specications
Dimensions 330 (W) x 307 (D) x 100 (H) mm
13 (W) x 12-1/8 (D) x 3-15/16 (H) inches
Inside dimensions 66 (H) mm
2-5/8 (H) inches
Weight 1.3 kg
2 lbs 14 oz
Accessories
4-pin parallel DC cable x 1
Pre-cut insert pad (thickness: 10 mm) x 1
Owner’s Manual
Option
(sold separately)
AC adaptor: PSA series
Pre-cut insert pad (thickness: 10 mm)
* This document explains the specications of the product at the time that the document was issued. For the latest
information, refer to the Roland website.
When turning the power on: Power-on the amp last.
When turning the power o: Power-o the amp rst.
Roland Corporation
2036-1 Nakagawa, Hosoe-cho, Kita-ku, Hamamatsu, Shizuoka 431-1304, JAPAN
Roland Corporation
ENA 23 Zone 1 nr. 1620 Klaus-Michael Kuehnelaan 13, 2440 Geel, BELGIUM
Importer:
Manufacturer:
For EU Countries
Roland Corporation
2036-1 Nakagawa, Hosoe-cho, Kita-ku, Hamamatsu, Shizuoka 431-1304, JAPAN
Roland Europe Group Limited
Hive 2, 1530 Arlington Business Park, Theale, Reading, Berkshire. RG7 4SA United Kingdom
Importer:
Manufacturer:
For the U.K.
For EU Countries
IMPORTANT NOTES
Placement
• Depending on the material and
temperature of the surface on which you
place the unit, its rubber feet may discolor
or mar the surface.
Maintenance
• Never use benzine, thinners, alcohol
or solvents of any kind, to avoid the
possibility of discoloration and/or
deformation.
Additional Precautions
• When disposing of the packing carton
or cushioning material in which this unit
was packed, you must observe the waste
disposal regulations that apply to your
locality.
• When opening/closing the lid, please be
careful not to get your ngers pinched
between the movable part and the
unit. In places where small children are
present, make sure that an adult provides
supervision and guidance.
Intellectual Property Right
• Roland, BOSS are either registered
trademarks or trademarks of Roland
Corporation in the United States and/or
other countries.
• Company names and product names
appearing in this document are registered
trademarks or trademarks of their
respective owners.
WARNING
Do not disassemble or modify by yourself
Do not carry out anything unless
you are instructed to do so in the
owner’s manual. Otherwise, you risk
causing malfunction.
Do not repair or replace parts by yourself
Be sure to contact your dealer, a
Roland service center, or an ocial
Roland dealer.
For a list of Roland service centers
and ocial Roland dealers, refer to the Roland
website.
Do not place in an unstable location
Otherwise, you risk injury as the
result of the unit toppling over or
dropping down.
WARNING
Do not use or store in the following types
of locations
• Subject to temperature extremes
(e.g., direct sunlight in an
enclosed vehicle, near a heating
duct, on top of heat-generating
equipment); or are
• Damp (e.g., baths, washrooms,
on wet oors); or are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and
shakiness; or are
• Placed in a poorly ventilated location.
Be cautious to protect children from injury
Always make sure that an adult is
on hand to provide supervision and
guidance when using the unit in
places where children are present,
or when a child will be using the unit.
WARNING
Do not drop or subject to strong impact
Otherwise, you risk causing damage
or malfunction.
CAUTION
Avoid climbing on top of the unit, or
placing heavy objects on it
Otherwise, you risk injury as the
result of the unit toppling over or
dropping down.
Take care so as not to get ngers pinched
When handling the following
moving parts, take care so as not
to get ngers, toes, etc., pinched.
Whenever a child uses the unit,
an adult should be on hand to provide
supervision and guidance.
• Lid
• If you use a knife to cut the holding pad,
take care not to injure yourself.
• When trimming the cutouts, take care that
the knife does not damage nearby devices.
For details on the BCB-30X, refer to the Boss website.
https://www.boss.info/global/
products/bcb-30x/
For BOSS cables, refer to the BOSS website (Accessories).
https://www.boss.info/global/
categories/accessories/boss_cables/
*5100074667-02*
1

Specyfikacje produktu

Marka: Boss
Kategoria: odbiornik
Model: BCB-30X

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Boss BCB-30X, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje odbiornik Boss

Boss

Boss DD-500 Instrukcja

12 Stycznia 2025
Boss

Boss PT3000 Instrukcja

11 Stycznia 2025
Boss

Boss Acoustic Singer Live LT Instrukcja

15 Grudnia 2024
Boss

Boss Acoustic Singer Live Instrukcja

15 Grudnia 2024
Boss

Boss WAZA-AIR BASS Instrukcja

15 Grudnia 2024
Boss

Boss Elite BE10ACP.WX Instrukcja

7 Października 2024
Boss

Boss Elite BE9ACP.XC Instrukcja

7 Października 2024
Boss

Boss Elite BE10ACP.XC Instrukcja

7 Października 2024
Boss

Boss AR1600.2 Instrukcja

7 Października 2024
Boss

Boss AR1500M Instrukcja

5 Października 2024

Instrukcje odbiornik

Najnowsze instrukcje dla odbiornik

Marantz

Marantz SR-8000 Instrukcja

15 Stycznia 2025
AKAI

AKAI AM-32 Instrukcja

15 Stycznia 2025
Peavey

Peavey CKd 608 Instrukcja

15 Stycznia 2025
OSD Audio

OSD Audio Nero HTX4150 Instrukcja

14 Stycznia 2025
S.M.S.L

S.M.S.L PA200 Instrukcja

14 Stycznia 2025
Pyle

Pyle PFMRA340BB.5 Instrukcja

13 Stycznia 2025
Wavtech

Wavtech link700.4plus Instrukcja

13 Stycznia 2025
Behringer

Behringer NU6000DSP Instrukcja

12 Stycznia 2025
Denon

Denon DRA-935R Instrukcja

12 Stycznia 2025
Kenwood

Kenwood KMM-BT508DAB Instrukcja

12 Stycznia 2025