Instrukcja obsługi Bogen NR100
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bogen NR100 (4 stron) w kategorii alarm. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/4
NR100
Night Ringer
Installation & Use Manual
© 2009 Bogen Communications, Inc. All rights reserved.
Specifications subject to change without notice.
54-5883-02B 0911
THE FOLLOWING INFORMATION IS REQUIRED BY PART 68 OF FCC RULES TO BE SUPPLIED TO THE
PURCHASER OF REGISTERED EQUIPMENT.
This equipment complies with part 68 of FCC rules. The FCC registration number and ringer equivalence num-
ber are printed on the front panel of this equipment. You must, upon request, provide this information to your tele-
phone company.
If this equipment causes harm to the telephone network, the telephone company may discontinue your service
temporarily. If possible, they will notify you in advance. If advance notice is not practical, you will be notified as
soon as possible. You will be notified of your right to file a complaint with the FCC.
The telephone company may ask that you disconnect this equipment from the network until the problem has
been corrected or until you are sure that the equipment is not malfunctioning.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could af-
fect the proper functioning of your equipment. If so, you will be notified in advance to give you an opportunity to
maintain uninterrupted telephone service.
Note that for all applications of this equipment, coin service lines and party lines may not be used.
This equipment is typically used as an adjunct device to other registered equipment (i.e.: PABX, 1A2 Key, or Elec-
tronic Key System). Such host equipment may be leased. If so, permission of the owner should be obtained prior
to the installation of this equipment.
If you experience trouble with this equipment, please contact the Service Department of Bogen Communica-
tions Inc. at 50 Spring Street, Ramsey, New Jersey 07446, telephone (201) 934-8500. Information will be pro-
vided on how to obtain service or repairs.
The Bogen Model NR100 produces an electronic ringing tone over the loudspeakers of
a paging/background music system. The device may be activated by a ring signal from a sin-
gle telephone, or from a contact closure supplied by a suitable telephone interface device.
The NR100 is generally connected to the background music input of a paging amplifier (and
the background music source connected to the NR100). This arrangement permits muting
of the background music source during the ring signal. On amplifiers with paging priority, the
night ringer tone has priority over background music and paging has priority over both.
The NR100 is ruggedly constructed to be maintenance-free. It operates from a 24-volt DC
source (Bogen Model PRS2403 power supply recommended) and includes flanges for wall-
mounted installation. Use suitable fasteners when mounting to a wall or backboard.
Unpacking:
The NR100 was carefully checked before leaving the factory. Inspect it and the shipping
container for damage. Report damage to the distributor who supplied the equipment. If the
unit was shipped to you, notify the transportation company and file a claim.
Installation:
For single-line connection, connect the unit as shown in Figure 1. Use Figure 2 for multi-line
connection. Note the following installation precautions:
1. Connect either the TEL RING or CONTACT RING terminals to the telephone system as
shown in Figures 1 or 2. Note: Do not use both types of ring inputs on the same device.
2. Connect the background music source to the BGM SOURCE A & B terminals. Connect the
shield from the BGM source to the same-letter (A or B) terminal as the shield for the
amplifier input to the AMP A & B terminals. (If the amplifier input is balanced, this precau-
tion is not necessary.)
Following installation, test ring the unit and set the TONE volume control to achieve an
acceptable level. (This control is screwdriver-adjustable.)
Connects to telephone line and activates the NR100 upon
detection of a telephone ring signal.
Activates the NR100 when shorted through a normally-open
dry contact (requires suitable multi-line interface).
Connects to 24V DC supply capable of supplying 25mA.
Bogen PRS2403 Power Supply is recommended. Connect
power supply only as shown in Figures 1 or 2. Do not ground
either of the power supply terminals. Be sure to observe
correct polarity.
Connects to background music source. This input is muted
upon activation of the NR100.
Output terminals to the paging system. These terminals are
connected to the MUSIC/AUX input.
TEL RING T&R
CONTACT
RING A&B
POWER SUPPLY
+24 & -24
BGM SOURCE
A&B
AMP INPUT
A&B
Terminal Connections
Fig. 1:
NR100
Single-Line
Connection
Fig. 2:
NR100
Multi-Line
Connection
Specyfikacje produktu
| Marka: | Bogen |
| Kategoria: | alarm |
| Model: | NR100 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Bogen NR100, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje alarm Bogen
18 Maja 2024
Instrukcje alarm
- alarm Auriol
- alarm Dahua Technology
- alarm Renkforce
- alarm Grothe
- alarm Hama
- alarm Smartwares
- alarm Finlux
Najnowsze instrukcje dla alarm
18 Września 2024
9 Lipca 2024
9 Lipca 2024
9 Lipca 2024
9 Lipca 2024
9 Lipca 2024
9 Lipca 2024
9 Lipca 2024
9 Lipca 2024
9 Lipca 2024