Instrukcja obsługi BeSafe iZi Modular X1 i-Size
BeSafe
fotelik samochodowy
iZi Modular X1 i-Size
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla BeSafe iZi Modular X1 i-Size (90 stron) w kategorii fotelik samochodowy. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/90
a
f
c
b
j
i
e
g
h
2
31
4
5
> 25 cm
d
click!
96
102
108
113
118
123
128
134
140
145
150
156
161
171
177
183
1
13
18
23
28
34
39
44
50
56
62
68
73
79
85
91
USER MANUAL
Rearfacing 61-105 cm
Forward facing 88-105 cm
Max. weight: 18 kg
Age approx. 6m - 4 yrs
UN regulation no. R129 i-Size
Rear & Forward facing
8 9
! Vital information
• The child seat MUST NOT be installed in a front passenger
seat WITH AN ACTIVATED AIRBAG.
• iZi Modular can only be installed on the iZi Modular
i-Size base.
• iZi Modular is approved rearfacing for children with a stature
height from 61 to 105 cm, with a maximum weight up to 18 kg and
forward facing for children with a stature height from 88 to 105 cm
with a maximum weight up to 18 kg.
• iZi Modular RF is approved rearfacing for children with a stature
height from 61 to 105 cm, with a max. weight up to 18 kg.
• Important: Do not use forward facing before the child is over
15 months.
• BeSafe recommends to use the seat for as long as possible in the
rearfacing position.
• The harness straps must always be locked when the child is in
the seat.
• The harness straps must be tightened without slack and
not twisted.
• The shoulder pads contain magnets. Magnets can influence
electronic equipment such as pacemakers.
• Protect any part of the child’s body which is exposed to the sun.
• Always dress your child in a thin layer of clothes to avoid direct
contact between harness belts and skin. Avoid puy clothes since
this prevents being able to tighten the belts fully.
• We recommend that this seat is used only for children who can sit
upright, usually not younger than 6 months.
• Remove the extra seat cushion when the child is over 2 years.
• Remove the extra side supports when the child is over 2 years
or earlier when the child does not fit between these side
supports anymore.
• When the child weighs over 18 kg or the shoulder height exceeds
above the highest position of the shoulder straps, the child must
change to a seat suitable for children with a weight above 18 kg.
• Replace the seat if it has been in a collision where the speed was
6
7
8 9
10
11
12
15 16
17 18
1
2
3
4
5
6
321
14
<2 yrs >2 yrs
SIP+
1
13
2 3
click!
click!
Thank you for choosing BeSafe iZi Modular (RF)
! It is important that you read this user manual BEFORE
installing your seat. Incorrect installation could endanger
your child.
10 11
• Adjustable head rest
• Shoulder pads (2x)
• Side support
• Shoulder straps (2x)
• Harness buckle
• Seat cushion
• Central adjuster
• Reclining handle
• Release handle head rest
• Front brace
1a
1b
1c
1d
1e
1f
1g
1h
1i
1j
Preparing to install
Installation of the seat on the i-Size base
1. Check if the ISOfix and floor support indicators on the base are
green. (2)
2. Make sure that the front brace is installed on the base. The
operation of the front brace is described in the user manual for the
base. (2)
3. Make sure that the seat is always in the release position when you
want to install the seat on the base or take the seat o the base. The
two yellow arrows on the seat and the base must be aligned. (3) Use
the reclining handle to adjust the recline position, see step 6.
4. Position the seat in the correct position on the base untill it clicks
with the base and the indicator at the front shows green. (3)
5. When the seat is positioned rearfacing on the back seat of the
vehicle, you should, if possible, push the front seat of the vehicle
backwards, so that it is in contact with the child seat (4). If it is not
possible to obtain contact with the child seat, push the back rest of
the front seat of the vehicle forward as far as possible.
6. The seat can be taken o and turned around by pulling the seat
release handle at the front of the base (5,6). Make sure that the
two yellow arrows on seat and seatbase are aligned; this is the only
position where you can take o the seat.
7. The seat should only be turned around to forward facing when the
child is minimum 88 cm and 15 months. BeSafe recommends to use
the seat rearfacing for as long as possible.
8. When the seat is positioned forward facing, the front brace has to be
in position 1. (7)
9. The seat cannot be turned around in the BeSafe iZi Modular RF. This
seat is only to be used rearfacing.
Positioning of the child
Removal of the seat of the i-Size base
1. Check that the shoulder strap slots are level with your child’s
shoulders. (12)
2. While pressing the button of the central adjuster, pull the shoulder
straps away from the seat with a flat hand. Make sure to pull the
straps evenly so that they stay at the same length. (13)
3. Open the harness buckle. (14)
4. The height of the shoulder straps and the head rest can be adjusted
by pulling the release handle upwards at the back of the head rest
and pulling the head rest up or down. (15)
5. Position the shoulder straps over the marking at the sides of the seat
to use the magnets to keep the harness open while you position the
child. (16)
1. The seat can be taken o by pulling the seat release handle at the
front of the base. Make sure that the two yellow arrows on seatbase
and seatbase are aligned; this is the only position where you can take
o the seat.
10. The seat can be reclined by pulling the reclining handle at the front
side of the seat. (8)
11. In a rearfacing position the seat should only be used in the 2 most
reclined positions. (9)
12. The leg room of the seat, in rearfacing position, can be made larger by
pulling the front brace box out from the base. The front brace box has
3 positions. To adjust the front brace position, the seat has to be taken
o and the base should be released from the ISOfix. (10)
13. The seat is delivered with removable SIP+ (side impact protection
+). This extra side impact protection should be used on the doorside
of the vehicle. To connect your SIP+ version, follow the instruction
drawings on the SIP+ included with your seat. The seat already oers
high level integrated side impact protection. This extra side impact
protection improves the protection in the side impact still further. (Not
on all models) (11)
14. Do not use the SIP+ on the seat when the space between seat and
door of the vehicle is too small, which might lead to a situation where
the seat is not positioned correctly on the vehicle seat.
Specyfikacje produktu
| Marka: | BeSafe |
| Kategoria: | fotelik samochodowy |
| Model: | iZi Modular X1 i-Size |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z BeSafe iZi Modular X1 i-Size, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje fotelik samochodowy BeSafe
3 Października 2024
3 Października 2024
3 Października 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
22 Września 2024
22 Września 2024
Instrukcje fotelik samochodowy
- fotelik samochodowy Kindercraft
- fotelik samochodowy Dometic
- fotelik samochodowy Maxi-Cosi
- fotelik samochodowy Lionelo
- fotelik samochodowy Axkid
- fotelik samochodowy Be Cool
- fotelik samochodowy Joie
- fotelik samochodowy Cybex
- fotelik samochodowy Chicco
- fotelik samochodowy Casualplay
- fotelik samochodowy Joolz
- fotelik samochodowy Stokke
- fotelik samochodowy Nuna
- fotelik samochodowy Foppapedretti
- fotelik samochodowy Recaro
- fotelik samochodowy Graco
- fotelik samochodowy Chipolino
- fotelik samochodowy Safety 1st
- fotelik samochodowy Hauck
- fotelik samochodowy Storchenmuhle
- fotelik samochodowy Peg Perego
- fotelik samochodowy Bugaboo
- fotelik samochodowy Baby Jogger
- fotelik samochodowy Kinderkraft
- fotelik samochodowy Jane
- fotelik samochodowy InfaSecure
- fotelik samochodowy Bebe Confort
- fotelik samochodowy Evenflo
- fotelik samochodowy Silver Cross
- fotelik samochodowy ABC Design
- fotelik samochodowy Britax
- fotelik samochodowy Lorelli
- fotelik samochodowy Kiddy
- fotelik samochodowy GB
- fotelik samochodowy Nania
- fotelik samochodowy Xomax
- fotelik samochodowy Inglesina
- fotelik samochodowy Fisher Price
- fotelik samochodowy Osann
- fotelik samochodowy Brevi
- fotelik samochodowy Baninni
- fotelik samochodowy Clek
- fotelik samochodowy Hema
- fotelik samochodowy Mountain Buggy
- fotelik samochodowy Britax-Romer
- fotelik samochodowy Concord
- fotelik samochodowy Phil And Teds
- fotelik samochodowy Bertoni
- fotelik samochodowy BabyGO
- fotelik samochodowy Xadventure
- fotelik samochodowy Uppababy
- fotelik samochodowy Giordani
- fotelik samochodowy Caretero
- fotelik samochodowy Romer
- fotelik samochodowy Cosatto
- fotelik samochodowy Migo
- fotelik samochodowy Bellelli
- fotelik samochodowy Burigotto
- fotelik samochodowy Ellermeyer
- fotelik samochodowy Gesslein
- fotelik samochodowy Renolux
- fotelik samochodowy Avova
- fotelik samochodowy Cangaroo
- fotelik samochodowy Klippan
- fotelik samochodowy Quax
- fotelik samochodowy Kikka Boo
- fotelik samochodowy Hipod
- fotelik samochodowy Walser
- fotelik samochodowy Kiwy
- fotelik samochodowy Dreambee
- fotelik samochodowy Hamron
- fotelik samochodowy Apramo
- fotelik samochodowy Mothers Choice
Najnowsze instrukcje dla fotelik samochodowy
13 Października 2024
11 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024