Instrukcja obsługi Bertazzoni PM36500X-A
Bertazzoni
Kołek
PM36500X-A
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bertazzoni PM36500X-A (24 stron) w kategorii Kołek. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/24
(GB) INSTRUCTIONS FOR THE INSTALLATION, MAINTENANCE
pag. 2 AND USE OF FIXED HOBS WITH GAS OR MIXED SUPPLY
DIMENSIONS: (890 mm)(W) x (520 mm)(D)
Models PM36500X Type ‘A’
Models PM365S0X Type ‘B’
(FR) (BE) INSTRUCTIONS POUR L'INSTALLATION, L'ENTRETIEN ET
page. 9 L'UTILISATION DES TABLES DE CUISSON ENCASTRABLES
GAZ ET MIXTES
DIMENSION: (890 mm)(W) x (520 mm)(D)
Modeles PM36500X Type ‘A’
Modeles PM365S0X Type ‘B’
(NL) INSTRUCTIES VOOR DE INSTALLATIE, ONDERHOUD
pag. 16 EN GEBRUIK VAN INGEBOUWDE GASKOOKPLATEN
DIMENSIES: (890 mm)(B) x (520 mm)(D)
Modellen PM36500X Type ‘A’
Modellen PM365S0X Type ‘B’
310519
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR’S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
OBSERVE ALL GOVERNING CODES AND ORDINANCES.
WARNING: If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
Do not store or use gasoline or other flammable vapors and liquid in the vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance.
- Do not touch any electrical switch.
- Do not use any phone in your building.
- Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier’s instructions.
- If you cannot reach your gas suppliers, call the fire department.
Installation and service must be performed by a qualified installer, service agency
or the gas supplier.
Read this instruction booklet before installing and using the appliance.
This appliance is marked according to the European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
This guideline is the frame of a European-wide validity of return and recycling on Waste
Electrical and Electronic Equipment.
The manufacturer will not be responsible for any damage to property or to persons caused by
incorrect installation or improper use of the appliance.
The manufacturer reserves the right to make changes to its products when considered necessary and useful,
without affecting the essential safety and operating characteristics.
This appliance has been designed for non-professional, domestic use only.
WARNING:
This appliance is not intended for use by person ( including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance buy a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
INFORMATION FOR THE INSTALLER
The installation, all regulations, changes and maintenance referred to in this part must only be
carried out by qualified staff.
A wrong installation can cause damage to persons, animals or things which the manufacturer cannot
be held responsible for.
The safety and automatic regulation devices on the appliances can only ever be changed by the
manufacturer or by the supplier which has been authorised to do so.
Inserting the hotplate
After having removed the various loose parts from the internal and external packing, make sure that the
hotplate in not damaged and is suitable for the specific gas usage. The gas type label is on the underside of
the hotplate base.
In case of doubt, do not use the appliance and contact skilled personnel.
Keep all the packing parts (polystyrene foam, cardboard, staples, etc.) away from children.
Consider the critical dimensions of the appliance, before making an opening in the top surface of the bench
top. (relative measurements as per Fig 1- 2).
Requirements
1. Overhead clearances (Minimum values)
The minimum overhead clearances shall be in accordance with the minimum values indicated in the table
n.1 and are shown and in the fig. 1- 2
Range hoods and exhaust fans shall be installed in accordance with the manufacturer’s instructions.
However, in no case shall the clearance between the top of the highest burner of the cooking appliance and
the range hood be less than 650mm.
Any other downward facing combustible surface less than 600mm above the top of the highest burner shall
be protected for the full width and depth of the cooking surface area.
However, in no case shall this clearance to any surface be less than 450mm.
Maximum depth for the overheads cabinet is 330mm
2. Side clearances (Minimum values)
The different side clearances shall be in accordance with the minimum values indicated in the table n.1 and
are shawn and in the fig. 1- 2
The cooking surface area is defined as that part of the appliance where cooking normally takes place and
does not include those parts of the appliance containing control knobs.
Table n.1
Hobs models
Type A
Type B
Hobs
models
Type A
Type B
Min. Clearances
(mm)
Min. Clearances
(mm)
L1
500
L10
870
L2
40
L11
915
L3
50
W
890
L4
457
D
520
L5
600
B1 (*)
40
L6
330
B2 (*)
152
L7
925
B3 (*)
40
L8
40
B4 (*)
152
L9
172
(*) Note:
-B1 is the min. clearance between the front edge of the appliance and the front edge of the cabinet.
-B2 and B4 are the min. clearance between the left/right side edge of the appliance and the side wall (if present).
-B3 is the min. clearance between the back edge of the appliance and the back wall.
Attaching the hotplate
To prevent liquids from leaking accidentally into the underlying storage space, the appliance is equipped with
a special gasket. To apply this gasket, carefully follow the instructions in Fig. 3. Lay out the protective sealing
Specyfikacje produktu
| Marka: | Bertazzoni |
| Kategoria: | Kołek |
| Model: | PM36500X-A |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Bertazzoni PM36500X-A, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Kołek Bertazzoni
18 Września 2024
Instrukcje Kołek
- Kołek Bauknecht
- Kołek Electrolux
- Kołek AEG
- Kołek Balay
- Kołek Beko
- Kołek Teka
- Kołek Etna
- Kołek Whirlpool
- Kołek Miele
- Kołek Baumatic
- Kołek Siemens
- Kołek Grundig
- Kołek Silverline
- Kołek Mesko
- Kołek Indesit
- Kołek Viking
- Kołek Kenwood
- Kołek Mestic
- Kołek PKM
- Kołek Melissa
- Kołek Thetford
- Kołek Zanussi
- Kołek Bourgini
- Kołek Koenic
- Kołek Exquisit
- Kołek Atag
- Kołek Novy
- Kołek Inventum
- Kołek BORA
- Kołek Esperanza
- Kołek Orion
- Kołek Respekta
- Kołek Rommelsbacher
- Kołek Gaggenau
- Kołek Elica
- Kołek Ignis
- Kołek Sogo
- Kołek Acec
- Kołek Progress
- Kołek Junker
- Kołek Friac
- Kołek Boretti
- Kołek M-System
- Kołek Primo
- Kołek Atlantic
- Kołek Efbe-schott
- Kołek Brixton
- Kołek Waves
- Kołek Gutmann
- Kołek Oranier
- Kołek Venga
- Kołek PowerTec Kitchen
- Kołek Bifinet
- Kołek Wigo
- Kołek Konig Electronic
- Kołek RoyaltyLine
- Kołek Prosolo
Najnowsze instrukcje dla Kołek
8 Października 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024