Instrukcja obsługi Bertazzoni MO30STANE

Bertazzoni Magnetostrykcja MO30STANE

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bertazzoni MO30STANE (40 stron) w kategorii Magnetostrykcja. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/40
1
MO30 STA NE
In the interest of user-safety the oven should be restored to its original condition and only parts identical to those specified should
be used.
WARNING TO SERVICE PERSONNEL: Microwave ovens contain circuitry capable of producing very high voltage and
current. Contact with the following parts may result in a severe, possibly fatal, electrical shock. (Inverter unit that includes
High Voltage Capacitor, High Voltage Power Transformer, High Voltage Rectifier and Heat sink etc., and Magnetron, High
Voltage Harness etc..)
TABLE OF CONTENTS
Page
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO
AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY .......................................................... 2
BEFORE SERVICING ............................................................................................................................................ 2
WARNING TO SERVICE PERSONNEL ................................................................................................................. 4
MICROWAVE MEASUREMENT PROCEDURE .....................................................................................................5
FOREWORD AND WARNING ............................................................................................................................... 7
PRODUCT SPECIFICATIONS ............................................................................................................................... 8
GENERAL INFORMATION.................................................................................................................................... 8
OPERATION ......................................................................................................................................................... 10
TROUBLESHOOTING GUIDE ............................................................................................................................. 14
TEST PROCEDURE ............................................................................................................................................ 15
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE.................................................................26
PICTORIAL DIAGRAM .........................................................................................................................................32
PARTS LIST ........................................................................................................................................................ 33
PACKING AND ACCESSORIES ..........................................................................................................................37
S31M332MO30ST
MO30 STA NE
MICROWAVE OVEN
BERTAZZONI SERVICE MANUAL
This document has been published to be used for after
sales service only.
The contents are subject to change without notice.
2
MO30 STA NE
PRECAUTIONS TO BE OBSERVED BEFORE
AND DURING SERVICING TO AVOID POSSIBLE
EXPOSURE TO EXCESSIVE MICROWAVE ENERGY
(a) Do not operate or allow the oven to be operated with the door open.
(b) Make the following safety checks on all ovens to be serviced before activating the magnetron or other microwave
source, and make repairs as necessary: (1) interlock operation, (2) proper door closing, (3) seal and sealing
surfaces (arcing, wear, and other damage), (4) damage to or loosening of hinges and latches, (5) evidence of
dropping or abuse.
(c) Before turning on microwave power for any service test or inspection within the microwave generating
compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity,
and connections.
(d) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and
transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before
the oven is released to the owner.
(e) A microwave leakage check to verify compliance with the Federal Performance Standard should be performed
on each oven prior to release to the owner.
BEFORE SERVICING
Before servicing an operative unit, perform a microwave emission check as per the Microwave Measure-
ment Procedure outlined in this service manual.
If microwave emissions level is in excess of the specified limit, contact BERTAZZONI immediately @
(English/Spanish) 1-866-905-0010 or (French) 1-800561-7625.
If the unit operates with the door open, service person should 1) tell the user not to operate the oven
and 2) contact BERTAZZONI and Food and Drug Administration's Center for Devices and Radiological
Health immediately.
Service personnel should inform BERTAZZONI of any certified unit found with emissions in excess of
4mW/cm2. The owner of the unit should be instructed not to use the unit until the oven has been brought
into compliance.
DANGER CAUTION
HIGH VOLTAGE
Do not energize a microwave oven with the outer case cabinet removed, because a microwave oven
generates High Voltage in the circuit.
If you intend to operate the oven employing the high frequency switching power converter circuit, you should
take special precautions to avoid an electrical shock hazard.
The high voltage transformer, high voltage capacitor and high voltage diode have energized high voltage
potential approx. 8 KV.
The aluminium heat sink is connected to the switching power transistor Collector pole, and has an energized
high voltage potential approx. 650V peak.
DO NOT ACCESS THE HIGH VOLTAGE TRANSFORMER, HIGH VOLTAGE CAPACITOR, HIGH
VOLTAGE DIODE AND HEAT SINK WHEN THE POWER SUPPLY IS CONNECTED TO AN ELECTRICAL
OUTLET.
3
MO30 STA NE
Notes

Specyfikacje produktu

Marka: Bertazzoni
Kategoria: Magnetostrykcja
Model: MO30STANE

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bertazzoni MO30STANE, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Magnetostrykcja Bertazzoni

Bertazzoni

Bertazzoni KOTR30XV Instrukcja

3 Października 2024
Bertazzoni

Bertazzoni MO30STANE Instrukcja

31 Sierpnia 2024
Bertazzoni

Bertazzoni F45CONMOWX Instrukcja

6 Lipca 2024

Instrukcje Magnetostrykcja

Najnowsze instrukcje dla Magnetostrykcja

Sharp

Sharp R-334W Instrukcja

15 Października 2024
Whirlpool

Whirlpool WMCS7022RS Instrukcja

15 Października 2024
Insignia

Insignia NS-MW11BK5 Instrukcja

15 Października 2024
Insignia

Insignia NS-MW7RM5 Instrukcja

15 Października 2024
Maytag

Maytag UMCS5022RZ Instrukcja

15 Października 2024
Whirlpool

Whirlpool AMW 730/WH Instrukcja

14 Października 2024
Whirlpool

Whirlpool AVM 220/WP/AV Instrukcja

14 Października 2024
Daewoo

Daewoo KOR-6CDS8 Instrukcja

14 Października 2024
Pelgrim

Pelgrim MAG740 Instrukcja

13 Października 2024
Sharp

Sharp R-2V11B Instrukcja

13 Października 2024