Instrukcja obsługi Bauknecht GSF Excellence 9r 9r pc power clean

Bauknecht zmywarka GSF Excellence 9r 9r pc power clean

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht GSF Excellence 9r 9r pc power clean (8 stron) w kategorii zmywarka. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/8

GB -1-

Chart

ON/OFF

BUTTON PROGRAMME

SELECTION BUTTON

Press button “Program”

(repeatedly) until the required

indicator of programme lights

up (see “Table of

programmes” below).

START BUTTON

The indicator lights up

during operation, and

goes off at the end of the

programme.

RESET BUTTON

For programme change or indication of faults.

Press and hold for 3 sec. this button to cancel a started

programme and selected extra options. Press this button to

cancel the main fault indicators “F..” also refer to the chapter

“What to do if...”. The programme can then be selected and

started.

(see at right for options

description)

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programmes

Detergent

Consumption

PProgrammes Available

options Loading instructions Litres Kwh Minutes 1)

1Auto 40-70°C

Delay

Multizone

Power Clean

Normally or heavily soiled crockery, including

pots and pans. None soaking or hand pre-

treatment is needed. In addition hygiene of the

complete loading is ensured with this

programme.

X 7-17 0.99-1.75 65-220

2Pre-Wash cold Delay

Multizone Crockery to be washed later. — 4.0 0.03 14

3Glasses 40°C Delay

Multizone Light soiling, for example glasses and cups. X 10.0 0.85 100

4Quickwash 40°C Delay

Multizone

Lightly soiled crockery, with no dried-on food.

* Not recommended tablets use. X*10.0 0.65 30

5Eco 2) 50°C

Delay

Multizone

Power Clean

Normally soiled crockery. X 11.0 1.05 150

6Antibacterial3) Delay

Multizone

Power Clean

Normally or heavily soiled crockery, with

additional antibacterial wash. Programme

interruption (e.g. due to door opening) can

compromise elimination of germs.

X 13.0 1.50 115

7Overnight 55°C Delay

Multizone

Normally soiled crockery, gentle and quiet

thanks to the lower spray pressure (39dbA). X 13.0 1.20 290

5019 496 01574

GSF Excellence 9R PC

Options and display description

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE INSTALLATION INSTRUCTIONS!

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time (h:mm), whereas with “Delayed start” selected it

indicates the time remaining until programme start (hh) and below 1h (0:mm).

If “F..” appears on the display, see chapter “What to do if...”.

KEYBOARD LOCK

This option allows you to lock the buttons on the

control panel. Children will not be able to

accidentally start the dishwasher by pressing the

buttons on the control panel when this option is

selected. If you want to activate or deactivate this

option hold down the Multi Zone button for three

(3) seconds. “Keyboard lock indicator” will flash

during activation and acoustic signal will confirm

activation. Deactivation is done in the same way.

MULTIZONE

Allows you to choose

the washing zones.

Press this button

(repeatedly) to select

the wash zones:

both racks

only lower

rack

only upper

rack

POWER CLEAN

Thanks to the

additional power jets

this option provides

a more intensive and

powerful wash in the

lower rack, in the

specific area.This

option is

recommended for

washing pots and

casseroles (see

page 4). Press this

button to activate

Power Clean (the

indicator lights up).

RINSE AID

INDICATOR

When lit, the rinse

aid dispenser

needs to be

refilled.

SALT

INDICATOR

When lit, the salt

reservoir needs to

be refilled.

DELAY

INDICATOR

When lit, the time

selection and

delay start

countdown.

DELAYED START

BUTTON

Press the button

(repeatedly) to delay the

start of the programme.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed start

indicator increases by one

hour and after 24 resets

from 0. Then press the

START button. The

dishwasher will start after

the set time.

KEYBOARD

LOCK

INDICATOR

When lit, the

keyboard lock

option is

activated.

SET THE

DETERGENT

Press to select

tablets. If not

selected then

powder is a

default detergent.

Quick reference guide

GB -2-

First time use

1- salt reservoir

2- rinse aid dispenser

3- detergent dispenser

4- racks system

5,6,7,8- available functions on the panel

9- filters

10- spray arms

1. Ask your water supply company what the water hardness is... 2. ...enter this value

on your

dishwasher

Suggestions for detergent use

German

degrees °dH

French

degrees °fH

English

degrees °eH

Water

hardness

Insert value is shown

in the display

Gel or Powder

(rinse aid and salt) Tabl et s

0 - 5 0 - 9 0 - 6.3 Soft 1

go to step 1

(see “Daily check”)

if extra salt is

needed go to

step 1

(see “Daily check”)

6 - 10 10 - 18 7 - 12.6 Medium 2

11 - 15 19 - 27 13.3 - 18.9 Average 3

16 - 21 28 - 37 19.6 - 25.9 Medium-hard 4

22 - 28 38 - 50 26.6 - 35 Hard 5

29 - 35 51 - 63 35.7 - 44.1 Very hard 6

36 - 60 64 - 107 44.8 - 74.9 Extremely hard 7

* only before the first wash or if the water hardness has been changed

Switch on the appliance

- Select the 2nd programme “P2” - consult the table in the Programme Chart.

- Press the START button for at least 5 seconds until the START indicator lamp flashes.

- The water hardness setting is shown on the di the START button flashes.splay (if present) or

- With each successive touch of the START button the setting increases and when it reaches 7 it returns to 1 again.

- The appliance must be switched off to memorise the new setting.

Even if you use tablets which include salt,

you must still add salt since such detergents

are not effective enough at softening hard

water.

Water hardness level is factory set for

medium hard water (a number “4” is

shown on the display).

1Visual indicator

(depending

on model).

Fill the salt reservoir

with water before the

first wash only.

Add salt

(never add detergent!).

min. 1.5 kg

max. 2 kg

Visual indicator

(depending on

model). Screw

on the cap. Salt

residues around

cap need to be

removed.

The salt level indicator lamp may remain lit for the

duration of several wash cycles. If the water

hardness level falls within category (soft), no salt is

required.

Salt indicator (depending on the model)

orange: OK. clear: NEEDS TO

BE ADDED

The indicator lamp on the control panel lights up

when SALT NEEDS TO BE ADDED.

Daily check

Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!)

How to set water hardness in order to always assure the best cleaning results

GB -3-

Daily check

Rinse aid indicator (depending on model) The indicator lamp on the control panel lights up when RINSE AID NEEDS

TO BE ADDED. dark: OK. clear: NEEDS TO BE ADDED

Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault function of the

appliance.

If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crocke e the dosage by turning the dial to a higher settiry is not perfectly dry: increas ng (5-6). Plastic dishes have more difficulty

drying and a higher rinse aid setting will not improve the situation.

Detergents with rinse aid incorporated may be effective only with longer programmes. In the case of shorter programmes, detergent residue may be a problem (if necessary, use powder detergent). Detergents

with rinse aid incorporated tend to form excess suds.

If required, open

the cover

(press lever).

Open the cover A

(press lever).

Only fill the

detergent dispenser

prior to starting a

wash programme.

Use one tablet per one cycle, only placed in

detergent dispenser.