Instrukcja obsługi Bauknecht GSF 7599 TW-WS

Bauknecht zmywarka GSF 7599 TW-WS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht GSF 7599 TW-WS (4 stron) w kategorii zmywarka. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

Further indications are given in the pages to follow and in the user instructions.

Water supply indicator

Check the appliance fills with water.

Lower spray arm block indicator

Release the spray arm.

“Water stop” device indicator

“Water stop” device not working. Switch off

the dishwasher and shut off the water tap.

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add

regeneration salt immediately before

starting a wash programme.

Programme progress indicator Delayed start buttons

The wash cycle can be programmed to start after 1-24 hours.

Then press the Start button. The dishwasher will start at the set time.

Time and failure display

Indicates in hours the time remaining until the start of the wash cycle.

Switches off when the programme has started. Toward the end

of the programme, during the drying cycle, the display will indicate the

time remaining in minutes.

“F1--F9” Identification of faults for service technician.

Start button

Indicator lamp lit while the dishwasher is operating. Flashes when

a fault occurs. Switches off at the end of the programme.

On / Off Button

Pre-rinse /

Pre-wash

Washing

Drying

Programme

end

Options

Half Load button

This function can be used with any

programme. The indicator lamp

switches on: the wash cycle is activated

for the upper or lower rack only.

Programme Symbol

and Temperature

Programme selection and

recommended load type

Place the detergent in the:

small large

compartment compartment

Consumption 1)

Normal load / (Half load)

Water

(Litres) Energy

(kWh) Time

(Min.)

Eco Normal 40 - 55° C Recommended programme

for routine washes, for crockery with

little or no dried-on food. X X

(13.5)

(11.5)

(1.3)

(0.9)

(80)

(60)

Intensive 60 - 70° C Recommended programme for heavily soiled crockery, with

dried-on food. Especially suitable for pans and saucepans. X X

(19.5)

(11.5)

(1.7)

(1.3)

(98)

(90)

Pre-wash Crockery to be washed later. - - 5.0 (4.2) 0.02 (0.02) 9 (9)

Rapid 40° C Lightly soiled crockery with no dried-on food. - X 13.0 (13.0) 0.85 (0.75) 30 (30)

Glasses 40° C Light soiling, especially glasses and cups. - X 12.0 (10.0) 0.82 (0.78) 60 (59)

Standard 50° C 2) Normally or heavily soiled crockery with dried-on food. X X 16.0 (14.5) 1.05 (0.90) 120 (117)

DYNAMIC SENSE: Energy savings and optimum wash results

The two sensor-controlled “DYNAMIC SENSE” wash options are recommended for

routine washes. They use double-sensor technology. Separate sensors gauge turbidity

and particles in order to determine the degree of soiling of the wash water. In

accordance with values measured, a microprocessor establishes optimum water,

energy and time consumption. Optimum wash results are thus achieved using only

those resources strictly required.

Quick Reference Guide

5019 100 90353

(We reserve the right to make technical modifications)

1) Values may vary in relation to usage, e.g.: different loads,

water temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.

2) Reference programme for Test Institute and energy-label.

GSF 7599

1. After loading the dishwasher, close the

door properly and open the water

supply tap.

2. Press the On/Off button to switch the

dishwasher on.

One of the programme

indicator lamps will switch on.

3. Select the desired programme by

pressing the corresponding button.

The corresponding indicator lamp

lights up. If required, select options (if

supplied).

4. Press the Start button to start the

selected programme. The Start

indicator lamp will light up. Once set,

the programmed data cannot be

altered by pressing the programme

selector buttons.

Note: once the Start buttonhas been

pressed, the dishwasher memorises the

last programme selected. This

information remains in the memory even

during interruption of the power supply.

To change the selected

programme, press the Start

button for about 5 seconds, until

the Start indicator lamp

switches off. Select a new

programme and press the Start

button.

Note: if the dishwasher is switched off

during a wash programme, when

switched on again it will resume the

wash cycle from where it was

interrupted.

Only open the dishwasher door if

strictly necessary during a wash

cycle and exercise maximum

caution. Danger of scalding from

steam.

5. To indicate the end of the programme,

the Start indicator lamp switches off

and the End indicator lamp (if fitted)

lights up (for about 30 min.).

6. Once the Start indicator lamp has

switched off press the On/Off button to

switch the dishwasher off. All the

indicator lamps switch off.

7. Open the door (warning: beware of hot

steam). Unload the lower rack before

the upper one. Close the water tap.

Upper rack

Half Load:

If the upper rack only is to be loaded, place

the cutlery basket “B” in the upper rack.

Rack height adjustment:

(The dishwasher is delivered with the upper

rack in the top position).

The rack height can also be changed

when loaded.To lower: pull out the two

side handles and gently lower the rack.

•To raise: pull up the two side handles

until the rack clicks into place.

•The rack must be level on both

sides.

Crockery holders:

•Down: cups and long-stemmed

glasses.

•Up: plates.

“Vario Organizer” multi-purpose

support:

•To be used, for example, for long-

handled utensils (arrange knives

with the blade facing downwards),

cups and glasses.

•May be used in three different

positions (see also “Dishwasher

loading instructions” on Page 4).

1. Upon the left-hand side of the rack.

2. Upside-down, towards the centre of

the rack.

3. Upside-down, towards the left side.

Glass holder:

Lower rack

Half Load:

Loading the lower rack only gives

greater washing power, especially for

plates and saucepans.

Plate holders:

•May be lowered to increase

available space (A).

Cutlery basket:

•The cutlery basket (B + C)

can be removed

to increase available space.

•Some models are provided with a

grid (D) that can be fitted onto the

cutlery basket.

How to use the dishwasher

Please read the user instructions carefully.

Upper and lower rack

Tips and advice

•Arrange crockery so that items do not

touch each other. Arrange large

crockery in the lower rack and smaller

crockery in the upper rack.

•Load cups at an angle to facilitate

water drainage.

•Generally speaking, place cutlery in the

basket with the handles positioned

downwards, but ensure that any sharp

knives and forks that might cause

injury are placed in the basket with the

handles positioned upwards.

•Make sure the water jet can reach all

loaded items and that the spray arms

turn freely.

Important

•Fill the detergent dispenser and check

the salt and rinse aid level.

•Do not use the appliance for items not

suitable for washing in a dishwasher,

for example: wooden items, aluminium,

plastic utensils, tin, hand-decorated

crockery (unglazed), silver cutlery.

•Do not put liquid fat in the dishwasher

(e.g. oil used for frying) or candle wax.

•If a fault occurs or you wish to change

the current programme, press the

“ ”START button for about 5 seconds

until the Start indicator lamp switches

off.

•If regeneration salt is to be added,

immediately start a wash programme

in order to eliminate any residual salt

(rinsing alone is not sufficient).

•Sometimes even though the

regeneration salt container has been

filled, the corresponding indicator lamp

(if fitted) will light up during the first

wash cycle after filling with salt.

•Before starting a wash programme,

make sure that the spray arms can turn

freely and are not impeded by crockery

or cutlery.

•Only switch off the dishwasher once

the “Start” indicator lamp has switched

off. If the dishwasher is switched off

during a wash cycle, when switched on

again it will resume the cycle from

where it was interrupted without having

to start it again

If a fault occurs, before contacting our

After-Sales Service, make the following

checks to try and remedy the problem:

The dishwasher is not working:

•Is the plug properly inserted in the wall

socket?

•Is there a power failure?

•Is the dishwasher switched on?

•Has the Start button been pressed?

•Has the delayed start timer been set (if

fitted)?

•Is the water supply tap on?

•Is the flow of water obstructed by

impurities? If so, close the water supply tap,

detach the water hose and clean the filter.

Then re-connect the water hose to the tap

and open the water tap once again.

• “Are the filters clogged? (See Care and

Maintenance” chapter in the user

instructions).

•Is the door closed properly?

•Is a fault indicated?

(The Start indicator lamp flashes).

Start the programme again from the

beginning: press the Start button for

about 5 seconds, until the Start indicator

lamp switches off.

Select a new programme and press the

Start button.

Crockery still dirty after washing:

•Was the crockery loaded properly?

•Crockery must be loaded facing

downwards; this is important, especially

for large items of crockery.

•The water jets must spray the entire

surface of all items.

•Make sure that crockery and cutlery are

arranged properly.

•Have you selected the correct programme?

•Did you use too much or too little

detergent? (The use of poor quality

detergents may result in less effective

washing).

•Are the filters clogged or incorrectly

assembled? (See “Care and

Maintenance” chapter in the user

instructions).

•Are the spray arms blocked or the nozzles

clogged? (See “Care and Maintenance”

chapter in the user instructions).

•Is the lower spray arm correctly fitted?

•Is the salt container cap (water softening

system) screwed down?

Marked crockery:

•Is the water hardness level selector not

properly adjusted? (See “Filling the salt

container” in the user instructions).

•Is the salt container empty?

(See “Filling the salt container” in

the user instructions).

•Was insufficient detergent used?

(See “Filling the detergent dispenser”

in the user instructions).

Marked glasses and cutlery:

•Was too much rinse aid used?

(See “Filling the rinse aid dispenser”

in the user instructions).

Note: with some models, when the Start

button is pressed a pre-wash cycle precedes

the actual wash programme; this

regenerates the water softening system.

If after carrying out the above checks

the malfunction persists or appears

again, turn the appliance off and turn

off the water supply tap, then call

our After-Sales Service (see guarantee).

Please specify:

•The nature of the fault.

•The appliance type and model.

•The service code (the number after

the word Service on theadhesive

rating plate) inside the door

on the right-hand side.

•Your full address and telephone

number.

AFTER-SALES

SERVICE

Troubleshooting Guide

Please read the user instructions carefully.

Specyfikacje produktu

Marka:	Bauknecht
Kategoria:	zmywarka
Model:	GSF 7599 TW-WS

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bauknecht GSF 7599 TW-WS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje zmywarka Bauknecht

Bauknecht B2F HD624 A Instrukcja

21 Września 2024

Bauknecht BK7IPA15BM6L0 Instrukcja

21 Września 2024

Bauknecht BFC 3C26 Instrukcja

20 Czerwca 2024

Bauknecht GSFH Symphony 05 Instrukcja

20 Czerwca 2024

Bauknecht GSIP 6798 in Instrukcja

20 Czerwca 2024

Bauknecht GSIP 6627 2 in Instrukcja

20 Czerwca 2024

Bauknecht GSU 81414 Instrukcja

20 Czerwca 2024

Bauknecht GSU 4591 Instrukcja

20 Czerwca 2024

Bauknecht GSU 5531 Instrukcja

20 Czerwca 2024

Bauknecht GSU 5545 Instrukcja

20 Czerwca 2024

Instrukcje zmywarka

Najnowsze instrukcje dla zmywarka

Gaggenau DF271100 Instrukcja

12 Października 2024

Gaggenau GI 256-161 Instrukcja

11 Października 2024

Miele G5050SCVI Instrukcja

9 Października 2024

Daewoo DA1D5SW0ES-2 Instrukcja

26 Września 2024

Daewoo DA248FI0ES-2 Instrukcja

26 Września 2024

Daewoo DA248FI7ES Instrukcja

26 Września 2024

Daewoo DA1D5SI0ES-2 Instrukcja

26 Września 2024

Daewoo DA134FW1ES Instrukcja

26 Września 2024

Daewoo DA134FI1ES Instrukcja

26 Września 2024

Daewoo DA1D5FW1ES Instrukcja

26 Września 2024