Instrukcja obsługi Bauknecht GSF 4062 TW

Bauknecht zmywarka GSF 4062 TW

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht GSF 4062 TW (4 stron) w kategorii zmywarka. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

Further indications are given in the pages to follow and in the user instructions.

“Water stop” device indicator

“Water stop” device not working.

Switch off the dishwasher and shut off the

water tap.

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add

regeneration salt immediately before

starting a wash programme.

Programme progress indicator

Start button

Indicator lamp lit while the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

On / Off Button

Pre-rinse / Pre-wash

Washing

Drying

Programme end

Options

Eco-Dry button

Dry cycle without using fans.

Programme Symbol

and Temperature

Programme selection and

recommended load type

Place the detergent in the:

Consumption 1)

Normal loadsmall

compartment large

compartment

Water

(Litres) Energy

(kWh) Time

(Min.)

Pre-wash Crockery to be washed later. - - 95.0 0.02

Rapid 40° C lightly soiled crockery with no dried-on food. - X 13.0 0.85 30

Bio-Eco 50° C Normally soiled crockery, with dried-on food. - X 12.5 1.30 73

Bio-Normal 50° C 2) Normally or heavily soiled crockery with dried-on food. X X 16.0 1.40 86

Normal 65° C 3) Normally or heavily soiled crockery. X X 16.0 1.60 86

Intensive 70° C Heavily soiled pans and saucepans. X X 21.5 1.70 93

Quick Reference Guide

5019 100 90299

(We reserve the right to make technical modifications)

1) Values may vary in relation to usage, e.g.: different loads, water temperatures (above or below 15° C), water hardness and power supply voltage, etc.

2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

GSF 4062

1. After loading the dishwasher, close the

door properly and open the water

supply tap.

2. Press the On/Off button to switch the

dishwasher on.

One of the programme

indicator lamps will switch on.

3. Select the desired programme by

pressing the corresponding button.

The corresponding indicator lamp

lights up. If required, select options (if

supplied).

4. Press the Start button to start the

selected programme. The Start

indicator lamp will light up.

Once set,

the programmed data cannot be

altered by pressing the programme

selector buttons.

Note: Once the Start button

has been pressed, the dishwasher

memorises the last programme selected.

This information remains in the memory

even during interruption of the power

supply.

To change the selected

programme, press the Start button

for about 5 seconds, until the Start

indicator lamp switches off.

Select a new programme using the

programme selector knob and

press the Start button.

Note:

If the dishwasher is switched off

during a wash programme, when

switched on again the dishwasher

resumes the wash cycle from where it

was interrupted.

Only open the dishwasher door if

strictly necessary during a wash

cycle and exercise maximum

caution. Danger of scalding from

steam.

5. To indicate the end of the programme,

the Start indicator lamp switches off

and the End indicator lamp (if fitted)

switches on (for about 30 min.).

6. Once the Start indicator lamp has

switched off press the On/Off button to

switch the dishwasher off. All the

indicator lamps switch off.

7. Open the door (warning: beware of hot

steam). Unload the lower rack before

the upper one. Close the water tap.

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper

rack in the top position).

The rack height can also be changed

when loaded.

•To lower: pull out the two side

handles and gently lower the rack.

•To raise: pull up the two side handles

until the rack clicks into place.

•The rack must be level on both

sides.

Crockery Holders:

•Down:

cups and long-stemmed glasses.

•Up: plates.

Glass holder:

•The glass holder can be moved

sideways.

•Below: small glasses.

•Above: long-stemmed glasses.

Lower rack

Plate holders:

•May be lowered to increase

available space (A).

•May be removed to increase

available space(B).

To remove: pull the handle up.

Cutlery basket (C):

The cutlery basket can be removed to

increase (C) available space.

How to use the dishwasher

Please read the user instructions carefully.

Upper and lower rack

Tips and advice

•Arrange crockery so that items do not

touch each other. Arrange large

crockery in the lower rack and smaller

crockery in the upper rack.

•Load cups at an angle to facilitate water

drainage.

•Generally speaking, place cutlery in the

basket with the handles positioned

downwards, but ensure that any sharp

knives and forks that might cause injury

are placed in the basket with the

handles positioned upwards.

•Make sure the water jet can reach all

loaded items and that the spray arms

turn freely.

Important

•Fill the detergent dispenser and check

the salt and rinse aid level.

•Do not use the appliance for items not

suitable for washing in a dishwasher, for

example: wooden items, aluminium,

plastic utensils, tin, hand-decorated

crockery (unglazed), silver cutlery.

•Do not put liquid fat in the dishwasher

(e.g. oil used for frying) or candle wax.

•If a fault occurs or you wish to change the

current programme,

press the “START” button for about 5

seconds until the Start indicator lamp

switches off.

•If regeneration salt is to be added

immediately start a wash programme

in order to eliminate any residual salt

(rinsing alone is not sufficient).

•Sometimes even after the regeneration

salt container has been filled, the

corresponding indicator lamp (if

present) may light up during the first

wash cycle.

•Before starting a wash programme,

make sure that the spray arms can turn

freely and are not impeded by crockery

or cutlery.

•Only switch off the dishwasher once the

“ ”Start indicator lamp has switched off.

If the dishwasher is switched off during a

wash cycle, when switched on again it

will resume the cycle from where it was

interrupted without having to start it

again.

If a fault occurs, before contacting our

After-Sales Service, make the following

checks to try and remedy the problem:

The dishwasher is not working:

•Is the plug properly inserted in the wall

socket?

•Is there a power failure?

•Is the dishwasher switched on?

•Has the Start button been pressed?

•Has the delayed start timer been set

(if fitted)?

•Is the water supply tap on?

•Is the flow of water obstructed by impurities?

If so, close the water supply tap, detach the

water hose and clean the filter. Then re-

connect the water hose to the tap and open

the water tap once again.

• “Are the filters clogged? (See Care and

maintenance” chapter in the user

instructions).

•Is the door closed properly?

•Is a fault indicated?

(The Start indicator lamp flashes).

Start the programme again from the

beginning: Press the Start button for

about 5 seconds, until the Start indicator

lamp switches off.

Select a new programme and press the

Start button.

Crockery still dirty after washing:

•Was the crockery loaded properly?

•Crockery must be loaded facing

downwards; make sure, especially for

large crockery.

•The water jets must spray the entire

surface of all items.

•Make sure that crockery and cutlery are

arranged properly.

•Have you selected the correct

programme?

•Did you use too much or too little

detergent? (The use of poor quality

detergents result in less effective

washing).

•Are the filters clogged or incorrectly

assembled?

(See “Care and Maintenance” chapter in

the user instructions).

•Are the spray arms blocked or the nozzles

clogged? (See “Care and Maintenance”

chapter in the user instructions).

•Is the lower spray arm correctly fitted?

•Is the salt container cap (water softening

system) screwed down?

Marked crockery:

•Is the water hardness level selector not

properly adjusted? See (“Filling the salt

container” in the user instructions).

•Is the salt container empty?

(See “ ”Filling the salt container in the user

instructions).

•Was insufficient detergent used? (See

“ ”Filling the detergent dispenser in the

user instructions).

Marked glasses and cutlery:

•Was too much rinse aid used?

(See “Filling the rinse aid dispenser” in the

user instructions).

Note: With some models, when the Start

button is pressed a pre-wash cycle precedes

the actual wash programme; This

regenerates the water softening system.

If, after carrying out the above checks the

malfunction persists or appears again,

turn the appliance off and turn off the

water supply tap, then call our After-Sales

Service (see guarantee). Please specify:

•The nature of the fault.

•The appliance type and model.

•The service code (the number after

the word Service on the

adhesive rating plate) inside the door on

the right-hand side.

•Your full address and telephone number.

AFTER-SALES

SERVICE

Troubleshooting Guide

Please read the user instructions carefully.

Specyfikacje produktu

Marka:	Bauknecht
Kategoria:	zmywarka
Model:	GSF 4062 TW

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bauknecht GSF 4062 TW, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje zmywarka Bauknecht

Bauknecht B2F HD624 A Instrukcja

21 Września 2024

Bauknecht BK7IPA15BM6L0 Instrukcja

21 Września 2024

Bauknecht BFC 3C26 Instrukcja

20 Czerwca 2024

Bauknecht GSFH Symphony 05 Instrukcja

20 Czerwca 2024

Bauknecht GSIP 6798 in Instrukcja

20 Czerwca 2024

Bauknecht GSIP 6627 2 in Instrukcja

20 Czerwca 2024

Bauknecht GSU 81414 Instrukcja

20 Czerwca 2024

Bauknecht GSU 4591 Instrukcja

20 Czerwca 2024

Bauknecht GSU 5531 Instrukcja

20 Czerwca 2024

Bauknecht GSU 5545 Instrukcja

20 Czerwca 2024

Instrukcje zmywarka

Najnowsze instrukcje dla zmywarka

Gaggenau DF271100 Instrukcja

12 Października 2024

Gaggenau GI 256-161 Instrukcja

11 Października 2024

Miele G5050SCVI Instrukcja

9 Października 2024

Daewoo DA1D5SW0ES-2 Instrukcja

26 Września 2024

Daewoo DA248FI0ES-2 Instrukcja

26 Września 2024

Daewoo DA248FI7ES Instrukcja

26 Września 2024

Daewoo DA1D5SI0ES-2 Instrukcja

26 Września 2024

Daewoo DA134FW1ES Instrukcja

26 Września 2024

Daewoo DA134FI1ES Instrukcja

26 Września 2024

Daewoo DA1D5FW1ES Instrukcja

26 Września 2024