Instrukcja obsługi Bauknecht GSF 4055 WS

Bauknecht zmywarka GSF 4055 WS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht GSF 4055 WS (4 stron) w kategorii zmywarka. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/4
Further indications are given in the pages to follow and in the user instructions.
Salt level indicator
Add regeneration salt; only add regeneration
salt immediately before starting a wash
programme.
Start button
Indicator lamp lit while the
dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the
programme.
On / Off Button
Programme Symbol
and Temperature
Programme selection and
recommended load type
Place the detergent in the:
small large
compartment compartment
Consumption 1)
Normal load
Water
(Litres)
Energy
(kWh)
Time
(Min.)
Pre-wash Crockery to be washed later. - - 95.0 0.02
Bio-Eco 50° C Normally soiled crockery. - X 12.5 731.30
Bio-Normal 50° C 2) Normally or heavily soiled crockery with dried-on food. X X 16.0 861.40
Normal 65° C 3) Normally or heavily soiled crockery with dried-on food. X X 16.0 861.60
Intensive 70° C Heavily soiled pans and saucepans. X X 21.5 1701.70
Quick Reference Guide
GB
5019 100 90333
(We reserve the right to make technical modifications)
1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C, water hardness and power supply voltage etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme on the energy data plate.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
GSF 4055
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. Press the On/Off button to switch the
dishwasher on.
One of the programme
indicator lamps will switch on.
3. Select the desired programme by
pressing the corresponding button.
The corresponding indicator lamp
lights up. If required, select options (if
supplied).
4. Press the Start button to start the
selected programme. The Start
indicator lamp will light up. Once set,
the programmed data cannot be
altered by pressing the programme
selector buttons.
Note: once the Start button has been
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds, until the Start
indicator lamp switches off.
Select a new programme using the
programme selector knob and
press the Start button.
Note: if the dishwasher is switched off
during a wash programme, when
switched on again it will resume the
wash cycle from where it was
interrupted.
Only open the dishwasher door if
strictly necessary during a wash cycle
and exercise maximum caution.
Danger of scalding from steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and the End indicator lamp (if fitted)
lights up (for about 30 min.).
6. Once the Start indicator lamp has
switched off press the On/Off button to
switch the dishwasher off. All the
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
Upper rack
Crockery holders:
Down: cups and long-stemmed glasses.
Up: plates.
Glass holder:
Lower rack
Cutlery basket:
The cutlery basket can be removed
to increase (C) available space.
C
C
How to use the dishwasher
Please read the user instructions carefully.
Upper and lower rack
Tips and advice
Arrange crockery so that items do not
touch each other. Arrange large
crockery in the lower rack and smaller
crockery in the upper rack.
Load cups at an angle to facilitate
water drainage.
Generally speaking, place cutlery in the
basket with the handles positioned
downwards, but ensure that any sharp
knives and forks that might cause
injury are placed in the basket with the
handles positioned upwards.
Make sure the water jet can reach all
loaded items and that the spray arms
turn freely.
Important
Fill the detergent dispenser and check
the salt and rinse aid level.
Do not use the appliance for items not
suitable for washing in a dishwasher,
for example: wooden items, aluminium,
plastic utensils, tin, hand-decorated
crockery (unglazed), silver cutlery.
Do not put liquid fat in the dishwasher
(e.g. oil used for frying) or candle wax.
If a fault occurs or you wish to change
the current programme, press the
“ ”START button for about 5 seconds until
the Start indicator lamp switches off.
If regeneration salt is to be added,
immediately start a wash programme
in order to eliminate any residual salt
(rinsing alone is not sufficient).
Sometimes even though the
regeneration salt container has been
filled, the corresponding indicator lamp
(if fitted) will light up during the first
wash cycle after filling with salt.
Before starting a wash programme,
make sure that the spray arms can turn
freely and are not impeded by crockery
or cutlery.
Switch off the dishwasher once the
“ ”Start indicator lamp has switched off.
If you switch off the dishwasher during
a wash cycle, when switched on again
the dishwasher resumes the cycle from
where it was interrupted without having
to start it again.
If a fault occurs, before contacting our
After-Sales Service, make the following
checks to try and remedy the problem:
The dishwasher is not working:
Is the plug properly inserted in the wall
socket?
Is there a power failure?
Is the dishwasher switched on?
Has the Start button been pressed?
Has the delayed start timer been set (if
fitted)?
Is the water supply tap on?
Is the flow of water obstructed by
impurities? If so, close the water supply tap,
detach the water hose and clean the filter.
Then re-connect the water hose to the tap
and open the water tap once again.
• “Are the filters clogged? (See Care and
maintenance chapter in the user
instructions).
Is the door closed properly?
Is a fault indicated?
(The Start indicator lamp flashes).
Start the programme again from the
beginning: press the Start button for
about 5 seconds, until the Start indicator
lamp switches off.
Select a new programme and press the
Start button.
Crockery still dirty after washing:
Was the crockery loaded properly?
Crockery must be loaded facing
downwards; this is important, especially
for large items of crockery.
The water jets must spray the entire
surface of all items.
Make sure that crockery and cutlery are
arranged properly.
Have you selected the correct programme?
Did you use too much or too little detergent?
(The use of poor quality detergents may
result in less effective washing).
Are the filters clogged or incorrectly
assembled? (See Care and Maintenance
chapter in the user instructions).
Are the spray arms blocked or the nozzles
clogged? (See Care and Maintenance
chapter in the user instructions).
Is the lower spray arm correctly fitted?
Is the salt container cap (water softening
system) screwed down?
Marked crockery:
Is the water hardness level selector not
properly adjusted? See (Filling the salt
container in the user instructions).
• “Is the salt container empty? (See Filling the
salt container in the user instructions).
Was insufficient detergent used? (See
“ ”Filling the detergent dispenser in the
user instructions).
Marked glasses and cutlery:
Was too much rinse aid used? (See
Filling the rinse aid dispenser in the user
instructions).
Note: with some models, when the Start button
is pressed a pre-wash cycle precedes the
actual wash programme; this regenerates the
water softening system.
If after carrying out the above checks
the malfunction persists or appears
again, turn the appliance off and turn
off the water supply tap, then call our
After-Sales Service (see guarantee).
Please specify:
The nature of the fault.
The appliance type and model.
The service code (the number after
the word Service on the adhesive
rating plate) inside the door
on the right-hand side.
Your full address and telephone
number.
AFTER-SALES
SERVICE
Troubleshooting Guide
Please read the user instructions carefully.


Specyfikacje produktu

Marka: Bauknecht
Kategoria: zmywarka
Model: GSF 4055 WS

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bauknecht GSF 4055 WS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje zmywarka Bauknecht

Instrukcje zmywarka

Najnowsze instrukcje dla zmywarka

Gaggenau

Gaggenau DF271100 Instrukcja

12 Października 2024
Gaggenau

Gaggenau GI 256-161 Instrukcja

11 Października 2024
Miele

Miele G5050SCVI Instrukcja

9 Października 2024
Daewoo

Daewoo DA1D5SW0ES-2 Instrukcja

26 Września 2024
Daewoo

Daewoo DA248FI0ES-2 Instrukcja

26 Września 2024
Daewoo

Daewoo DA248FI7ES Instrukcja

26 Września 2024
Daewoo

Daewoo DA1D5SI0ES-2 Instrukcja

26 Września 2024
Daewoo

Daewoo DA134FW1ES Instrukcja

26 Września 2024
Daewoo

Daewoo DA134FI1ES Instrukcja

26 Września 2024
Daewoo

Daewoo DA1D5FW1ES Instrukcja

26 Września 2024