Instrukcja obsługi Atco Balmoral 17 SK

Atco kosiarka Balmoral 17 SK

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Atco Balmoral 17 SK (10 stron) w kategorii kosiarka. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/10
STOP
4
6
10
9
1 2 3 5
7
8
11
12
13
14
15
Balmoral - Seite 3 Seite 1 Freitag, 1. Dezember 2006 11:39 11
Cylinder Mower Balmoral 14 SK Balmoral 17 SK Balmoral 20 SK
Part number 3 616 C07 ... 3 616 C08 ... 3 616 C09 ...
Engine size (cm
3)
98 98 98
Fuel Tank capacity (l) 1.8 1.8 1.8
Rated power 2.2 kW (3.0 Hp) 2.2 kW (3.0 Hp) 2.2 kW (3.0 Hp)
Blade width (cm) 35 43 50
Height of cut (mm) 6
–
35 6
–
35 6
–
35
Cuts per metre 79 79 79
Grassbox capacity (l) 52 62 70
Weight (kg) 45 51 54
Max overall width (cm) 51 60 68
Serial Number See rating details on machine
This product is intended for domestic lawn
mowing.
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is im-
portant that you read these instructions care-
fully.
When fully assembled the machine weighs ap-
proximately 45 kg – 54 kg. If necessary, obtain
assistance to remove from packaging.
Take care when transporting the mower to the
lawn, as the blades are sharp.
Carefully remove the machine from its packag-
ing and check that you have all the following
items:
– Lawnmower with handle assembly
– Operating instructions
– Machine registration card
– Engine maintenance manual
– Hexagonal wrench
– Grassbox
– Grassbox cradle
When parts are missing or damaged, please
contact your dealer.
1
Throttle lever
2
Red safety latch
3
Cutter control lever
4
Drive control lever
5
Handle top
6
Engine cut-off switch
7
Petrol filler cap
8
Petrol tank
9
Handle bottom
10
Grassbox
11
Choke lever
12
Carburettor
13
Recoil cord handle
14
Petrol tap
15
Serial No
Not all of the accessories illustrated or described are
included as standard delivery.
Handles
Unfold the handle top
5
and secure with wing
nut
16
. Make sure the cables do not become
trapped between the handles.
The handle top is height adjustable. The spin-
dle
17
can be repositioned in desired position
I
,
II
or
III
.
Use cable clips to attach cables to bottom han-
dle
9
and top handle
5
.
Product Specification
Intended Use
Introduction
Delivered Items
Operating Controls
Assembly
A
A
A
AA
Balmoral - GB Seite 2 Freitag, 1. Dezember 2006 11:42 11
Petrol
Petrol deteriorates over time. Engine starting
may be difficult if you use petrol kept for more
than 30 days. Always run the fuel tank dry when
storing over 30 days.
1. Remove the petrol filler cap
7
, slowly add un-
leaded petrol to the tank
8
, fill to approx.
halfway up the fuel strainer.
2. Replace the petrol filler cap
7
.
3. Wipe up any spilt petrol from the engine be-
fore starting the mower.
Engine Oil
The mower is not supplied with oil in the engine,
however it is possible that there is a small quan-
tity in the engine. It is essential to fill with oil be-
fore starting the engine to avoid damage to
your engine. It is important to use the recom-
mended oil to avoid damage to your engine.
1. With the mower standing on level ground,
unscrew and remove the oil filler dip stick
18
.
2. Wipe the oil filler dip stick
18
clean; insert the
oil filler dip stick
18
, then remove it again. Do
not screw it in. Check the oil level.
3. Add a good-quality SAE 30 API SF in small
quantities at a time, allowing it to settle. Re-
peatedly add oil and check the level until it
reaches the max. position dip stick
18
. The
engine may require up to 0.4 litres of oil.
4. Refit the oil fill dip stick
18
.
Grassbox/bag
Attach/remove the grassbox
10
as shown.
Height of Cut Adjustment
Your mower has an infinitely adjustable height
of cut between 6 - 35 mm with four markings
21
between these (numbered 1 - 4) as a guide to
adjustment. A fifth position labelled „S“ should
only be used with the scarifier cassette acces-
sory or to achieve a particularly short cut if the
lawn is very flat. The height of cut is adjusted by
turning the knob
19
at the right hand rear of the
machine. The comb will also require adjust-
ment, see „Comb Adjustment“.
Comb Adjustment
Your mower is fitted with an adjustable comb
25
which can be brought into use on the lower
heights of cut. The comb is set by loosening the
screws
24
and rotating the comb until the tines
just touch the ground. You may need to re-ad-
just after changing the height of cut. Take care
not to set the comb too deep, as this could
cause damage to either your mower or lawn.
Cutting Long Grass Using Side Wheel Kit (ap-
propriate models only)
Your mower is fitted with a full width front roller
which is suitable for normal smooth lawns. For
cutting longer, coarse grass a side wheel kit can
be fitted.
To fit this kit proceed as follows:
1. Tilt the mower back and wedge securely.
2. Remove the front roller/comb assembly by re-
moving bolt
26
and removing screw
24
on both
sides.
3. Fit the side wheel
29
, on to the side wheels
spindle
28
.
4. Fit each side wheel assembly on both sides of
the roller brackets as shown and fix with bolt
30
Refit the full width roller by following steps 1-4 in
reverse.
D
Starting and Stopping
Starting from Cold
1. Move the throttle lever
1
to position .
2. Move the engine cut-off switch
6
to „
I
“.
3. Turn the petrol tap
14
„On“.
4. Move the choke lever
11
to .
5. Pull the recoil cord handle
13
. Allow the recoil
handle to return slowly after each pull.
6. Gradually turn the choke lever
11
to .
Starting from Hot
Follow “Starting from Cold” using steps 1,3 & 5
only.
If the engine does not start or will not continue
to run, follow the “Starting from Cold” proce-
dure with choke
11
lever between the
and position.
Stopping
1. Move the throttle lever
1
to position .
2. Move the engine cut-off switch
6
to „0“.
3. Turn the petrol tap
14
„Off“.
Engaging cylinder cutter and rear roller
1. Start engine.
2. Push the red safety latch
2
forward and grad-
ually squeeze the cutter control lever
3
to-
wards the top handle
5
.
3. Gradually squeeze the drive control lever
4
towards the top handle
5
.
4. Release the safety button
2
.
5. Adjust the speed as required by moving the
throttle lever
1
between and .
6. To stop, release both control levers
4
and
3
.
B
B
B
BB
C
C
C
CC
C
C
C
CC
D
D
D
DD
Using Your mower
D
D
D
DD
E
E
E
EE
F
F
F
FF
Balmoral - GB Seite 3 Freitag, 1. Dezember 2006 11:42 11

Specyfikacje produktu

Marka: Atco
Kategoria: kosiarka
Model: Balmoral 17 SK

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Atco Balmoral 17 SK, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje kosiarka Atco

Atco

Atco Balmoral 17 SK Instrukcja

31 Sierpnia 2024

Instrukcje kosiarka

Najnowsze instrukcje dla kosiarka

Powerblade

Powerblade V475 Instrukcja

10 Grudnia 2024
Powerblade

Powerblade 350CX Instrukcja

10 Grudnia 2024
Ozito

Ozito CPM-300C Instrukcja

10 Grudnia 2024
Hecht

Hecht 5654 Instrukcja

9 Grudnia 2024
Stihl

Stihl RM 253 Instrukcja

8 Grudnia 2024
Baumr-AG

Baumr-AG 730EX Instrukcja

7 Grudnia 2024
Baumr-AG

Baumr-AG 790SXe Instrukcja

7 Grudnia 2024
Flymo

Flymo Chevron 34C Instrukcja

6 Grudnia 2024
Flymo

Flymo Turbo Compact 330 Instrukcja

6 Grudnia 2024
Flymo

Flymo Easimo 900W Instrukcja

6 Grudnia 2024