Instrukcja obsługi AstralPool Rolachem RC1


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AstralPool Rolachem RC1 (8 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/8
INSTALLATION AND
OPERATING INSTRUCTIO NS
sales@astralpool.com.au
www.astralpool.com.au
INSTALLATION AND OPERATING INSTRUCTIONS I INSTALLATION AND OPERATING INSTRUCTIONS
RC1 Semi-Automatic
Controllers
INST234 RolaChem RC1 Semi - Automatic Controllers 8_ V0 20
2
Congratulations, you have made a good choice in purchasing a RolaChem RC1 controller by Astral Pool.
Swimming pool chemistry is quite interesting and dynamic. There is no one setting that is right for every swimming pool or
spa. Let the RC1 settle down over a couple of days and then if necessary alter the setting to suit your pool or spa.
If large quantities of chemicals are dumped in the pool water, this excess quantity should be circulated well and then,
allowed to settle down before this machine starts to give true readings.
If you have any questions please contact your Astral Pool supplier or us directly.
INDEX
Note:
The appliance is not intended for use by young children or inrm person without supervision. Please ensure that young
children are supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualied person in
order to avoid a hazard.
Power to this controller must be either;
Supplied by an isolating transformer
Supplied through a residual current device (RCD) with a rated residual operating current not exceeding 30 mA
INDEX
STARTING UP 3………………………………………………………………………………………………………..
INSTALLATION 3……………………………………………………………………………………………………
RC-1 TYPICAL INSTALLATION 5 ………………………………………………………………………………….
MAINTENANCE 6……………………………………………………………………………………………………..
TROUBLE SHOOTING GUIDE 6……………………………………………………………………………………
WARRANTY 7…………………………………………………………………………………………………………
INST234 RolaChem RC1 Semi - Automatic Controllers 8_ V0 20
3
STARTING UP
Before starting up your RC1 controller, it is advisable that the pool water be balanced.
Recommended chemical ranges (depending on pool location and pool surface) are:
CHLORINE: - 3ppm 1 pH 7.2 - 7.8
STABILISER: - 50 mg/L 30
TOTAL ALKALINITY: - 150 mg/L 80
CALCIUM HARDNESS: 90 - 300 mg/L
INSTALLATION
PLEASE READ ALL THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING & OPERATING THE UNIT AND LEAVE THE
MANUAL ON SITE FOR OWNER/OPERATOR’S USE
ROLA CHEM SYSTEMS SHOULD OPERATE ONLY WHEN THE POOL FILTER IS OPERATING.THE UNIT MUST NOT BE
CONNECTED WITHOUT ADEQUATE EARTH CONNECTIONS AND A VOLTAGE OTHER THAN 230-250V
Before installing the unit in position on the wall or post, the length of the PVC tubing provided should be
measured and taken into consideration. To avoid loss of water from the system, close all stop valves before
cutting any lines.
Connection of lines (see illustration page 4)
Install the “T” pieces into the “return’’ line. Cut an appropriate piece out of this line and glue the ‘T’ piece in
position, using a PVC adhesive. Thread the PVC tube through the hole in the cap or shoulder of the chemical
container and t the non-return or check valve and the weight. Ensure that the non-return valve is tted
correctly (arrow indicates the direction of ow) Drop the weight, with the non-return valve into the bottom of
the container.
TIP: Soaking the ends of the PVC tubing in hot water or gentle heating with a lighter makes it easier to push
onto the barb. When installing chemical containers (especially acid), in lter enclosures, which have no
ventilation, it is recommended that the hole in the cap of the container is cut to t tightly around the tubing,
so that fumes from the acid or chlorine will not corrode the equipment. It will be necessary to drill a second
hole in the cap tted tightly with a length of tubing which should then be vented outside the lter enclosure.
This procedure is recommended only where the lter enclosure has no ventilation and is to protect the
equipment.
IMPORTANT: RolaChem pumps dose against a maximum pressure of 150-175 kPA (20-25 psi), avoid excessive pressure
situations such as:
In-oor cleaners (when using for pool applications): The recommended position of the injection point and probe is on
the suction line.
ACID SHOULD BE DILUTED MINIMUM 1:2, MORE DILUTION IS OK
ALWAYS ADD ACID TO WATER (NOT WATER TO ACID)
NEVER MIX CHEMICALS


Specyfikacje produktu

Marka: AstralPool
Kategoria: Niesklasyfikowane
Model: Rolachem RC1

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z AstralPool Rolachem RC1, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane AstralPool

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024