Instrukcja obsługi Argox PT-90

Argox czytnik kodów kreskowych PT-90

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Argox PT-90 (74 stron) w kategorii czytnik kodów kreskowych. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/74

User’s Manual

PT-90 Mobile Computer

(WinCE 6.0 version)

DOC NO. UM-P 05-01 90

Mar . 2010

Version 1.0

Empower the Bar Code

User’s Manual II

NOTICE: at any time without prior notice. This user’s manual may be revised or withdrawn

This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or

converted to any electronic or machine readable form without the prior written consent of

Argox.

Limited warranty and disclaimers

By opening the package of this product you agree to become bound by the liability and

warranty conditions as described below.

Under all circumstances this manual should be read attentively before installing and or using

the product. In no event, will Argox be liable for any direct, indirect, consequential or

incidental damages arising out of use or inability to use both the hardware and software, even

if Argox has been informed about the possibility of such damages.

A serial number appears on all Argox products. This oﬀicial registration number is strictly

related to the device purchased. Make sure that the serial number appearing on your Argox

device has not been removed. Servicing by our service department can only be carried out

under warranty.

All Argox products are warranted for the legal warranty period after purchase, covering

defects in material and workmanship. Argox will repair or, at its opinion, replace products that

prove to be defective in material or workmanship under proper use during the warranty period.

Argox will not be liable in case modiﬁcations are made by the customer. In such case the

standard repair charge will be applicable. The standard charge for repair will also be

applicable in case no defect is found at all. These rules also apply for products that are still

under warranty. Therefore, you are advised to have the product speciﬁcations always at hand.

Trademarks used are property of their respective owners.

User’s Manual I

Table of Contents

1. INTRODUCTION ............................................................................................................. 1

1.1 A M BOUT THIS ANUAL ................................................................................................ 1

1.2 U P S SER AND RODUCT AFETY ..................................................................................... 2

1.3 S PECIFICATIONS ......................................................................................................... 4

2. GETTING STARTED ...................................................................................................... 6

2.1 C HECK THE PACKAGE ................................................................................................ 6

2.1.1 Compact Package 6 ............................................................................................

2.1.2 Cadle & Pistol grip Package (Optional) ......................................................... 7

2.2 D V ETAILED IEW ......................................................................................................... 8

2.2.1 -90 Mobile Computer 8 PT ..................................................................................

2.2.2 Cradle 9 .............................................................................................................

2.3 I , R NSTALLING EPLACING AND HARGING ATTERIESC B ...........................................10

2.3.1 Installing / Replacing the Battery Pack ..........................................................12

2.3.2 Charging the Battery Pack with a Power Adapter .........................................12

2.3.3 Charging the Battery Pack with Cradle .........................................................13

2.4 I NSTALLING IN A YSTEMS .........................................................................................14

2.4.1 Via USB /RS- Cable 232 .................................................................................14

2.4.2 Via CRD-90 Cradle ........................................................................................14

3. OPERATION OF THE MOBILE COMPUT ER ..........................................................15

3.1 K D EYPAD ESCRIPTION ..............................................................................................15

3.2 F K D UNCTION EY ESCRIPTION ..................................................................................16

3.3 I NSTALL MICRO SD CARD INTO PT-90 .....................................................................17

3.4 C - S ONFIGURING PT 90 ETTINGS ...............................................................................18

3.4.1 Calibrating Touch Screen Alignment .............................................................18

3.4.2 Adjusting Brightness ......................................................................................19

3.4.3 Muting Sound .................................................................................................19

3.4.4 Using the Stylus ..............................................................................................19

3.5 E I NTERING NFORMATION .........................................................................................20

3.5.1 Entering Information Using a Keypad ...........................................................20

3.5.2 Entering Information Using the Keyboard Input Panel .................................20

3.5.3 Entering Data via the Bar Code Scanner .......................................................20

3.6 P M OWER ANAGEMENT .............................................................................................21

3.6.1 Power Status Indication .................................................................................21

3.6.2 Saving Battery Power .....................................................................................23

3.6.3 Suspend Mode ................................................................................................24

3.6.4 Resume ...........................................................................................................25

3.7 R - ESETTING THE PT 90 ..............................................................................................25

3.7.1 Performing a Warm Boot ...............................................................................26

3.7.2 Performing a Cold Boot .................................................................................26

3.7.3 Performing a Clean Boot ...............................................................................26

3.8 F S LASH TORAGE ........................................................................................................27

3.8.1 Flash Disk Location .......................................................................................27

3.8.2 Flash Disk Size ...............................................................................................27

3.9 B S LUETOOTH ETTING ...............................................................................................28

3.10 WLAN S ETTING ........................................................................................................34

4. SCANNING ......................................................................................................................35

4.1 S C CAN ONFIGURATION .............................................................................................35

4.2 S CAN DRIVER .............................................................................................................36

Specyfikacje produktu

Marka:	Argox
Kategoria:	czytnik kodów kreskowych
Model:	PT-90

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Argox PT-90, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje czytnik kodów kreskowych Argox

Argox AS-8310 Instrukcja

30 Września 2024

Argox AR-3100 Instrukcja

30 Września 2024

Argox AI-6801 Instrukcja

30 Września 2024

Argox AS-8020CL Instrukcja

30 Września 2024

Argox AI-6821 Instrukcja

30 Września 2024

Argox AI-6821HD Instrukcja

30 Września 2024

Argox AS-8000 Instrukcja

30 Września 2024

Argox AS-8120 Instrukcja

30 Września 2024

Argox PT-90 Instrukcja

30 Września 2024

Argox AS-9600 Instrukcja

30 Września 2024

Instrukcje czytnik kodów kreskowych

Najnowsze instrukcje dla czytnik kodów kreskowych

Posiflex CD-3602U Instrukcja

9 Października 2024

Posiflex CD-3202U Instrukcja

9 Października 2024

Datalogic CBX500 Instrukcja

9 Października 2024

Brady IRX200 Instrukcja

8 Października 2024

Newland HR33 Marlin filaire Instrukcja

8 Października 2024

Wasp WDI9600 Instrukcja

7 Października 2024

Wasp WLS9500 Instrukcja

7 Października 2024

Wasp WCS3900 Instrukcja

7 Października 2024

Wasp WDI4600 Instrukcja

7 Października 2024

Wasp WLR8900 Instrukcja

7 Października 2024