Instrukcja obsługi Argox A-2240Z
Argox
drukarka etykiet
A-2240Z
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Argox A-2240Z (47 stron) w kategorii drukarka etykiet. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/47
A SERIE RINTERSP
A-2240, A-2240E, A-2240Z,
A-2240ZE, A-3140, A-3140Z
A-2240M, A-2240ME
User’s Manual
Website: http://www.argox.com
Ribbon & Media Installation video
A Series User’s Manual
2
Introduction
Proprietary Statement
This manual contains proprietary information of Argox Information Co., Ltd. It is
intended solely for the information and use of parties operating and maintaining
the equipment described herein. Such proprietary information may not be used,
reproduced, or disclosed to any other parties for any other purpose without the
expressed written permission of Argox Information Co., Ltd.
Product Improvements
Continuous improvement of products is a policy of Argox Information Co., Ltd. All
specifications and signs are subject to change without notice.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that the interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into a different outlet on a different circuit.
Consult the dealer or an experience Radio/TV technician for help.
This unit was tested with shielded cables on the peripheral devices. Shielded
cables must be used with the unit to insure compliance. The user is cautioned
that any changes or modifications not expressly approved by Argox Information
Co., Ltd. could void the user’s authority to operate the equipment.
Liability Disclaimer
Argox Information Co., Ltd. takes steps to assure that the company’s published
engineering specifications and manuals are correct; however, errors do occur.
Argox Information Co., Ltd. reserves the right to correct any such errors and
disclaims any resulting liability. In no event shall Argox Information Co., Ltd. or
A Series User’s Manual
3
anyone else involved in the creation, production, or delivery of the
accompanying product (including hardware and software) be liable for any
damages whatsoever (including, without limitation, damages for loss of business
profits, business interruption, loss of business information, or other pecuniary
loss) arising out of the use of or the results of use of or inability to use such
product, even if Argox Information Co., Ltd. has been advised of the possibility of
such damages.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Safety
INDUSTRY CANADA NOTICE:
This device complies with Industry Canada ICES-003 class A requirements.
Cet equipement est conforme a ICES-003 classe A de la norm Industrielle
Canadian.
Supplemental Information: This device complies with the
requirement of FCC Part 15 Rules. Operation is subject to the
following two Conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Please only use adapters with the following electrical characteristics and
are certified by current legislation. Using other adapters may damage the
device and void the warranty also cause risks to the user.
Features Output: 24VDC, 2.4A
The manufacturer declares under sole responsibility that this product
conforms to the following standards or other normative documents:
EMC: EN 2010 Class A
EN 55024:2010
A Series User’s Manual
4
Argox Information Co., Ltd certifies that the following products and/or
components are compliant with the current requirements of the European
Union Restriction on the use of Hazardous Substances (RoHS) Directive,
2011/65/EC.
A Series User’s Manual
5
Table of Contents
Introduction................................................................................. 2
Proprietary Statement ............................................................. 2
Product Improvements............................................................ 2
FCC Compliance Statement ................................................... 2
Liability Disclaimer.................................................................. 2
Safety ..................................................................................... 3
Getting Started............................................................................ 7
Unpacking............................................................................... 7
Package Contents............................................................................. 8
Connecting the Power Supply................................................. 9
Getting to Know Your Printer..................................................... 12
Parts and Features ............................................................... 12
Controls and Indicators......................................................... 14
Loading Ribbon and Media....................................................... 16
Loading a Ribbon.................................................................. 16
Loading Media...................................................................... 21
Standard Mode................................................................................21
Peel Off Mode..................................................................................26
Cutter Mode.....................................................................................31
Configuration and Configuration ............................................... 39
Performing Calibration and a Configuration Report............... 39
Resetting Printer to Factory Defaults .................................... 41
Sensor Detection .................................................................. 42
Detection Area of the Transmissive Sensor (edge)......................42
Detection Area of the Transmissive Sensor (centre)....................43
Detection Area of the Reflective Sensor .......................................44
Computer Connections............................................................. 45
USB Interface Requirements ................................................ 45
Serial (RS-232) Interface Requirements ............................... 46
Serial Cabling Requirements ................................................ 46
Ethernet 10/100 Internal Printer Server Option ..................... 48
Communicating with the Printer ................................................ 50
Installing a Plug and Play printer driver (for USB only).......... 51
Installing the Printer Driver.................................................... 58
A Series User’s Manual
6
Troubleshooting ........................................................................70
LED Diagnosis ......................................................................70
Miscellaneous .......................................................................73
Recovery...............................................................................74
Caring for Your Printer...............................................................75
Cleaning................................................................................75
Media Sensor..................................................................................75
Thermal Print Head......................................................................... 75
Replacing Thermal Print Head ..............................................78
Technical Reference.................................................................81
General Specifications ..........................................................81
Fonts, Bar Codes and Graphics Specification .......................84
Printer Programming Language A, PPLA .................................... 84
Printer Programming Language B, PPLB .................................... 85
Printer Programming Language Z, PPLZ..................................... 86
Interface Specifications .........................................................87
USB Interface..................................................................................87
Serial ................................................................................................88
Ethernet ...........................................................................................89
Connection with host ...................................................................... 90
Appendix I - Installing the Extension Card.................................92
Specyfikacje produktu
| Marka: | Argox |
| Kategoria: | drukarka etykiet |
| Model: | A-2240Z |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Argox A-2240Z, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje drukarka etykiet Argox
30 Września 2024
30 Września 2024
30 Września 2024
30 Września 2024
30 Września 2024
30 Września 2024
30 Września 2024
30 Września 2024
30 Września 2024
30 Września 2024
Instrukcje drukarka etykiet
- drukarka etykiet Epson
- drukarka etykiet Toshiba
- drukarka etykiet Casio
- drukarka etykiet Citizen
- drukarka etykiet Brother
- drukarka etykiet Honeywell
- drukarka etykiet Primera
- drukarka etykiet Godex
- drukarka etykiet Olivetti
- drukarka etykiet Zebra
- drukarka etykiet Seiko
- drukarka etykiet Renkforce
- drukarka etykiet Dymo
- drukarka etykiet Panduit
- drukarka etykiet Intermec
- drukarka etykiet Bixolon
- drukarka etykiet Datamax O'Neil
- drukarka etykiet TSC
- drukarka etykiet Brady
- drukarka etykiet Leitz
- drukarka etykiet POSline
- drukarka etykiet Kroy
- drukarka etykiet Metapace
- drukarka etykiet Datacard
- drukarka etykiet Star Micronics
- drukarka etykiet Dascom
- drukarka etykiet DULA
- drukarka etykiet EC Line
- drukarka etykiet Tach-It
- drukarka etykiet Colop
- drukarka etykiet Qoltec
- drukarka etykiet SATO
- drukarka etykiet SII
- drukarka etykiet Start International
- drukarka etykiet Custom
Najnowsze instrukcje dla drukarka etykiet
15 Października 2024
13 Października 2024
11 Października 2024
10 Października 2024
8 Października 2024
8 Października 2024
5 Października 2024
5 Października 2024
5 Października 2024
4 Października 2024