Instrukcja obsługi Andrews Polar Wind Portable

Andrews Klimatyzator Polar Wind Portable

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Andrews Polar Wind Portable (4 stron) w kategorii Klimatyzator. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
Click www.andrews-sykes.com
or Call Us Free 0800 211 611
Polar Wind
Portable Air Conditioning
Operating Instructions
& Safety Guide
Maintenance
Disconnect from the electrical supply before any cleaning or
maintenance.
DO not use chemical solvents to clean the surface of the unit. Use
a clean damp cloth.
Check the filter every week. (fig. 4).
Remove the air filter, the element may be vacuumed clean or
washed in a neutral warm water and detergent mix (40°C).
Rinse and dry the filter before replacing.
Do not dry in direct sunlight.
Laying Up
1.) Clean filter
2.) Clean surfaces
3.) Drain water from the unit
Please note water will drain from the low level water drain (Fig 5) when
the stopper is removed. Run in fan mode until the pipe is dry.
DO NOT DO THIS ON ANY INDOOR FLOOR SURFACES!
4.) When the unit is clean and drained, store in a clean, dry area. Stow cable.
The unit may be covered.
Getting started and operation
Never operate the unit in very hot or cold conditions - it works properly at
temperatures between 17 and 30º C.
Always allow the unit to stand/settle for 15 minutes before switching on when
either setting up or restarting.
Put the mobile air conditioner in a flat location where the air outlets cannot be
covered up. Place the unit no less than 50cm away from a wall or other obstacle
Fit the square end of the exhaust duct to the exhaust terminal of the unit. Fig 1.
Put the other end (discharge) to the nearest window. The length of the air
exhaust between 600mm - 1800mm. Use the min length when working.
When mounting, try to keep the air exhaust horizontal , sloping up or down.
Never operate if the hose is kinked or sagging (fig. 2 & 3).
If mounting through wall, the height of the hole should be 40cm - 130cm.
General Safety
Keep children and animals away from air conditioning units.
Never leave them alone in a room where the units in use.
This equipment should only be used by a competent person who
has read and understood these instructions.
Never operate this equipment if you are ill, feeling tired or under the
influence of alcohol or drugs.
Keep the Air Conditioning vents clear of all obstructions.
Never put anything on top of the unit or block the air outlets.
Make sure equipment is switched off and unplugged after use
Never leave switched on or unattended.
Do not use the unit where sunlight is shining directly onto it.
Check condition of equipment before use. If unit is showing signs of
damage contact your supplier immediately.
Electrical Safety
This unit requires a 230 volt electrical supply. It plugs into a standard BS1363
domestic socket.
Always inspect plugs and leads for damage before plugging into the supply -
DO NOT USE IF ANY DAMAGE IS FOUND
Ensure cables are run as not to cause a hazard.
If an extension lead is used, ensure it is of the correct standard , and fully
uncoiled when being used.
Do not lay electrical cables in wet / damp areas.
Do not move equipment whilst operating.
Do not pull equipment by its cable.
It is recommended that electrical equipment is used via a suitable RCD.
Operating Instructions - Polar Wind
Click www.andrews-sykes.com 0800 211 611or Call Us Free
Dehumidifying and Cooling Operations
1. The operating range for dehumidifying is 10°C-30ºC (50°F-86°F) and the
operating range for cooling operating is 17°C-30°C (63°F-86°F).
2. If the cooling or dehumidifying operations have been switched off and need
switching on again in a short time, allow approximately three minutes for the
cooling or dehumidifying operations to resume.
3. Make sure the water pump drain hose is correctly connected to the unit.
Cooling Operation
1. Operating temperature range: 17ºC-30°C (63°F-86°F)
2. Press the button several times until the indicator light comes on.
3. Press the buttons to select your desired room temperature.
4. Press the button to choose the fan speed.
Dehumidifying Operation
1. Operating temperature range: 13°C-32°C (55°F-90°F)
2. Press the button several times until the indicator light comes on.
3. The fan will run at a fixed speed at this setting.
4. Keep windows and doors dosed for the best dehumidifying effect.
5. Do not put the duct to window.
Fan Operation
1. Press the button several times until the indicator light comes on.
2. Press the button to choose the fan speed.
3. Do not put’the duct to window.
Timer Operation
1. Press the button when the air conditioner is off. Select the time you
need the unit to start to operate.
2. The Operation paned window will display “On”.
3. The starting time is adjustable from 00.00 to 24.
Setting the off timer:
1. Press the button when the air conditioner is on. Select the time you
need the unit to turn off. The Operation Panel Window will display “Off”.
2. The turning off time is adjustable from 0.00 to 24
Water Pump Drainage
Connect the water pump drain hose to the unit before operate. When the water
level of the internal water tank reaches a predetermined level, the water pump will
be activated and drain the condensed water outside through the connected drain
hose. (Under this condition, attach the rubber bung to the back hole to prevent
continuous drainage.) Fig. 4
Continuous Drainage
When you plan to leave this unit unused for a long time, remove the rubber bung
from the back hole and attach a section of the continuous drain hose connector.
All the water In the water tank will drain outside through the drain hose. (Under
this condition, the water pump is not activated). Fig. 5.
DIGITAL DISPLAY
FAN SPEED
Indication lights.
COOL/DRY/FAN indicator
Press this button will choose
high, middle or low speed of air
delivery.
TEMP SETTING buttons
This button sets the present time
and timer.
TIMER ON/OFF buttons
Program the timer on/off function
FAN SPEED button
Indication light.
WATER FULL
Indication light.
ON/OFF button
Pressing this button will turn the
machine on or off.
MODE button
Pressing this button will turn the
machine on or off.
POWER
Indication light.
INFRA RED RECEIVER
Fig.4
Filter
Drain Water pump drain
Fig.5
Fig.1
Fig.3
Fig.2
Operating Controls

Specyfikacje produktu

Marka: Andrews
Kategoria: Klimatyzator
Model: Polar Wind Portable

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Andrews Polar Wind Portable, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Klimatyzator Andrews

Andrews

Andrews PAC 14 Instrukcja

4 Lipca 2024
Andrews

Andrews PAC15 Instrukcja

4 Lipca 2024
Andrews

Andrews Polar Wind Portable Instrukcja

2 Lipca 2024
Andrews

Andrews ET 25 Instrukcja

2 Lipca 2024
Andrews

Andrews Polar Breeze Instrukcja

30 Czerwca 2024
Andrews

Andrews PAC60 Instrukcja

30 Czerwca 2024
Andrews

Andrews M3000 L-C Instrukcja

28 Czerwca 2024

Instrukcje Klimatyzator

Najnowsze instrukcje dla Klimatyzator

Einhell

Einhell BMK 2400E Instrukcja

14 Października 2024
Airwell

Airwell QUATTRO DC Inverter Instrukcja

5 Października 2024
Mobile Airco

Mobile Airco PC35-AMB Instrukcja

5 Października 2024
Haier

Haier AS12GB2HRA Instrukcja

5 Października 2024
SMD

SMD Afstandsbediening Instrukcja

26 Września 2024
Fujitsu

Fujitsu ASYG 30LF Instrukcja

24 Września 2024
Fujitsu

Fujitsu ASYG 07LE Instrukcja

24 Września 2024
Fujitsu

Fujitsu AOT90TP Instrukcja

24 Września 2024
Rowenta

Rowenta AU4010 F0 - Intense Cool Instrukcja

23 Września 2024
Olimpia Splendid

Olimpia Splendid ARYAL S1 E TRIAL INVERTER 21 Instrukcja

23 Września 2024