Instrukcja obsługi 3M PX5

3M Projektory PX5

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla 3M PX5 (95 stron) w kategorii Projektory. Ta instrukcja była pomocna dla 13 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/95

E-1

IMPORTANT

Digital Light Processing, DLP™, Digital Micromirror Device and DMD are all trademarks of Texas

Instruments.

Other names of companies and products mentioned are trademarks and registered trade-marks of

the respective companies. ™, ® and © marks are not used in this document.

Introduction

Congratulations on your purchase of the Projector.3M™ Digital

Please read the USER’S MANUAL (Simplified Edition) and the USER’S MANUAL (CD-

ROM Edition) carefully and use the projector properly. After reading, please store in a safe

place.

Digital Projector

PX5

USER’S MANUAL (Simplified Edition)

E-2

IMPORTANT SAFETY INFORMATION

DECLARATION OF CONFORMITY

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may

not cause harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation.

U.S. Responsible Party:

Address:

Tel. No.:

3M Austin Center

Building A145-5N-01 6801 River Place Blvd.

Austin, TX 78726-9000

800-328-1371

Type of Product:

Equipment Classification:

Models:

Projector

Class B Peripheral

PX5

We hereby declare that the equipment specified above

conforms to the technical standards as specified in the FCC Rules.

DOC compliance Notice

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equip-

ment Regulations.

RF Interference

WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful inter-

ference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorientate or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

E-3

IMPORTANT SAFETY INFORMATION

This symbol warns the user that uninsulated voltage within the unit may have sufficient

magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact

with any part inside of this unit.

This symbol alerts the user that important literature concerning the operation and mainte-

nance of this unit has been included. Therefore, it should be read carefully in order to avoid

ony problems.

The above cautions are given on the bottom of the product.

CAUTION

TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED 3M™ SERVICE PERSONNEL.

Hg: Lamp in This Product Contains Mercury. Dispose of Lamp According to Local, State or Federal Law.

Important Safeguards

These safety instructions are to ensure the long life of the unit and to prevent fire and

shock. Please read them carefully and heed all warnings.

Installation

• For best results, use the unit in a darkened room.

• Place the unit on a flat, level surface in a dry area away from dust and moisture.

• Do not place the unit in direct sunlight, near heaters or heat radiating appliances.

• Exposure to direct sunlight, smoke or steam can harm internal components.

• Handle the unit carefully. Dropping or jarring can damage internal components.

• Do not place heavy objects on top of the unit.

Power Supply

• The unit is designed to operate on a power supply of 100-240 V 50/60 Hz AC. Ensure that your

power supply fits these requirements before attempting to use the unit.

• Handle the power cable carefully and avoid excessive bending. A damaged cord can cause electric

shock or fire.

• Disconnect the power cable (main’s lead) from the power outlet after using the unit.

Before disconnecting the power cable, make sure that the STANDBY indicator lights in amber (not

blinking or in green).

WARNING

TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. DO

NOT USE THIS UNIT’S GROUNDED PLUG WITH AN EXTENSION CORD OR IN AN OUTLET

UNLESS ALL THREE PRONGS CAN BE FULLY INSERTED. DO NOT OPEN THE CABINET.

THERE ARE HIGH-VOLTAGE COMPONENTS INSIDE. ALL SERVICING MUST BE DONE BY

QUALIFIED 3M SERVICE PERSONNEL.

Specyfikacje produktu

Marka:	3M
Kategoria:	Projektory
Model:	PX5
Wysokość produktu:	4.57 mm
Szerokość produktu:	26.92 mm
Głębokość produktu:	6.6 mm
Szerokość opakowania:	13.97 mm
Wysokość opakowania:	11.23 mm
Głębokość opakowania:	506 mm
Ilość na paczkę:	20 szt.
Zakres temperatur (eksploatacja):	0 - 70 °C
Liczba styków:	20
Zakres temperatur (przechowywanie):	-65 - 150 °C
Model:	Logiczny układ scalony
Rodzaj opakowania:	PDIP
Szerokość (z bolcami):	26.92 mm
Głębokość (z bolcami):	10.92 mm
Wysokość (z bolcami):	8.26 mm