Instrukcja obsługi Yamaha Stagepas 600BT

Yamaha system hi-fi Stagepas 600BT

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Yamaha Stagepas 600BT (32 stron) w kategorii system hi-fi. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/32

Owner’s Manual

Mode d’emploi

Manual de instrucciones

EnglishFrançaisEspañol

2STAGEPAS 600BT/STAGEPAS 400BT Owner’s Manual

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions con-

tained in this manual, meets FCC requirements. Modifications not

expressly approved by Yamaha may void your authority, granted by

the FCC, to use the product.

2. IMPORTANT: When connecting this product to accessories and/

or another product use only high quality shielded cables. Cable/s

supplied with this product MUST be used. Follow all installation

instructions. Failure to follow instructions could void your FCC

authorization to use this product in the USA.

3. NOTE: This product has been tested and found to comply with the

requirements listed in FCC Regulations, Part 15 for Class “B” digital

devices. Compliance with these requirements provides a reason-

able level of assurance that your use of this product in a residential

environment will not result in harmful interference with other elec-

tronic devices. This equipment generates/uses radio frequencies

and, if not installed and used according to the instructions found in

the users manual, may cause interference harmful to the operation

of other electronic devices. Compliance with FCC regulations does

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B)

not guarantee that interference will not occur in all installations. If

this product is found to be the source of interference, which can be

determined by turning the unit “OFF” and “ON”, please try to elimi-

nate the problem by using one of the following measures:

Relocate either this product or the device that is being affected by

the interference.

Utilize power outlets that are on different branch (circuit breaker or

fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the

antenna. If the antenna lead-in is 300 ohm ribbon lead, change the

lead-in to co-axial type cable.

If these corrective measures do not produce satisfactory results,

please contact the local retailer authorized to distribute this type of

product. If you can not locate the appropriate retailer, please con-

tact Yamaha Corporation of America, Electronic Service Division,

6600 Orangethorpe Ave, Buena Park, CA90620

The above statements apply ONLY to those products distributed by

Yamaha Corporation of America or its subsidiaries.

FCC INFORMATION (U.S.A.)

* This applies only to products distributed by

YAMAHA CORPORATION OF AMERICA.

(FCC DoC)

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.

이 기기는 가정용(B급) 전자파적합기기로서 주로

가정에서 사용하는 것을 목적으로 하며, 모든

지역에서 사용할 수 있습니다.

(class b korea)

FCC CAUTION

Changes or modifications not expressly approved by

the party responsible for compliance could void the

user’s authority to operate the equipment.

COMPLIANCE INFORMATION STATEMENT

(DECLARATION OF CONFORMITY PROCEDURE)

Responsible Party : Yamaha Corporation of America

Address : 6600 Orangethorpe Ave., Buena Park, Calif. 90620

Telephone : 714-522-9011

Type of Equipment : PORTABLE PA SYSTEM

Model Name : STAGEPAS 600BT, STAGEPAS 400BT

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1) this device may not cause harmful interference, and

2) this device must accept any interference received including interference

that may cause undesired operation.

See user manual instructions if interference to radio reception is sus-

pected.

(fcc_sengen)

English

STAGEPAS 600BT/STAGEPAS 400BT Owner’s Manual 3

PRECAUTIONS

PLEASE READ CAREFULLY

BEFORE PROCEEDING

Please keep this manual in a safe place for

future reference.

WARNING

Always follow the basic precautions listed below to

avoid the possibility of serious injury or even death

from electrical shock, short-circuiting, damages, fire

or other hazards. These precautions include, but are

not limited to, the following:

Power supply/power cord

• Do not place the power cord near heat sources such as

heaters or radiators, and do not excessively bend or

otherwise damage the cord, place heavy objects on it, or

place it in a position where anyone could walk on, trip

over, or roll anything over it.

• Only use the voltage specified as correct for the mixer.

The required voltage is printed on the name plate of the

mixer.

• Use only the supplied power cord.

If you intend to use the device in an area other than in the

one you purchased, the included power cord may not be

compatible. Please check with your Yamaha dealer.

• Check the electric plug periodically and remove any dirt

or dust which may have accumulated on it.

• When setting up the device, make sure that the AC outlet

you are using is easily accessible. If some trouble or

malfunction occurs, immediately turn off the power switch

and disconnect the plug from the outlet. Even when the

power switch is turned off, as long as the power cord is

not unplugged from the wall AC outlet, the device will not

be disconnected from the power source.

• Remove the electric plug from the outlet when the device

is not to be used for extended periods of time, or during

electrical storms.

• Be sure to connect to an appropriate outlet with a

protective grounding connection.

Do not open

• This device contains no user-serviceable parts. Do not

open the device or attempt to disassemble the internal

parts or modify them in any way. If it should appear to be

malfunctioning, discontinue use immediately and have it

inspected by qualified Yamaha service personnel.

Water warning

• Do not expose the device to rain, use it near water or in

damp or wet conditions, or place on it any containers

(such as vases, bottles or glasses) containing liquids

which might spill into any openings. If any liquid such as

water seeps into the device, turn off the power

immediately and unplug the power cord from the AC

outlet. Then have the device inspected by qualified

Yamaha service personnel.

• Never insert or remove an electric plug with wet hands.

Hearing loss

• Avoid setting all equalizer controls and level controls to

their maximum. Depending on the condition of the

connected devices, doing so may result in feedback that

can cause hearing loss and damage the speakers.

• Before connecting the device to other devices, turn off the

power for all devices. Also, before turning the power of all

devices on or off, make sure that all volume levels are set

to the minimum. Failing to do so may result in hearing loss,

electric shock, or device damage.

• When turning on the AC power in your audio system,

always turn on the device LAST, to avoid hearing loss and

speaker damage. When turning the power off, the device

should be turned off FIRST for the same reason.

Fire warning

• Do not place any burning items or open flames near the

device, since they may cause a fire.

Wireless unit

• Do not use this device near medical devices or inside

medical facilities. Radio waves from this device may affect

electro-medical devices.

• Do not use this device within 15 cm (6 in) of persons with

a heart pacemaker implant or a defibrillator implant. Radio

waves from this device may affect electro-medical

devices, such as a heart pacemaker implant or

defibrillator implant.

If you notice any abnormality

• If any of the following problems occur, immediately turn off

the power switch and disconnect the electric plug from

the outlet.

- The power cord or plug becomes frayed or damaged.

- Unusual smells or smoke are emitted.

- Some object has been dropped into the device.

- There is a sudden loss of sound during use of the

device.

- Cracks or other visible damage appear on the device.

Then have the device inspected or repaired by qualified

Yamaha service personnel.

• If this device should be dropped or damaged,

immediately turn off the power switch, disconnect the

electric plug from the outlet, and have the device

inspected by qualified Yamaha service personnel.

Specyfikacje produktu

Marka:	Yamaha
Kategoria:	system hi-fi
Model:	Stagepas 600BT

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Yamaha Stagepas 600BT, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje system hi-fi Yamaha

Yamaha MusicCast SRT-1500 Instrukcja

7 Października 2024

Yamaha R-N1000A Instrukcja

22 Września 2024

Yamaha MusicCast NP-S303 Instrukcja

22 Września 2024

Yamaha R-N800A Instrukcja

22 Września 2024

Yamaha CRX-E300 Instrukcja

29 Sierpnia 2024

Yamaha Stagepas 600BT Instrukcja

21 Sierpnia 2024

Yamaha MCR-B043DAB Instrukcja

8 Sierpnia 2024

Yamaha AV-1 Instrukcja

4 Lipca 2024

Yamaha PianoCraft E-410 Instrukcja

3 Lipca 2024

Instrukcje system hi-fi

Najnowsze instrukcje dla system hi-fi

AKAI EIE Pro Instrukcja

13 Października 2024

Sharp XL-540H Instrukcja

11 Października 2024

Kenwood M-9000S Instrukcja

10 Października 2024

GoGen MSC 472 BTDAB Instrukcja

9 Października 2024

Morel SUB-10X Instrukcja

9 Października 2024

Morel USUB 803 Instrukcja

9 Października 2024

Morel Soundsub PSW8e-w Instrukcja

9 Października 2024

Morel Sopran 934 Instrukcja

9 Października 2024

NAD M10 V3 Instrukcja

9 Października 2024

NUVO NV-MPS4-E Instrukcja

8 Października 2024