Instrukcja obsługi Whirlpool AKR 021/IX

Whirlpool piekarnik AKR 021/IX

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Whirlpool AKR 021/IX (9 stron) w kategorii piekarnik. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/9

INSTRUCTIONS FOR USE

BEFORE USING THE HOB

INSTALLATION - TECHNICAL INFORMATION FOR THE

INSTALLER

ELECTRICAL CONNECTION

ENERGY SAVING TIPS

PROTECTING THE ENVIRONMENT

DECLARATION OF CONFORMITY CE

PRECAUTIONS AND GENERAL RECOMMENDATIONS

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

AFTER SALES SERVICE

3gb66016.fm Page 13 Monday, August 19, 2002 11:59 AM

BEFORE USING THE HOB

• To make the most of your new appliance,

please read the user instructions carefully and

keep them handy for future consultation.

INSTALLATION - TECHNICAL INFORMATION FOR THE

INSTALLER

•Make sure that the appliance is installed and connected to an

electrical outlet and gas supply by a qualiﬁed technician, in

accordance with the manufacturer’s instructions and in

compliance with local regulations.

•Before installation, make sure that the setting of this

appliance is compatible with local gas and pressure

conditions. The adjustment conditions of this appliance are

stated on the rating plate or on the label.

•The appliance must be switched off before any maintenance.

Before installation, please read the following:

•The cooktop must be installed into a countertop 20 to 40 mm

thick and 600 mm deep.

•Inside the unit there must be a space of at least 30 mm

between the bottom of the cooktop and the top of an

appliance or bracket.

•If the cooktop is to be installed next to a column unit, leave

a distance of at least 100 mm.

•There must be a distance of at least 50 mm between the cooktop

and the wall.

•If a hood or cupboard is installed above the cooktop, leave a

minimum distance of 650 mm.

•The coatings of the walls of the unit or appliances near the

cooktop must be heat resistant.

•Do not install the cooktop near ﬂammable materials

(e.g., curtains).

Location of the appliance

The appliance should be installed where there is enough air

for the correct gas combustion (2 m3/h x kW).

• The installer must refer to national standards concerning

ventilation and removal of combustion products.

•There must be a natural airﬂow through one or more

openings, which must be:

- Permanent and made in the outside walls of the room to be

ventilated.

- Made so that the opening outlets, both inside and outside the

wall, cannot be obstructed.

- Protected with grids, metal grill, etc., so as not to reduce the

installation distances indicated above.

- Situated next to ﬂoor level so as not to impede the correct

operation of the combustion products removal devices.

When these openings cannot be made, the necessary air must

come from an adjacent room, ventilated as required, as long as

it is not a bedroom or a dangerous space. In this case the

kitchen door must allow the passage of air.

3gb66016.fm Page 14 Monday, August 19, 2002 11:59 AM

INSTALLATION - TECHNICAL INFORMATION FOR THE

INSTALLER

Discharge of combustion products

The combustion products of gas appliances must be discharged

through hoods connected directly to the outside.

When this is not possible, an electric fan can be used, attached to

the outside wall or to the window, The fan must be able to ensure

an hourly exchange of air 3-5 times the volume of the kitchen.

The fan can only be installed if there are suitable openings for

the air inlet.

Installation

- Remove the protective film from the cooktop.

- Cut an opening in the countertop to the dimensions shown in

the Product Description Sheet supplied separately.

- Stretch gasket (C) over the edge of the opening being careful

to overlay the junction edges.

- Turn the cooktop upside down and put tabs (A) into the seats

provided, tightening screws (B).

Please make sure that the tabs are correctly positioned as

illustrated.

- Position the cooktop into the housing.

- Put tabs (A) into place; tooth (D) of the tabs should ﬁt into

the hole.

- Tighten screw (B) until the cooktop is completely secured.

Installing two cooktops side by side

To install two cooktops side by side (see ﬁgure), use the special

kit (code N° AMH 719) available from the After-Sales Service:

- Cut an opening in the countertop, as illustrated in the ﬁgure.

- Please observe the installation instructions for a single

installation.

- A 5 mm space must be left between the cooktops to fit the

junction piece.

- For installations with more than 3 cooktops side-by side,

calculate the hole needed, referring to the dimensions shown

in ﬁgure.

- Each cooktop must have its own gas/electrical supply.

2 DOMINO side-by-side

3 DOMINO side-by-side

3gb66016.fm Page 15 Monday, August 19, 2002 11:59 AM

Specyfikacje produktu

Marka:	Whirlpool
Kategoria:	piekarnik
Model:	AKR 021/IX
Kolor produktu:	Biały
Liczba źródeł światła:	1 szt.
Rodzaj żarówki:	Halogen
Wysokość produktu:	- mm
Szerokość produktu:	- mm
Głębokość produktu:	- mm
Ilość na paczkę:	1 szt.
Lampy:	400 W
Kolor światła:	Biały
Model:	Oświetlenie zewnętrzne ścienne
Stopień ochrony IP:	IP44
Zdalnie sterowany:	Nie
Cechy zabiezpieczeń:	Nie
Moc w sumie:	- W
Strumień świetlny:	8545 lm
Lampa reflektorowa:	R7s
Kolor szkła:	Przezroczysty
Zintegrowane czujniki:	Czujnik ruchu
Nadaje się do użytku na zewnątrz:	Ogród