Instrukcja obsługi Whirlpool ADG 9527/2

Whirlpool zmywarka ADG 9527/2

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Whirlpool ADG 9527/2 (8 stron) w kategorii zmywarka. Ta instrukcja była pomocna dla 22 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/8

Whirlpool is a registered trademark of Whirlpool USA

Before using the dishwasher, read the

installation and maintenance instructions carefully!

5019 396 01158

ADG 9527

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads,

extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN

comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

1. OVERVIEW

ON button

OFF button

Programme selection button

Press button P (repeatedly) until the required

programme number appears on the display.

Fault indication and wash time display

In normal operation it indicates the remaining time

(h:mm), whereas with “Delayed start” selected it

indicates the time remaining until programme start (hh).

In the presence of a fault indication “F..” –, consult the

section “5. What to do if…”.

An acoustic signal sounds as long as the error persists.

Rinse aid level indicator and salt level indicator

They light up when rinse aid or salt need to be added.

Add just before starting a wash cycle.

Set the detergent

Press button P (repeatedly) to set the type of detergent used.

This deactivates the rinse aid and/or salt indicator.

Half Load/Multizone button

Load the upper or lower rack only.

Press once = wash upper rack (the indicator/symbol lights up)

Press twice = wash lower rack (the indicator/symbol lights up)

Press 3 times = Off (Half load/Multizone deactivated).

When washing without the upper rack, press the “Half

load” (i.e. “wash bottom rack”) button twice (the

corresponding indicator/symbol lights up).

Powder, gel, tablets (standard): indicator off

Detergent with rinse aid: left indicator

Detergent with salt + rinse aid: right indicator

Antibacterial rinse 3)

This function activates an antibacterial rinse at the end of

the wash cycle, guaranteeing a further reduction of

bacteria. Press the button to activate or deactivate the

function. This function can be used with those

programmes marked with the relative symbol in table 1.1.

The dishwasher door must be kept shut for the entire

duration of the programme in order to guarantee

reduction of bacteria. If the door is opened the indicator

lamp starts flashing.

“Delayed start” button

Press the button (repeatedly) to delay the start of the

programme. Adjustable from 1 to 24 hours. With each

press of the button, the delayed start indicator increases by

one hour and after 24 restarts from 00. Then press the

START button. The dishwasher will start after the set time.

START button

The indicator lights up during operation, flashes when a

fault occurs, and goes off at the end of the programme.

RESET button - for programme change or indication of

faults

Press this button to cancel a started programme and

selected extra functions. Press this button to cancel the

main fault indicators (F..); also refer to the section “5.

What to do if...”. The programme can then be selected

and started.

Running programme indicator

A LED light projected on the floor indicates that the

dishwasher is working.

Table 1.1.

Table of programmes Detergent

dispenser Consumption 1)

PProgrammes

Selectable

extra

functions Loading instructions large small Litres kWh Minutes

1Auto Sensor 50-65°C

Automatic programme

recommended for routine washes,

with dried-on or burnt food (for

example EN 50242).

X X 11-16 1.10-1.50 100-130 ±1)

2Pre-Rinse cold Crockery to be washed later. — — 4.0 0.03 14 ± 1)

3Quickwash 40°C Slightly soiled crockery, without dry

residuals. X — 10.0 0.65 30 ± 1)

4Bio 2) 50°C Normally soiled crockery. Energy-

saving programme. X X 11.0 1.05 155 ± 1)

5Intensive 70°C Recommended programme for

heavily soiled crockery, especially

suitable for pans and saucepans. X X 14.0 1.55 155 ± 1)

2. QUICK REFERENCE GUIDE

Detailed instructions are given in the following pages, see also chapter “5. What to do if...”

1. Switch on the

appliance

Open the dishwasher door.

Press the ON button.

2. Select a programme Press the button or to bring up the desired programme on the display.

Select options, if available.

3. Select the type of

detergent

The detergent selection procedure varies depending on the dishwasher model.

Chapter “1. Overview” provides instructions for selecting detergent type.

4. Fill in the detergent 4a. Powder/gel/tabs

Fill the detergent dispenser compartments in

accordance with the wash programme selected.

Large compartment A for every wash cycle, additional

small compartment B for programmes with pre-wash

(see table 1.1.).

4b. Combined action detergents (2 in 1/3 in 1/... etc.)

Place the detergent in compartment A, as per the

manufacturer's recommendations.

5. Check the rinse aid

level

6. Check the salt level Depending on the model:

7. Load the racks

Make sure that the spray arms can turn freely and are not impeded by crockery

or cutlery in the racks.

Detailed instructions on loading the racks are given in chapter “3. How to use

the appliance”, under “How to load the racks”.

8. Start the appliance Press the START button.

9. Turn on the water

tap and close the

dishwasher door

When the door is closed the dishwasher

starts automatically.

Wash cycle

If the appliance is switched off during a

wash cycle, when switched on again it will

resume the cycle from where it was

interrupted. Care must be taken when

opening the door, as steam will escape!

10.End of programme At the end of the programme an acoustic signal will sound.

The START indicator lamp switches off.

11.Open the door,

switch off the

appliance

Press the OFF button. All the indicator lamps switch off.

12. Turn off the water

tap, unload the racks

Unload the appliance, starting from the lower rack in order to avoid any

residual drips of water falling onto crockery below.

A CB

Visual indicator in dispenser C

dark ➯sufficient rinse aid present,

clear ➯add rinse aid (approx. 150 ml).

The indicator lamp on the control panel lights up when rinse aid

needs to be added. Not all models are equipped with such an

indicator.

window in salt reservoir cap on bottom of appliance inside

orange ➯when sufficient salt is present,

clear ➯when salt needs to be added.

The indicator lamp on the control panel lights up when salt needs

to be added. Even once salt has been added, the indicator lamp

only switches off after several wash cycles!

Change the programme in

progress:

- Press the RESET button.

- Close the door.

- (Water drains for up to 60 seconds).

- Open the door.

- Select a new programme.

- Press the START button.

3. HOW TO USE THE APPLIANCE

PROGRAMME SELECTION

Press the button or to bring up the desired programme on the display. The appliance must be switched

on. If required, select options (if supplied). The corresponding indicator lamp switches on. Appropriate

programmes and relative available options are detailed in table 1.1 on page 1.

Programme times stated in the table were obtained under normal conditions and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes

as a result of the appliance's automatic calibration system.

HOW TO FILL THE DETERGENT DISPENSER

Only fill the detergent dispenser prior to starting a wash programme. Only use detergents

specially recommended for dishwashers, observing the manufacturer's recommended dosage.

Observe the manufacturer's safety warnings!

Open the detergent dispenser compartments by pushing the left button (button 1) of the dispenser.

a. Powder/gel/tabs

Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).

Programmes without pre-wash:

pour the entire recommended dosage into compartment A.

Programmes with pre-wash:

pour 2/3 of the recommended dosage into the large compartment

A and 1/3 into the small compartment B.

Dishwasher tabs should be placed, according to the

manufacturer's recommendations, in compartment A.

If the “Half load” option is selected, detergent dosage should be

reduced by approximately 1/3.

b. Combined action detergents (2 in 1/3 in 1/... etc.)

Combined action detergents should be placed, according to the

manufacturer's recommendations, in compartment A.

Firmly close and press the detergent compartment lid shut after filling.

Detergents with rinse aid incorporated may be effective only with longer programmes. In the

case of shorter programmes, detergent residue may be a problem (if necessary, use powder

detergent). Detergents with rinse aid incorporated tend to form excess suds.

The guarantee is not applicable if faults are caused by the use of these products.

HOW TO CHECK/FILL/ADJUST RINSE AID

Not necessary when using a combined action detergent.

a. How to check the rinse aid level

Check the visual indicator C on the rinse aid dispenser: dark = su ear = add rinse aid.fficient rinse aid, cl

In the case of appliances with an electric indicator on the

control panel, the rinse aid indicator lamp lights up red

when rinse aid needs to be added.

b. How to fill the rinse aid dispenser

Open the rinse aid dispenser by pressing the right button

(button 2) of the dispenser.

Fill the dispenser with rinse aid up to the “max” line

(approx. 150 ml).

Shut the lid again.

Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away

any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault

function of the appliance.

button 1

Large

compartment A

Small

compartment B

button 2

Indicator C

max

Specyfikacje produktu

Marka:	Whirlpool
Kategoria:	zmywarka
Model:	ADG 9527/2
Położenie urządzenia:	W pełni wbudowany
Częstotliwość wejściowa AC:	50 Hz
Napięcie wejściowe AC:	220 - 230 V
Wysokość produktu:	820 mm
Szerokość produktu:	597 mm
Głębokość produktu:	555 mm
Waga produktu:	50000 g
Kolor drzwiczek:	Nie dotyczy
Kolor panelu sterowania:	Stal nierdzewna
Głębokość przy otwartych drzwiach:	1150 mm
Liczba miejsc:	12 komplet.
Ilość programów piorących:	5
Poziom hałasu:	48 dB
Czas cyklu:	155 min
Obciążenie:	2200 W
Pobór wody na cykl:	11 l
Zużycie energii na cykl:	1.05 kWh
Klasa efektywności energetycznej (stara):	A
Kategoria prania:	A
Kategoria suszenia:	A