Instrukcja obsługi Viewsonic PJ-WMK-305

Viewsonic nieskategoryzowany PJ-WMK-305

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Viewsonic PJ-WMK-305 (2 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

PJ-WMK-305

Quick Start Guide

中国

http://www.viewsonic.com.cn

电话：4008 988 188

香港

http://www.hk.viewsonic.com

電話：852 3102 2900

澳門

http://www.hk.viewsonic.com

電話：853 2833 8407

台灣

http://www.viewsonic.com.tw

電話：0800 899 880

한국

http://ap.viewsonic.com/kr/

Phone: 080 333 2131

Singapore/Malaysia/Thailand

http://www.viewsonic.com.sg

Phone: 65 6461 6044

India

http://www.in.viewsonic.com

Phone: 1800-419-0959

United States

http://www.viewsonic.com

Phone: 1-800-688-6688

Canada

http://www.viewsonic.com

Phone: 1-866-463-4775

Europe

http://www.viewsoniceurope.com

http://www.viewsoniceurope.com/uk/support/call-desk/

Australia/New Zealand

http://www.viewsonic.com.au

Phone: 1800 880 818 (AUS)

0800 008 822 (NZ)

South Africa

http://ap.viewsonic.com/za/

Latin America (Chile)

http://www.viewsonic.com/la/

http://www.viewsonic.com/la/soporte/servicio-tecnico

Latin America (Mexico)

http://www.viewsonic.com/la/

http://www.viewsonic.com/la/soporte/servicio-tecnico

Latin America (Peru)

http://www.viewsonic.com/la/

http://www.viewsonic.com/la/soporte/servicio-tecnico

Latin America (Argentina)

http://www.viewsonic.com/la/

http://www.viewsonic.com/la/soporte/servicio-tecnico

Puerto Rico & Virgin Islands

http://www.viewsonic.com

Phone: 1-800-688-6688 (English)

http://www.viewsonic.com/la/soporte/servicio-tecnico

PJ-WMK-305_QSG_Rev. 1a 01-14-21

Copyright © 2021 ViewSonic Corporation. All rights reserved.

Checking The Supplied Accessories

Setting The Projector Wall Mount On The Wall

• If the board has been installed, please align the center line of the projector lens on the

installation chart with that of the screen or board to the locate the place of the mount period.

• For concrete wall mounting, thickness of the wall must be not less than 4'' (100mm). Anchor

bolt and screw (M6x55) are needed to be used for concrete wall installation.

• For Dry-wall mounting, thickness of the dry-wall must be not less than 4.5" (114mm). Only

screw (M6x55) is needed to be used for installation, and gypsum board thickness less than

0.59" (15mm).

Note: If the thickness of wall is not strong enough, reinforce it sufﬁciently before installation.

Note: To make adjustments to meet your demands, screws must be loosened in a

speciﬁc order, as shown in the above figure. (When the length of inside arm

895mm do not meet your demands, then you should loose the screws on the

outside arm to adjust the middle arm. Under this circumstance, the number

read on the middle arm is correct).

Adjusting The Image Height Adjusting The Horizontal Rotation

Adjusting The Vertical Tilt Placing The Decorative Cover

Note: When all adjustments are done, the wall plate covers can be used to cover the

blank area on the top of wall plate. The number of wall plate cover used

depends on the size of blank area. But the wall cover must be used in an

speciﬁc order as the picture on left shows. Finally, put the wall cover on.

1

2

3

4

6

58

9

Adjusting The Horizontal Roll

7

Fixed Support Arm x1

Projector Mounting

Plate x 1

Wall Plate x 1 Wall Cover x 1

Projector Mounting

Arms x4 Wall Plate Cover x 1

Concrete wall mounting

take off the cover

loosen the screw

• Insert Screw A (M6x55) from the ﬁxing kit, tighten with a L5 Allen Key from ﬁxing kit.

a. Use the extend arm

b. Install the Projector Mounting Plate to the Projector

• Insert Screw F(M6x15) from the ﬁxing kit, tighten with a L5 Allen Key from ﬁxing kit.

Dry-wall mountingWith anchor bolt Without anchor bolt

Installing The Projector On The Projector Wall Mount

Screen Adjustment Direction

Adjusting The image horizontally

Adjusting The Image Size

Fixing Kit

The arrows up

The arrows up

When installation on the

wood stud wall, Align the

center of the wall mount

plate with the center of

the stud.

Loosen the screws with L3 allen wrench,

pull out the support arm around 4''

(100mm)and make power cable & signal

cables go through the support arm.

The cables can go through the wall plate

by three ways as shown in the pictures.

Then, tighten the screw F after locating

the projector position.

Screen Adjustment Direction

Connect power cable and other signal cable to the projectorTighten the screws

Power cable

Signal cable

Product Information

15 lb (6.8 kg)

PJ-WMK-305

Model

Net Weight

Weight Capacity

Extendable Length

Adjustment Angle

22 lb (10.0 kg)

19"-49" (495-1250mm)

Vertical tilt, Horizontal roll, Horizontal rotation ±5°

Important Safety Informa�on

1.

2. For safety reasons, please make sure the wall is strong enough to sustain the weight of the

projector & wall mount.

3. The total maximum weight of all items mounted should NEVER exceed the weight capacity: 55 lbs

(25kg).

4. 

5.

chance of impact.

6. 

excessively dusty place.

7. Use the supplied accessories only. Use of accessories other than those supplied may result in

damage to the projector and/or projector wall mount.

8. Unplug the AC power cord and any other connected cables before dismounting the projector from

the projector wall mount.

9. Do not hit or hang any heavy objects on the projector wall mount. If the projector wall mount is

damaged, stop using immediately and contact a qualified service personnel immediately.

10. Only install the projector wall mount horizontally on the level surfaces.

* The manufacturer is not liable for any damages or injury caused by mishandling or improper

installa�on.

11. The projector or wall mount may fall and cause personal injury. Ensure screws are tightened to the

proper torque after installation and any adjustments. Do not overtighten screws as this may cause

screw deformation.

12. This wall mount kit ONLY supports ViewSonic® projectors and models that are designated by

ViewSonic. Use with non-ViewSonic branded projectors or exceeding the weight capacity is

neither supported nor recommended, may cause property damage or personal injury, and shall be

at the sole risk of users/installers.

E (M4x10)

E (M4x10)

Use

Connecting

screws G

M4

M4

Bulging

Flat

Screw E & G Tightening torque:

8kgf-cm ( 12kgf-cm)≦

Screw hole

on projector

Screw hole

on projector

Extend Arm

No need

Connecting

screw G

Specyfikacje produktu

Marka:	Viewsonic
Kategoria:	nieskategoryzowany
Model:	PJ-WMK-305
Kolor produktu:	Biały
Kod zharmonizowanego systemu (HS):	83024190
Maksymalna waga:	15 kg
Typ mocowania:	Ściana
Obsługiwane produkty:	PJD5353LS, PJD5553LWS, PJD6352LS, PJD6552LWS, PS501X, PS501W, PS600X, PS600W, LS620X, PX706HD
Dystans do ściany (max.):	1270 mm
Dystans do ściany (min.):	660 mm
Teleskopowy:	Tak
Regulowane ramię:	Tak

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Viewsonic PJ-WMK-305, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje nieskategoryzowany Viewsonic

Viewsonic VPC12-WPO-17 Instrukcja

21 Sierpnia 2024

Viewsonic PGD-250 Instrukcja

4 Lipca 2024

Viewsonic VPC16-WP-4 Instrukcja

19 Maja 2024

Viewsonic LDM163-182 Instrukcja

16 Maja 2024

Viewsonic SW-094-2 Instrukcja

15 Maja 2024

Viewsonic SW-092-2 Instrukcja

11 Maja 2024

Viewsonic VPC12-WPO-16 Instrukcja

8 Maja 2024

Viewsonic SW-091-3 Instrukcja

6 Maja 2024

Viewsonic VB-WIFI-001 Instrukcja

5 Maja 2024

Viewsonic SW-092-3 Instrukcja

5 Maja 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Asko DBI644MIB.S.TW/1 Instrukcja

28 Października 2024

Asko DFS233IB.S.TW/1 Instrukcja

28 Października 2024

Emko EZM-9920 Instrukcja

27 Października 2024

Emko ESM-3712-H Instrukcja

27 Października 2024

Emko ATS-10 Instrukcja

27 Października 2024

Emko EAOM-11.2 Instrukcja

27 Października 2024

Emko EPM-3790 Instrukcja

27 Października 2024

Emko EPM-7790 Instrukcja

27 Października 2024

Livarno Lux IAN 108340 Instrukcja

27 Października 2024

Livarno Lux HG06009A-BS Instrukcja

27 Października 2024