Instrukcja obsługi Uniden TCX 860

Uniden telefon TCX 860

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Uniden TCX 860 (8 stron) w kategorii telefon. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/8
TCX 860
Acc e sso ry Ha ndse t
OWNE R'S
MANUAL
– – 2
Welcome
Congratulations on your purchase of the Uniden TCX860 optional
handset and charger. This expansion handset is for use with the Two
Line Digital Expandable TRU8866 series (model numbers may vary).
Each model within this series will support up to ten handsets. It
functions as a 2-line telephone system if you subscribe to two phone
lines. You can place a fully featured cordless handset anywhere in your
home as long as you have AC power is available to connect the handset
charging cradle.
IMPORTANT
The TCX860 expansion handset will not operate unless it has been
registered to your main base. This manual describes how to set up and
connect your new handset; for instructions on operating your new
handset, refer to the owner's manual supplied with your main base.
To purchase expansion handsets (TCX860), visit our web site at
www.uniden.com.
Checking the Package Contents
Make sure you have received the following items in the package.
If any of these items are missing or damaged, contact the Uniden
Parts Department.
Cordless Handset
Charging Cradle
Battery Pack (BT-446)
(Capacity: 800 mAH, 3.6V)
AC Adapter (AD-0005)
(INPUT: 120V AC 60Hz) (OUTPUT: 9V DC 210 mA)
• Beltclip
This Owner’s Manual
Other Printed Material
Uniden Parts Department at (800) 554-3988
Hours: M-F 8:00 a.m. to 5:00 p.m. CST.
or visit our website at
www.uniden.com
– – 3
Installing Your Expansion Handset
Follow these three easy steps to get your new handset ready to use:
1Install the battery pack.
2Connect the charger and charge your new handset for 15-20 hours.
3Register your new handset to the main base.
Step 1: Install the Battery Pack
1Press down on the handset battery
case cover (use the finger indention
for a better grip) and slide the cover
downward to remove.
2Plug the battery pack connector
(red & black wires) into the jack
inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the polarity
label in the battery compartment, and
push the connector in until you hear
a click.
3Make sure you have a good connection
by slightly pulling on the battery
wires. If the connection is secure, the
battery jack will remain in place.
4Place the battery case cover back on
the handset by sliding it upwards
until it clicks into place.
5Place the handset in the charging
cradle with the keypad facing
forward.
Use only the Uniden battery (BT-446)
supplied with your phone.
Replacement batteries are also available
through the Uniden Parts Department. (See
page 2.)
Recharge your handset on a regular basis by
returning the handset to the charger after each
phone call.
Rechargeable Nickel-Metal-Hydride Batteries
Must Be Recycled or Disposed of Properly


Specyfikacje produktu

Marka: Uniden
Kategoria: telefon
Model: TCX 860

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Uniden TCX 860, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje telefon Uniden

Uniden

Uniden XS 1415 Instrukcja

13 Października 2024
Uniden

Uniden XDECT 6105BTU Instrukcja

10 Października 2024
Uniden

Uniden SSE P1 Instrukcja

2 Października 2024
Uniden

Uniden D1880 Instrukcja

27 Września 2024
Uniden

Uniden EXI 7960 Instrukcja

20 Września 2024
Uniden

Uniden EZAI 2997 Instrukcja

19 Września 2024
Uniden

Uniden WDECT 2316 Instrukcja

19 Września 2024
Uniden

Uniden WDECT 2355 Instrukcja

18 Września 2024
Uniden

Uniden EXI 4561 Instrukcja

17 Września 2024
Uniden

Uniden XC 610 Instrukcja

17 Września 2024

Instrukcje telefon

Najnowsze instrukcje dla telefon