Instrukcja obsługi Tripp Lite OMNIVSX850D

Tripp Lite UPS OMNIVSX850D

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Tripp Lite OMNIVSX850D (56 stron) w kategorii UPS. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/56

UPS Systems

Models:

OMNIVSX850, OMNIVSX850D, OMNIVSX1000,

OMNIVSX1000D, OMNIVSX1500, OMNIVSX1500D

(Series Numbers: AG-02FC, AG-02F5, AG-87E4, AG-02FD, AG-87E6, AG-02FE)

Owner’s Manual

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

Español 12 • Français 23 • Русский 34 • Deutsch 45

18-07-252-93388F.indb 1 10/3/2018 10:10:23 AM

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that should be followed during the

installation, operation and storage of this product. Failure to heed these warnings may

affect the warranty.

UPS Location Warnings

• Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust or

direct sunlight.

• For best performance, keep the indoor temperature between 32º F and 104º F

(0º C and 40º C).

• Leave adequate space around all sides of the UPS for proper ventilation.

• Only set the UPS upright on a sturdy ﬂat surface. Do not block fans or ventilation holes, as this will

seriously inhibit the unit's internal cooling and cause product damage not covered under warranty.

UPS Connection Warnings

• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the UPS into itself;

this will damage the UPS.

• Do not modify the UPS plug, and do not use an adapter that would eliminate the UPS ground

connection.

• Do not use extension cords to connect the UPS to an AC outlet.

• If the UPS receives power from a motor-powered AC generator, the generator must provide clean,

ﬁltered, computer-grade output.

• The mains socket outlet that supplies the UPS should be easily accessible and located near the

UPS.

Equipment Connection Warnings

Short Circuit backup protection and overcurrent protection is provided by the

building installation.

To reduce the risk of ﬁre, connect only to a circuit provided branch circuit

overcurrent protection. The plug on the power supply cord is intended to serve

as the disconnect device. Be sure the socket-outlet is installed near the

equipment and is made easily accessible.

• Use of this equipment in life support applications where failure of this equipment can reasonably

be expected to cause the failure of the life support equipment or to signiﬁcantly affect its safety or

effectiveness is not recommended.

• Do not connect surge protectors or extension cords to the output of your UPS. This might damage

the UPS and may affect the surge protector and UPS warranties.

• Connect the UPS to an outlet that is adequately protected against excess currents, short circuits

and earth faults as part of the building installation.

Important Safety Instructions

18-07-252-93388F.indb 2 10/3/2018 10:10:23 AM

Important Safety Instructions

Battery Warnings

• Batteries can present a risk of electrical shock and burn from high short-circuit current. Observe

proper precautions. Do not dispose of the batteries in a ﬁre. Do not open the UPS or batteries.

Do not short or bridge the battery terminals with any object. Unplug and turn off the UPS before

performing battery replacement. Use tools with insulated handles. There are no user-serviceable

parts inside the UPS. Battery replacement should be performed only by authorized service

personnel using the same number and type of batteries (Sealed Lead-Acid).

The batteries are recyclable. Refer to your local codes for disposal requirements or visit

http://www.tripplite.com/support/recycling-program for recycling information. Tripp Lite offers a

complete line of UPS System Replacement Battery Cartridges (R.B.C.).Visit Tripp Lite on the

Web at http://www.tripplite.com/products/battery-ﬁnder/ to locate the speciﬁc replacement

battery for your UPS.

CAUTION: A battery can present a risk of electrical shock and high short-circuit

current. Contact with any part of a grounded battery can result in electrical shock.

The following precautions should be observed when working on batteries:

• Remove watches, rings or other metal objects.

• Use tools with insulated handles.

• Wear rubber gloves and boots.

• Do not lay tools or metal parts on top of batteries.

• Disconnect the charging source and load prior to installing or maintaining the battery.

• Remove battery grounds during installation and maintenance to reduce likelihood of

shock.

• Remove the connection from ground if any part of the battery is determined to be

grounded.

• Unplug the UPS from the AC mains receptacle. Disconnect all cables, including the

equipment plugged into the UPS.

• Servicing of batteries should be performed or supervised by personnel knowledgeable

about batteries and required precautions.

• When replacing batteries, replace with the same type and number of batteries or battery

packs.

• CAUTION: Do not dispose of batteries in a ﬁre. The batteries may explode.

• CAUTION: Do not open or mutilate batteries. Released electrolyte is harmful to the skin

and eyes. It may be toxic.

UPS and Battery Recycling

Tripp Lite products use sealed lead-acid batteries, which are highly recyclable.

Call Tripp Lite at 1.773.869.1234 or visit www.tripplite.com/support/recycling-program for

more information on recycling the batteries or any other Tripp Lite product. Please refer to

local codes for disposal requirements.

18-07-252-93388F.indb 3 10/3/2018 10:10:23 AM

Specyfikacje produktu

Marka:	Tripp Lite
Kategoria:	UPS
Model:	OMNIVSX850D
Kolor produktu:	Czarny
Rodzaj zasilania:	Bateria
Wysokość produktu:	97.3 mm
Szerokość produktu:	139.8 mm
Głębokość produktu:	85.5 mm
Waga produktu:	623 g
Bluetooth:	Tak
Wersja Bluetooth:	4.0
Port USB:	Tak
Typ HD:	4K Ultra HD
Technologia baterii:	Litowo-jonowa (Li-Ion)
Typ ekranu:	LCD
Długość przekątnej ekranu:	3 "
Obsługiwane typy kart pamięci:	SD,SDHC,SDXC
Maksymalny rozmiar karty pamięci:	512 GB
Zakres temperatur (eksploatacja):	-10 - 40 °C
Zakres wilgotności względnej:	10 - 80 %
Ekran dotykowy:	Tak
Nagrywanie wideo:	Tak
Wi-Fi:	Tak
Standardy Wi- Fi:	802.11b,802.11g,Wi-Fi 4 (802.11n)
Obsługiwane formaty audio:	LPCM
Obsługiwane formaty plików wideo:	H.264,MOV,MPEG4
Rodzaj baterii:	NP-W126S
Mikrofon:	Tak
Baterie w zestawie:	Tak
HDMI:	Tak
Wersja USB:	3.2 Gen 1 (3.1 Gen 1)
Cyfrowe zbliżenie:	- x
Waga (łącznie z baterią):	673 g
Czas pracy na zasilaniu akumulatorowym:	1.25 h
Typ aparatu/kamery:	Obudowa bezlusterkowca
Megapiksele:	24.3 MP
Rozmiar przetwornika obrazu:	- "
Typ przetwornika obrazu:	CMOS III
Maksymalna rozdzielczość obrazu:	- px
Stabilizator obrazu:	Tak
Lokalizacja stabilizatora obrazu:	Ciało
Obsługiwane proporcje obrazu:	1:1,3:2
Format kompresji zdjęć:	JPEG
Rozdzielczości wideo:	2048 x 1080,1280 x 720,1920 x 1080,3840 x 2160,4096 x 2160 px
Maksymalna rozdzielczość filmu:	4096 x 2160 px
Wielkość ramki ruchomej jpeg:	70 fps
Zoom optyczny:	- x
interfejs mocowania obiektywu:	Fujifilm X
Regulator ostrości:	Automatyczne/Ręczne
Tryby autofokusa:	Continuous Auto Focus,Single Auto Focus
Wykrywanie obiektów z automatyczną regulacją ostrości (AF):	Twarz
Balans bieli:	Fine,Fluorescent,Incandescent,Shade,Underwater
Opóżnienie samowyzwalacza:	2,10 s
System plików:	Exif 2.3,RAW
Czułość ISO:	100,125,160,200,12800,25600,51200
Tryby naświetlania:	Aperture priority AE,Manual,Shutter priority AE
Pomiar światła:	Centre-weighted,Spot
Korekcja naświetlania:	± 5EV (1/3EV step)
Czułość ISO (min):	100
Czułość ISO (maks):	51200
Typ migawki aparatu:	Electronic,Mechanical
Tryby lampy błyskowej:	Auto,Flash off,Manual,Second curtain synchro,Slow synchronization
Zasięg lampy (szerokość):	- m
Zasięg lampy (tele):	- m
Stopka mocująca lampę błyskową:	Tak
Typ stopki mocującej lampę błyskową:	Gniazdo lampy błyskowej
Proporcje obrazu:	3:2
Wizjer:	Elektroniczny
Rozmiar ekranu wizjera:	0.5 "
Rozdzielczość wizjera:	3690000 px
Rodzaj złącza HDMI:	Mikro
Powiekszenie:	0.75 x
Ładowarka akumulatorów:	Tak
Pasek na szyję:	Tak