Instrukcja obs艂ugi TomTom GO 740

TomTom Navigator GO 740

Przeczytaj poni偶ej 馃摉 instrukcj臋 obs艂ugi w j臋zyku polskim dla TomTom GO 740 (86 stron) w kategorii Navigator. Ta instrukcja by艂a pomocna dla 2 os贸b i zosta艂a oceniona przez 2 u偶ytkownik贸w na 艣rednio 4.5 gwiazdek

Strona 1/86
TomTom GO
What鈥檚 in the box1.
2
What鈥檚 in the box
aTomTom GO AOn/Off button
BMicrophone
CLight sensor
DSpeaker
EMemory card (micro SD card)
slot
bWindshield Mount
cAdhesive disk for Windshield
Mount
dUSB car charger
e fHome Dock Documentation pack
A
B
C
D
E
Before you start2.
3
Before you start
Switching on and off
Install your TomTom GO navigation device in your car following the
instructions in the installation section at the start of this book.
To switch on your navigation device, press and hold the On/Off button until
you see the start-up screen. The first time you switch on your device, it may
take a short time to start.
To set up your device you need to answer a few questions by tapping the
screen.
Device not starting
In rare cases, your TomTom GO navigation device may not start correctly or
may stop responding to your taps.
First, check that the battery is properly charged. To charge the battery,
connect your device to the car charger. It can take up to 2 hours to fully charge
the battery.
If this does not solve the problem, you can reset the device. To do this, press
and hold the On/Off button for fifteen seconds and release the button when
your device begins to restart.
Battery notes
The battery in your TomTom GO navigation device charges when you connect
it to the car charger or to your computer.
The light next to the On/Off button is orange while the battery is charging and
is green when the battery is fully charged.
When you connect your device to a computer, you are asked if you want to
connect to the computer. If you select and then do not tap the screen No
within three minutes, the device will automatically switch off. This happens so
that the battery can charge faster.
Note: You should plug the USB connector directly into a USB port on your
computer and not into a USB hub or USB port on a keyboard or monitor.
Windshield Mount
Use the Windshield Mount to install your TomTom GO inside your car.
Make sure that both the Windshield Mount and your windshield are clean and
dry before you attach the mount. Place the Windshield Mount so that it does
not interfere with your view of the road or of any of the controls in your car.

Specyfikacje produktu

Marka: TomTom
Kategoria: Navigator
Model: GO 740

Potrzebujesz pomocy?

Je艣li potrzebujesz pomocy z TomTom GO 740, zadaj pytanie poni偶ej, a inni u偶ytkownicy Ci odpowiedz膮




Instrukcje Navigator TomTom

Instrukcje Navigator

Najnowsze instrukcje dla Navigator