Instrukcja obsługi Swann ADS-100

Swann Kamera monitorująca ADS-100

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Swann ADS-100 (4 stron) w kategorii Kamera monitorująca. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
1
ADS-100
Advanced-Series
222
Congratulations on your purchase of the ADS-100 from ! You’ve chosen a great entry-level, Swann
indoor and outdoor, compact CCTV camera which has active infrared night vision, allowing it to see up
to 5m/15ft in complete darkness!
Placement Guide
The ADS-100 has a 3.6mm built-in which allows it to see almost 60 degrees wide-angle lens
horizontally. What does this mean for you when placing it?
You will be able to see a • reasonably wide area. If it’s mounted
high up in a square corner, you’ll be able to see most of the room.
Things may look slightly further away than they really are. Anything •
further than a few meters (ten feet or so) from the camera may
appear to be too small for the level of detail you require.
The small size of the camera, wide viewing area and limited •
night vision range mean that you really need to get this camera
as close to what you want to see as possible.
The ADS-100 is great for monitoring smaller areas. You can use the miniature size of the camera to your
advantage when choosing a location to mount it, as it doesn’t require much space.
It’s best mounted high-up in a corner looking down into the room, so that it can look over intervening
obstacles. Also, the higher the camera is mounted, the harder it’ll be for an intruder to access the
camera or interfere with it.
Installing the Camera
The camera mounts onto almost any flat surface using the screws (and wall-plugs, if necessary - see
below) provided. The surface must have sufficient strength to hold the camera. Materials such as
hardwood, brick or masonry are good options, and we’ve included all the gear you’ll need to mount it
there (except the tools - sorry, you’ll still need your own drill). You can mount the camera onto a metal
surface, but you’ll need to supply your own mounting hardware.
To mount the camera:
Using the holes on the camera stand as a guide, mark the locations on your wall to drill. Make •
sure the wall is thick and strong enough that you won’t drill through it.
If the wall is masonry, brickwork or similar, use the provided wall plugs. If the wall is made of •
wood, then the camera can be screwed directly onto the wall.
Ensure that the cable is fully protected from the weather. The camera is weather resistant, but the •
cable (particularly the microphone - see , opposite) is not.Audio
Once the camera has been mounted, ensure that it is securely fixed in place. The camera’s not •
going to do any good if it falls!
Troubleshooting
Problem: At night, all I see is white.
Solution: The camera is most likely looking through a window. At night, the infrared light the camera
uses to see in the dark can ‘bounce back’ off a reflective surface (such as glass, water, spider webs,
some ceramics and so on) and effectively blind the camera. If you want to see outside, mount the
camera outside - we made it weather-resistant for a reason! If the camera absolutely see through must
glass (or similar transparent material) then ensure it is clean, and try to have the camera on an angle
relative to the glass, so that the IR light doesn’t bounce directly back into the lens.
Problem: I see only a blank screen where my image should be.
Solution: Check the wiring to the camera, and ensure the camera is being supplied power from
the included power adapter. Try using a different video lead, or connecting the camera to a different
television or monitor. Be sure there are no devices interrupting your signal, such as a DVR or VCR that
isn’t outputting the signal correctly.
Problem: I can’t see anything at night.
Solution: The maximum range of the night vision is just that, the maximum range. If there’s nothing
in this range, you won’t see anything. Also, some dark objects (like the proverbial black cat) may not
reflect enough light to be seen except as a silhouette if the background is brighter. Some objects which
can easily be seen in visible light don’t reflect much infrared light.
60° 10m
33ft
11.5m
55ft
3
INPUT
2A. Connecting Directly to TV 2B. Connecting to Your Existing DVR
Connect the yellow video out plug to the
video input on your television (typically also yellow).
If you want sound, connect the RED audio out to
the RED audio input. If your TV doesn’t have a red
audio in, connect it to the white Audio In socket.
2
Using the RCA to BNC adapter, connect the
YELLOW video plug to an channel input on the
rear of the R. If your R has audio inputs,DV DV
connect the RED audio plug to an audio in socket.
2
Plug in the camera
power adapter into
a wall socket
4
Connect the camera’s DC and RCA sockets
to the extension cable, matching plugs to
sockets by color.
Microphone
1
Connect the extension cables
DC socket to the DC plug on
the power adapter
3
Technical Specifications
Video
Image Sensor 1/4” CMOS
Video Quality 400 TV Lines
Effective Pixels NTSC: 510 x 492
PAL: 628 x 582
Min. Illumination 0 Lux (IR on)
White Balance Automatic
Electronic Shutter NTSC: 1/60 ~ 1/100 000
PAL: 1/50 ~ 1/100 000
Gain Control Automatic
Backlight Comp. No
Wide Dynamic Range No
Lens 3.6mm
Viewing Angle H: 60°, V: 47°
Night Vision
Range Up to 5m (15ft)
IR Cut Filter No
Number of IR LEDs 11
Infrared Wavelength 850nm
IR LED Life (Average) 10, 000 hours
General
Power Required DC 12V @ 150mA
Operating Temp. -10°C ~ 45°C (14°F ~ 113°F)
Casing Aluminum
Dimensions (Camera) 165mm x 115mm x 67mm
(6.5” x 4.5” x 3.15”)
Dimensions (Stand) 60mm x 50mm x 45mm
(2.4” x 2” x 1.75”)
Weight (Camera) 60g / 2.2oz (approx)
Weight (Stand) 60g / 2.2oz (approx)
Audio
The ADS-100 has a microphone built in. It’s not in the camera itself, it’s attached to the cable (it’s in the
plastic tab near the A/V plugs). The RED RCA jack on the back of the camera carries the audio. It’s a
standard line-level output, and can be connected to a TV, DVD recorder, DVR, audio recorder, the line-in
port on a computer or any other audio device with standard inputs.
The microphone has a range of about 3m/10ft for sounds as loud as a normal speaking voice. Loud
sounds travel much further, and it might not hear really soft sounds at all.
The microphone isn’t in the camera for two reasons:
The weather-resistant case makes it relatively sound-resistant as well. We couldn’t put the mic in 1.
there without compromising the seal, and losing any shielding the camera has.
You can use the somewhat moveable microphone to your advantage, by placing it closer to what 2.
you’d want to hear. The microphone has a limited range, so proximity is the key to good results!

Specyfikacje produktu

Marka: Swann
Kategoria: Kamera monitorująca
Model: ADS-100

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Swann ADS-100, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Kamera monitorująca Swann

Swann

Swann SWNHD-866MSD Instrukcja

2 Października 2024
Swann

Swann Pro DVR8-4000 Instrukcja

28 Września 2024
Swann

Swann DVR4-1000 Instrukcja

22 Września 2024
Swann

Swann Enforcer SWPRO-4KMQB Instrukcja

19 Września 2024
Swann

Swann SW312-HMD-CA Instrukcja

16 Września 2024
Swann

Swann PRO-A851 Instrukcja

15 Września 2024
Swann

Swann SWIFI-PTCAM232GB Instrukcja

12 Września 2024
Swann

Swann AllSecure650 SWNVK-650KH4 Instrukcja

12 Września 2024
Swann

Swann PrivateEye ADS-45 Instrukcja

9 Września 2024
Swann

Swann SW331-PR5 Instrukcja

9 Września 2024

Instrukcje Kamera monitorująca

Najnowsze instrukcje dla Kamera monitorująca

Dahua Technology

Dahua Technology Pro IPC-HDPW5442G-Z Instrukcja

15 Stycznia 2025
Toshiba

Toshiba IKS-WR7412 Instrukcja

13 Stycznia 2025
AVerMedia

AVerMedia FC1320-P Instrukcja

13 Stycznia 2025
Digitus

Digitus OptiMax DN-16037 Instrukcja

13 Stycznia 2025
Hikvision

Hikvision DS-2CE59U1T-AVPIT3ZF Instrukcja

12 Stycznia 2025
Hikvision

Hikvision IDS-2CD7526G0-IZHSY Instrukcja

12 Stycznia 2025
Hikvision

Hikvision DS-2CD2163G0-I(S) Instrukcja

12 Stycznia 2025
Hikvision

Hikvision DS-2CD2H83G1-IZS Instrukcja

12 Stycznia 2025
Speco Technologies

Speco Technologies O5LB1 Instrukcja

12 Stycznia 2025
ZKTeco

ZKTeco AntarVis 2.0 Instrukcja

12 Stycznia 2025