Instrukcja obsługi Sony SAL300F28G2
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Sony SAL300F28G2 (2 stron) w kategorii Obiektyw. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/2
You can find information on using the lens in “ Operating Instructions.”
Refer to “ Operating Instructions” on the names of parts, depth-of-field
table (in meters). Other information, such as notes on use, can be found in
“ Operating Instructions” and “Precautions before using” on a separate
sheet.
Attaching/detaching the lens
To attach the lens
1 Remove the front and rear lens caps and the camera body cap.
2 Align the orange index on the lens barrel with the orange index
on the camera (mounting index), then insert the lens into the
camera mount and rotate it clockwise until it locks.
Do not press the lens release button on the camera when mounting the lens.
Do not mount the lens at an angle.
To remove the lens
While pressing and holding the lens release button on the camera,
rotate the lens counterclockwise until it stops, then detach the lens.
Attaching the lens hood
It is recommended that you use a lens hood to reduce flare and ensure
maximum image quality.
Loosen the locking screw on the lens hood and slip the lens hood
over the front of the lens. Check that lens hood is attached properly,
and then tighten the screw.
When using a built-in camera flash, make sure to remove the lens hood to avoid
blockage of the flash light.
Attaching the lens front cap
When storing, turn the lens hood back over the lens, and tighten the screw to
secure the lens hood to the lens.
Attach the lens to the lens front cap firmly, zip the fastener tape and tighten
with the stopper.
When attaching the lens front cap to the lens hood, align the holder of the lens
hood on the hole of the lens front cap.
Attaching a tripod
Attach the tripod to the lens, not to the camera.
To change vertical/horizontal position
Loosen the collar-locking knob on the tripod-mounting collar (1) and rotate
the camera either direction. The camera can be quickly switched between
vertical and horizontal positions while maintaining stability when using a
tripod.
Gray indexes (collar indexes) are located at 90° intervals on the tripod-mounting
collar. Align a gray index on the tripod-mounting collar with the gray index
(lens index) on the lens to adjust the camera position precisely (2).
Tighten the collar-locking knob firmly after the camera position is set.
4-433-638- (1)11
©2012 Sony Corporation
Interchangeable Lens
SAL300F28G2
300mm F2.8 G SSM II
Operating Instructions
A-mount
Printed in Japan
(1) (2)
To detach the tripod-mounting collar
The tripod-mounting collar can be detached.
1 Remove the lens from the camera.
See “ Attaching/detaching the lens” for details.
2 Loosen the collar-locking knob (1).
3 Rotate the tripod-mounting collar to align the red index on
the tripod-mounting collar (collar mounting index next to
SET/RELEASE) with the orange index on the lens (lens mounting
index) (3).
4 Move the tripod-mounting collar towards the lens mount and
detach the tripod-mounting collar from the lens (4).
(3) (4)
Attaching the strap
Attach the strap so that the lens can be carried easily. Follow steps (1) and (2)
to attach the strap.
To prevent the lens from dropping, be sure to attach the strap properly so that
the strap will not come loose from the lens.
(1) (2)
Focusing
To switch AF (auto focus)/MF (manual focus)
The focus mode can be switched between AF and MF on the lens.
For AF photography, both the camera and lens should be set to AF. For MF
photography, either or both the camera or lens should be set to MF.
(1) (2)
To set the focus mode on the lens
Slide the focus-mode switch to the appropriate mode, AF or MF (1).
Refer to the camera manuals to set the focus mode of the camera.
In MF, turn the focusing ring to adjust the focus (2) while looking through the
viewfinder, etc.
FULL: The focus range is not limited. AF is set to the entire focus range.
- 6.4m: AF is set to 6.4 m (21 feet) to infinity.
SET: AF is set to the appointed focus range, both far and near positions.
To set the focus range
1 Slide the focus-range limiter to SET.
2 Focus the lens to the desired far or near distance.
The focusing distance can be set in any focus mode: AF, MF or DMF.
The far and near focusing distance can be set in either order.
3 Slide the focus-range setting switch to FAR or NEAR for the
appropriate focus range position (depending on which position
you set first).
The focus-range setting switch automatically returns to the original
position.
If the audio-signal switch is set to ON, a beep will be heard when the focus
range is set.
The focus range to be set is effective until a new focus range is set.
Using prefocus
A specific subject distance can be stored and recalled at any time. With the
distance set, this is useful for catching fast-moving subjects, such as a moving
train, events at a sports festival, or horse and car races, etc.
To set the subject distance
1 Slide the focus-hold/prefocus switch to PREFOCUS.
2 Focus the lens on the distance to be set.
The focusing distance can be set in any focus mode: AF, MF or DMF.
3 Press the focus preset button to store the subject distance.
The stored subject distance is effective until a new subject distance is set.
If the audio-signal switch is set to ON, a beep will be heard when the
subject distance is stored.
To recall the preset subject distance
1 Slide the focus-hold/prefocus switch to PREFOCUS.
Set the focus hold button function to FOCUS HOLD for cameras with
custom function capability.
2 Press the focus-hold button so that the lens will focus to the
prefocus position.
When AF is set, press and hold the focus-hold button while taking pictures.
If the focus-hold button is released, AF will be reactivated and the subject
focus distance will be changeable.
If the audio-signal switch is set to ON, a beep will be heard when the preset
subject distance is recalled.
Using the audio signal
The audio signal beeps when the focusing range is customized with the
focus-range setting switch or the prefocus distance is set or recalled with the
focus preset button.
Slide the audio-signal switch to BEEP ON to activate the signal.
To use a camera equipped with an AF/MF control button
Press the AF/MF control button to switch AF to MF when both the camera and
lens are set to AF.
Press the AF/MF control button to switch MF to AF when the camera is set to
MF and the lens is set to AF.
Direct manual focus (DMF)
Even when AF is set, the setting is switched to MF automatically if you rotate
the focusing ring while pressing the shutter button halfway. This provides
quick fine adjustment of focusing (DMF). Select the mode for correct DMF
from the following. Set the DMF-mode switch to whichever you prefer.
Standard DMF (STD)
Rotate the focusing ring to set correct DMF when the focus is locked in AF-A
(automatic auto focus) or AF-S (single-shot auto focus). Using this mode is
recommended for normal subjects.
DMF is not available in AF-C (continuous auto focus), when out of focus, or
with continuous advance in AF-A after the second focus is confirmed.
Full-time DMF (F TIME)
In any AF mode (AF-A/S/C), rotate the focusing ring while pressing the
shutter button halfway to set correct DMF. This is useful to catch a fast-
moving subject.
Shooting at infinity in MF
The focusing ring can be rotated slightly past the infinity to provide accurate
focusing under various operating temperatures. Do not rotate the focusing
ring all the way to the end when focusing manually, even at infinity. Look
through the viewfinder, etc., and set the focus precisely.
Depth-of-field scale (See Exhibit Operating
Instructions- )
When focus is set on a subject, anything at that same distance will appear
sharp, and anything within a certain range before and beyond the subject will
also appear in focus; this is called depth of field. Depth of field depends on
the subject distance and aperture you choose and is indicated by the lines on
the depth-of-field scale corresponding to the aperture.
The depth-of-field scale and depth-of-field table are for 35mm-format cameras.
The depth-of-field is shallower when you use an Interchangeable Lens Digital
Camera equipped with an APS-C sized image sensor.
Using focus-hold buttons
This lens has 4 focus-hold buttons.
Press the focus-hold button in AF to cancel AF. The focus is fixed and you
can release the shutter on the fixed focus. Release the focus-hold button while
pressing the shutter button halfway to start AF again.
Set the focus-hold/prefocus switch to FOCUS HOLD and press the
focus-hold button.
The function of the focus-hold button can be changed on cameras with custom
function capability. Refer to the camera manuals for details.
Switching focus range (AF range)
The focus-range limiter enables you to reduce the auto focusing time. This is
useful when the subject distance is definite. You can also set the desired focus
range and select it.
Slide the focus-range limiter to select the focus range.
To set the signal off, slide the audio-signal switch to OFF.
Changing the plug-in filters
A normal filter is equipped with your lens.
The filter is a part of optical system component. Be sure to attach either the
normal filter or the polarizing (circular) filter when taking pictures.
To change the plug-in filter
1 Push down the filter-holder lock and turn it counterclockwise 90°
towards the lens front until the orange index is aligned with the
filter holder, and then lift the filter holder up.
2 Align the filter-holder lock orange index with the filter holder,
face the side with the filter to the camera body, and then insert
the filter holder into the lens barrel.
When attaching the polarizing (circular) filter to the lens, make sure to
point the arrow tip of the filter holder to the lens front.
Plug-in filters can be used in either direction, facing back or front.
3 Push down the filter-holder lock and turn it 90° clockwise to lock.
The filter-holder lock orange index is perpendicular to the holder.
To use the plug-in polarizing (circular) filter
1 Adjust the focus precisely while looking through the viewfinder,
etc.
2 Rotate the adjust ring on the plug-in polarizing (circular) filter
holder while looking through the viewfinder, etc., to adjust
degree of polarization for shooting.
The polarizing (circular) filter can reduce or eliminate unwanted reflections
(polarized light) from nonmetallic surfaces of water, glass, windows, shiny
plastics, ceramics, paper, etc. It can also filter out polarized light from
the atmosphere in general to produce richer colors. You can adjust the
polarizing degree to get good contrast when taking photos of blue sky.
Generally, reflected light (polarization) should be minimized in
photography, however you can adjust the polarizing degree for the desired
effect.
The amount of light reaching the image sensor decreases. If your camera is
set to manual exposure mode and you are using a commercially available
exposure meter, or if your camera is set to manual exposure mode and you
are using the Manual Flash Control function available on some external
flash units, adjust the exposure compensation by opening the aperture 1 or
2 stops to the + side.
Specyfikacje produktu
| Marka: | Sony |
| Kategoria: | Obiektyw |
| Model: | SAL300F28G2 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Sony SAL300F28G2, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Obiektyw Sony
7 Października 2024
7 Października 2024
4 Października 2024
4 Października 2024
4 Października 2024
4 Października 2024
4 Października 2024
4 Października 2024
29 Września 2024
27 Września 2024
Instrukcje Obiektyw
- Obiektyw Samsung
- Obiektyw Leica
- Obiektyw Gigabyte
- Obiektyw Panasonic
- Obiektyw Canon
- Obiektyw Fujifilm
- Obiektyw MSI
- Obiektyw Sigma
- Obiektyw Nikon
- Obiektyw Godox
- Obiektyw Olympus
- Obiektyw Axis
- Obiektyw Optoma
- Obiektyw Pentax
- Obiektyw InLine
- Obiektyw Hanwha
- Obiektyw Gaggenau
- Obiektyw Tamron
- Obiektyw Zeiss
- Obiektyw Vello
- Obiektyw Celly
- Obiektyw Brinno
- Obiektyw Computar
- Obiektyw Lensbaby
- Obiektyw Pelco
- Obiektyw Laowa
- Obiektyw Cambo
- Obiektyw Tokina
- Obiektyw Accsoon
- Obiektyw NiSi
- Obiektyw DZOFilm
Najnowsze instrukcje dla Obiektyw
14 Października 2024
11 Października 2024
10 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
Tamron SP AF17-50mm F/2.8 XR Di II LD Aspherical [IF] Instrukcja
9 Października 2024