Instrukcja obsługi Sony LMD-DM30

Sony monitor LMD-DM30

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Sony LMD-DM30 (34 stron) w kategorii monitor. Ta instrukcja była pomocna dla 17 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/34
LCD Display
4-421-015-12 (1)
© 2012 Sony Corporation
Instructions for Use
Before operating the unit, please read this manual thoroughly
and retain it for future reference.
LMD-DM50
LMD-DM30
LMD-DM20
2
Owner’s Record
The model and serial numbers are located at the rear.
Record these numbers in the spaces provided below.
Refer to these numbers whenever you call upon your
Sony dealer regarding this product.
Model No. ____________________
Serial No. ____________________
WARNING
To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
No modification of this apparatus is allowed.
WARNING
THIS APPARATUS MUST BE EARTHED.
To disconnect the main power, unplug the AC plug.
WARNING
When installing the unit, incorporate a readily
accessible disconnect device in the fixed wiring, or
connect the power plug to an easily accessible socket-
outlet near the unit. If a fault should occur during
operation of the unit, operate the disconnect device to
switch the power supply off, or disconnect the power
plug.
WARNING
Make sure the surface is wide enough so that this
apparatus’s width and depth don’t exceed the surface’s
edges.
If not, this apparatus may lean or fall over and cause an
injury.
For the customers in the U.S.A.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC Rules.
If you have any questions about this product, you may
call;
Sony Customer Information Service Center 1-800-222-
7669 or http://www.sony.com/
WARNING:
Using this unit at a voltage other than 120 V may require
the use of a different line cord or attachment plug, or
both. To reduce the risk of fire or electric shock, refer
servicing to qualified service personnel.
For the customers in Canada
This Class B digital apparatus complies with Canadian
ICES-003.
For the customers in Canada
This unit has been certified according to Standard CSA
C22.2 No.601.1.
For the customers in the U.S.A and Canada
When you use this product connected to 240 V single
phase, be sure to connect this product to a center tapped
circuit.
Declaration of Conformity
Trade Name : SONY
Model : LMD-DM50/DM30/DM20
Responsible party : Sony Electronics Inc.
Address : 16530 Via Esprillo, San Diego,
CA 92127 U.S.A.
Telephone Number : 858-942-2230
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
3
For the customers in Europe
This product has been manufactured by or on behalf of
Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-
0075 Japan. Inquiries related to product compliance
based on European Union legislation shall be addressed
to the authorized representative, Sony Deutschland
GmbH, Hedelfinger Strasse 61, 70327 Stuttgart,
Germany. For any service or guarantee matters, please
refer to the addresses provided in the separate service or
guarantee documents.
Important safeguards/notices for use in the
medical environments
1. All the equipments connected to this unit shall be
certified according to Standard IEC60601-1,
IEC60950-1, IEC60065 or other IEC/ISO Standards
applicable to the equipments.
2. Furthermore all configurations shall comply with the
system standard IEC60601-1-1. Everybody who
connects additional equipment to the signal input
part or signal output part configures a medical
system, and is therefore, responsible that the system
complies with the requirements of the system
standard IEC60601-1-1.
If in doubt, consult the qualified service personnel.
3. The leakage current could increase when connected
to other equipment.
4. For this particular equipment, all accessory
equipment connected as noted above, must be
connected to mains via an additional isolation
transformer conforming with the construction
requirements of IEC60601-1 and providing at least
Basic Insulation.
5. This equipment generates, uses, and can radiate radio
frequency energy. If it is not installed and used in
accordance with the instruction manual, it may cause
interference to other equipment. If this unit causes
interference (which can be determined by
unplugging the power cord from the unit), try these
measures: Relocate the unit with respect to the
susceptible equipment. Plug this unit and the
susceptible equipment into different branch circuit.
Consult your dealer. (According to standard EN60601-
1-2 and CISPR11, Class B, Group 1)
Caution
When you dispose of the unit or accessories, you must
obey the laws in the relative area or country and the
regulations in the relative hospital.
For the customers in the USA
Lamp in this product contains mercury. Disposal of
these materials may be regulated due to environmental
considerations. For disposal or recycling information,
please contact your local authorities or the
Telecommunications Industry Association
(www.eiae.org).
WARNING on power connection
Use a proper power cord for your local power supply.
1. Use the approved Power Cord (3-core mains lead) /
Appliance Connector / Plug with earthing-contacts
that conforms to the safety regulations of each
country if applicable.
2. Use the Power Cord (3-core mains lead) / Appliance
Connector / Plug conforming to the proper ratings
(Voltage, Ampere).
If you have questions on the use of the above Power
Cord / Appliance Connector / Plug, please consult a
qualified service personnel.
WARNING on power connection for medical
use
Please use the following power supply cord. With
connectors (plug or female) and cord types other than
those indicated in this table, use the power supply cord
that is approved for use in your area.
*Note: Grounding reliability can only be achieved when the
equipment is connected to an equivalent receptacle marked ‘Hospital
Only’ or ‘Hospital Grade’.
Symbols on the unit
This symbol indicates the manufacturer, and
appears next to the manufacturer’s name and
address.
Refer to the operating instructions
Follow the directions in the operating
instructions for parts of the unit on which this
mark appears.
United States and Canada
Plug Type HOSPITAL GRADE*
Cord Type Min. Type SJT
Min. 18 AWG
Minimum Rating
for Plug and
Appliance
Couplers
10A/125V
Safety Approval UL Listed and CSA


Specyfikacje produktu

Marka: Sony
Kategoria: monitor
Model: LMD-DM30

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Sony LMD-DM30, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje monitor Sony

Sony

Sony LMD-1420 Instrukcja

5 Października 2024
Sony

Sony FW-75BZ35F Instrukcja

4 Października 2024
Sony

Sony LMD-9050 Instrukcja

4 Października 2024
Sony

Sony INZONE M9 Instrukcja

4 Października 2024
Sony

Sony SDM-N50 Instrukcja

26 Września 2024
Sony

Sony FW-98BZ50L Instrukcja

24 Września 2024
Sony

Sony FW-65BZ30L Instrukcja

24 Września 2024
Sony

Sony INZONE M3 Instrukcja

23 Września 2024
Sony

Sony ZRD-CH15D Instrukcja

20 Września 2024

Instrukcje monitor

Najnowsze instrukcje dla monitor

Acer

Acer EB321HQUDbmidphx Instrukcja

15 Października 2024
Bauhn

Bauhn APMTR-0624 Instrukcja

15 Października 2024
Acer

Acer KA270H Instrukcja

14 Października 2024
Acer

Acer K272HUL Dbmidpx Instrukcja

14 Października 2024
NEC

NEC E424 Instrukcja

14 Października 2024
LG

LG UltraGear 32GS85Q Instrukcja

14 Października 2024
LG

LG UltraGear 27GS85Q Instrukcja

14 Października 2024
Acer

Acer EK220QB Instrukcja

13 Października 2024
Acer

Acer S242HL Instrukcja

12 Października 2024