Instrukcja obsługi Snow Joe H092

Snow Joe nieskategoryzowany H092

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Snow Joe H092 (6 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 16 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/6
© 2012 by Snow Joe, LLC
All rights reserved. Original instructions.
OPERATOR’S MANUAL
SAVE THESE INSTRUCTIONS
1
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Any electrical appliance can be dangerous if used incorrectly.
Some of the safety precautions given in this manual apply
generally to many appliances. Other warnings are specic to
the use of this tree stand.
You and any other operator of this rotating tree stand must
read, understand and follow these instructions in their entirety,
and should re-read them at the start of each holiday season.
Failure to follow any of these instructions may result in
ELECTRIC SHOCK, FIRE and/or serious PERSONAL INJURY.
General Safety WARNINGS!
Notice the personal safety alert symbol used in this m
manual to draw your attention to a WARNING given along
with the particular operating instruction. This means that
an operation requires special ATTENTION, CAUTION and
AWARENESS.
1. indoor seasonal This tree stand is for use for articial
trees only. Do not install on a permanent basis or use for
commercial purposes.
2. Do not use this product for other than its intended use.
3. Keep tree stand away from all heat sources including gas
and electric heaters, replaces, and candles.
4. Use the electric cord safely.
A. Electric plugs must match the outlet. Never modify
the plug in any way. Unmodied plugs and matching
outlets will reduce the risk of electric shock.
B. Do not use with an extension cord unless the plug can
be fully inserted.
C. Do not abuse the cord. Keep cord away from heat
sources, oil and sharp edges.
D. Do not place the cord in high trafc areas of your
home, or close doors or windows on the cord.
E. Never carry the tree stand by its cord or yank the cord
to disconnect it from electrical outlet.
F. Replace or properly repair damaged cords. If cord is
damaged in any manner while plugged in, pull cord
from wall receptacle.
G. Do not secure the cord with staples or nails, or place
on sharp hooks or nails, since this may damage the
cord and increase the risk of electric shock.
H. Turn off the power switch and disconnect the cord
before decorating your tree or when leaving the tree
stand unattended.
I. Contact with water while operating the tree stand can
result in electric shock and serious personal injury. Do
not handle the plug or the appliance with wet hands or
while standing in water.
5. WARNING Keep out of reach of small children. This m
product is not a toy. To avoid risk of electric shock, re,
and serious bodily injury, do not play with tree stand or
allow access to small children or unauthorized users.
6. Moving parts present risks. Keep your face, hair, clothing,
hands and feet away from the rotating spindle. Shut off
and disconnect cord before touching any moving parts.
7. Make sure the tree can rotate freely without any
obstructions, such as walls curtains, lamp cords, or
furniture. If the tree’s rotation is obstructed, you will hear a
clicking sound every fteen seconds, which will stop once
the obstructing object is removed.
8. Keep tree skirts, tinsel, garland, and other holiday
decorations away from rotating spindle.
9. This product has a polarized plug (one blade is wider than
the other) as a feature to reduce the risk of electric shock.
This plug will t in a polarized outlet only one way. If the
plug does not t fully in the outlet, reverse the plug. If it
still does not t, contact a qualied electrician. Do not use
with an extension cord unless plug can be fully inserted.
Do not alter or replace the plug. It is acceptable to omit
this item if the product does not employ a polarized plug.
10. Do not cover the product with cloth, paper or any material
not part of the product when in use.
11. Unplug the product when leaving the house, or when
retiring for the night, or if left unattended.
A Division of Snow Joe, LLC
Form No. H092-880E
Model No. H092
Rotating Articial Tree Stand
Rotating Articial Tree Stand
2
Assembly
Getting Started
1. Remove the tree stand from the box and familiarize
yourself with the unit (Fig. 1).
2. Inspect the stand carefully for shipping damage. If
damage is seen or suspected (such as damaged wire
insulation, cracks in the enclosures, loose connections or
exposed copper wire), do not assemble. Instead, contact
Snow Joe Customer Service for assistance.
Tree Installation
1. Locate the tree base collar in the parts bag and slide the
collar onto the tree pole (Fig. 2). Do not attempt to insert
the tree pole into the collar while the collar is screwed into
the tree stand.
Note: This tree stand will accommodate standard size
tree poles up to 1.25 in. (3.18 cm) in diameter. If the collar
will not slip onto the tree pole, this indicates that your tree
pole is not a standard size.
2. Insert the tree pole into the stand.
Note: For poles with pointed ends (crimps), carefully turn
the pole into the spindle until the crimp hooks onto the rib
inside the spindle (Fig. 3).
m m CAUTION
Inspect wiring, which, if damaged during shipping, may
cause serious bodily injury during equipment use. If any
damage is seen or suspected, do not assemble. Instead,
contact Snow Joe Customer Service (1-866-766-9563)
for assistance.
Handle with care during assembly so that electrical
wiring does not become damaged.
D
I
H
G
B
F E
CA
Figure 1
A. Spindle Screw
B. Rotaing Power Base
C. Tree Base Collar
D. Tree Stand Base
E. Switch Box
F. Reset Switch
G. Light Switch
H. Rotation Switch
I. Power Cord
C
B
A
B
B
D
E
F
Figure 2
A. Articial Tree Pole
B. Spindle Screws (x3)
C. Receptacle
D. Tree Base Collar
E. Rotating Power Base
F. Tree Stand Base
A
B
C
C
C
Figure 3
A. Articial Tree Pole
C. Collar Screws (x3)
B. Tree Stand Base
3
3. Slide the collar down the pole and secure it to the tree
stand by fastening the three (3) collar screws (Fig. 4).
IMPORTANT: Do not over-tighten the screws, since this
can damage the tree stand.
4. Tighten all three (3) spindle screws to secure the tree in a
stable, upright position (Fig. 5).
5. Make sure the tree ts securely inside the collar before
turning on the tree stand. Once the tree is installed inside
the stand, do not rock it back and forth since this can
damage the stand. If the tree does not t properly even
after tightening the collar screws, please contact Snow
Joe Customer Service at 1-866-766-9563.
Operation
1. The electric cord has a polarized plug (Fig. 6), with one
prong slightly longer and wider than the other. This plug
can be inserted only one way into a polarized outlet. If the
plug does not t properly in the outlet, unplug it from the
outlet and insert it in the reverse direction. If it still does
not t, seek the assistance of a qualied electrician.
Note: If using an extension cord with this unit, make sure
that the original plug ts snugly into the extension cord
slots, which are likewise polarized.
A
E
D
C
B
B
Figure 4
A. Articial Tree Pole
B. Collar Screws (x3)
C. Tree Base Collar
D. Rotating Power Base
E. Tree Stand Base
A
B
B B
C
D
Figure 5
A. Articial Tree Pole
B. Spindle Screws (x3)
C. Rotating Power Base
D. Receptacle
m WARNING m
Electric shock can cause SEVERE INJURY or
DEATH. Heed these warnings:
• Do not allow any part of tree stand to make contact
with water while powered on. If the stand becomes
wet while turned off, wipe dry before starting.
• Do not touch the tree stand or its plug with wet
hands or while standing in water.
• Do not use with an extension cord unless the plug
can be fully inserted.
A
Figure 6
A. Electrical Cord

Specyfikacje produktu

Marka: Snow Joe
Kategoria: nieskategoryzowany
Model: H092
Kolor produktu: Zielony
Maksymalna waga: 68 kg
Typ mocowania: Podłoga

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Snow Joe H092, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje nieskategoryzowany Snow Joe

Snow Joe

Snow Joe RJ205M-RM Instrukcja

18 Czerwca 2024
Snow Joe

Snow Joe RJ204M Instrukcja

18 Czerwca 2024
Snow Joe

Snow Joe SJSPD1 Instrukcja

18 Czerwca 2024
Snow Joe

Snow Joe RJ205M Instrukcja

18 Czerwca 2024
Snow Joe

Snow Joe ATJ401M-GLD Instrukcja

18 Czerwca 2024
Snow Joe

Snow Joe ION18SB-HYB-RM Instrukcja

18 Czerwca 2024
Snow Joe

Snow Joe ATJ401M-SJB Instrukcja

18 Czerwca 2024
Snow Joe

Snow Joe H092 Instrukcja

18 Czerwca 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Meec Tools

Meec Tools 010-084 Instrukcja

6 Października 2024
Outwell

Outwell Scenic Road 250 Instrukcja

5 Października 2024
Impact

Impact Qualite QL-3560-LED Instrukcja

4 Października 2024
Impact

Impact QuikBalance Instrukcja

4 Października 2024
Impact

Impact CA-112 Instrukcja

4 Października 2024
Impact

Impact Forever Ready Cool FRC-24-LED Instrukcja

4 Października 2024
Impact

Impact LS-BHA Instrukcja

4 Października 2024
Impact

Impact LKB-5C Instrukcja

4 Października 2024
Impact

Impact Varipole Drop Ceiling Adapter Instrukcja

4 Października 2024
Impact

Impact RST-001 Instrukcja

4 Października 2024