Instrukcja obsługi Smeg PTS726EB

Smeg piekarnik PTS726EB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Smeg PTS726EB (15 stron) w kategorii piekarnik. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/15
Table of Contents
19
1. Precautions for safety and use ________________________ 20
2. Fitting the appliance in the top ________________________ 21
2.1 Fixing to the supporting structure _______________________________________21
3. Electrical connection________________________________ 23
4. Gas connection____________________________________ 24
4.1 Bottled gas connection _______________________________________________25
4.2 Room ventilation____________________________________________________25
4.3 Combustion gas discharge ____________________________________________25
5. Adapting to different types of gas ______________________ 26
5.1 Removing the hob skin _______________________________________________26
5.2 Adjusting for bottled gas ______________________________________________27
5.3 Adjusting for natural gas ______________________________________________27
5.4 Adjusting the primary air flow __________________________________________28
5.5 Reassembling the hob skin____________________________________________28
5.6 Adjusting the minimum setting for natural gas and town gas __________________28
5.7 Adjusting the minimum for bottled gas ___________________________________28
5.8 Hob burner layout ___________________________________________________29
5.9 Greasing the gas taps________________________________________________29
6. Description of controls ______________________________ 30
6.1 The front panel _____________________________________________________30
7. Using the hob _____________________________________ 31
7.1 Lighting burners with safety device______________________________________31
7.2 Positioning the griddle plate ___________________________________________31
7.3 Practical hints for using the burners _____________________________________31
7.4 Pan diameters______________________________________________________32
8. Cleaning and maintenance ___________________________ 33
8.1 Cleaning stainless steel ______________________________________________33
8.2 Cleaning the components _____________________________________________33
THESE INSTRUCTIONS ONLY APPLY TO THE COUNTRIES OF DESTINATION WHOSE
IDENTIFICATION SYMBOLS ARE LISTED ON THE COVER OF THIS MANUAL.
THIS BUILT-IN HOB IS CLASSIFIED AS CLASS 3.
INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified
engineer who is to check the gas supply system and install, commission and test the
appliance.
INSTRUCTIONS FOR THE USER: these provide recommendations for use, a
description of the controls and the correct procedures for cleaning and maintaining the
appliance.
Precautions for Safety and Use
20
1. Precautions for safety and use
THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CARE OF IT AND KEEP IT
TO HAND THROUGHOUT THE HOB'S LIFE CYCLE. USERS ARE ADVISED TO READ THIS MANUAL
AND ALL THE INSTRUCTIONS IT CONTAINS BEFORE USING THE HOB. ALSO KEEP THE SET OF
NOZZLES PROVIDED IN A SAFE PLACE. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED
STAFF IN COMPLIANCE WITH THE RELEVANT REGULATIONS. THIS APPLIANCE IS INTENDED FOR
HOUSEHOLD USE AND COMPLIES WITH THE EEC DIRECTIVES CURRENTLY IN FORCE. THE
APPLIANCE IS BUILT TO PROVIDE THE FOLLOWING FUNCTION: COOKING AND HEATING FOODS;
ALL OTHER USES ARE TO BE CONSIDERED IMPROPER.
THE MANUFACTURER DECLINES ALL LIABILITY FOR USES OTHER THAN THOSE STATED ABOVE.
NEVER LEAVE PACKAGING RESIDUES UNATTENDED IN THE HOME. SEPARATE WASTE
PACKAGING MATERIALS BY TYPE AND CONSIGN THEM TO THE NEAREST SEPARATE DISPOSAL
CENTRE.
THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE WITH ELECTRICAL SYSTEM
SAFETY REGULATIONS.
THE PLUG TO BE CONNECTED TO THE POWER SUPPLY LEAD AND THE RELATIVE SOCKET MUST
BE OF THE SAME TYPE AND COMPLY WITH THE RELEVANT REGULATIONS.
THE POWER SUPPLY SOCKET MUST BE ACCESSIBLE EVEN AFTER THE APPLIANCE HAS BEEN
BUILT-IN.
NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD.
IMMEDIATELY AFTER INSTALLATION, CARRY OUT A QUICK TEST ON THE HOB FOLLOWING THE
INSTRUCTIONS PROVIDED LATER IN THIS MANUAL. IF THE APPLIANCE FAILS TO OPERATE,
DISCONNECT IT FROM THE ELECTRICAL MAINS AND CONTACT YOUR NEAREST SERVICE
CENTRE.
NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF.
AFTER EACH USE OF THE HOB, ALWAYS CHECK THAT THE CONTROL KNOBS ARE TURNED TO
"ZERO" (OFF).
NEVER PLACE PANS WITH BOTTOMS WHICH ARE NOT PERFECTLY FLAT AND SMOOTH ON THE
HOB PAN STANDS.
NEVER USE PANS OR GRIDDLE PLATES WHICH PROJECT BEYOND THE OUTSIDE EDGE OF THE
HOB.
THE NAMEPLATE WITH THE TECHNICAL DATA, SERIAL NUMBER AND MARK IS IN A VISIBLE
POSITION UNDERNEATH THE CASING, ANNEXED TO THIS MANUAL AND APPLIED TO THE QUALITY
CERTIFICATE.
THIS NAMEPLATE MUST NEVER BE REMOVED.
THE APPLIANCE IS INTENDED FOR USE BY ADULTS. KEEP CHILDREN AT A SAFE DISTANCE AND
NEVER ALLOW THEM TO PLAY WITH IT.
THIS APPLIANCE IS TAGGED UNDER EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL
AND ELECTRONIC EQUIPMENT (WEEE).
THIS DIRECTIVE CONTAINS THE REGULATIONS GOVERNING THE COLLECTION AND RECYCLING
OF DECOMMISSIONED APPLIANCES THROUGHOUT THE EUROPEAN FITTING.
The manufacturer declines all responsibility for injury or damage caused by failure to comply
with the above regulations or deriving from tampering with even just one part of the appliance
and the use of non-original spare parts.
Instructions for the Installer
21
2. Fitting the appliance in the top
The procedures required below must be carried out by a skilled builder and/or joiner.
The hob can be installed on various materials, including masonry, metal, solid wood
and wood finished with plastic laminates, provided the material is heat-resistant
(T 90° C).
2.1 Fixing to the supporting structure
Make a hole in the cabinet top with the dimensions shown here, maintaining a
distance of at least 50 mm from the rear edge. This appliance may be installed
against walls higher than the worktop surface, provided the distance "X" shown here is
maintained, in order to prevent damage due to overheating. Make sure that there is at
least 750 mm between the hob burners and a shelf or hood (if any) placed vertically
above them.
(*:6 Burner Hob, UR2 at Side)
If the hob is installed above a cupboard with doors, a separator panel must be
installed underneath it. Leave a gap of at least 10 mm between the bottom of the hob
and the surface of the panel, which must be easily removable to allow sufficient
access for any servicing procedures.
Installation of an oven without cooling fan underneath the hob is forbidden.
In case of installation on a hollow compartment with doors, a separating panel has to
be placed under the hob. Keep a minimum distance of 10 mm between the bottom of
the unit and the panel surface. The panel has to be easily removable to allow access
in the event of technical service.


Specyfikacje produktu

Marka: Smeg
Kategoria: piekarnik
Model: PTS726EB

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Smeg PTS726EB, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje piekarnik Smeg

Smeg

Smeg APF6B-1 Instrukcja

12 Stycznia 2025
Smeg

Smeg SRV573XG Instrukcja

12 Stycznia 2025
Smeg

Smeg BG91CTN2 Instrukcja

11 Stycznia 2025
Smeg

Smeg SFPA6390X2 Instrukcja

10 Stycznia 2025
Smeg

Smeg SFPA6309X Instrukcja

10 Stycznia 2025
Smeg

Smeg SFPA6390X Instrukcja

10 Stycznia 2025
Smeg

Smeg SFA7390X Instrukcja

10 Stycznia 2025
Smeg

Smeg SOA4102M1S Instrukcja

9 Stycznia 2025
Smeg

Smeg SOA4102M1N Instrukcja

9 Stycznia 2025
Smeg

Smeg SFA4390MX Instrukcja

9 Stycznia 2025

Instrukcje piekarnik

Najnowsze instrukcje dla piekarnik