Instrukcja obsługi Singer 1


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Singer 1 (60 stron) w kategorii maszyna do szycia. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/60
10
Power/light switch “OFF”
电源 / 灯源开关关闭
Power / lampu dimatikan
Power/light switch “ON”
电源 / 灯源开关打开
Power / lampu dinyalakan
SETTING UP YOUR MACHINE
Be sure to wipe off any surplus oil from
needle plate area before using your machine
the rst time.
POWER LINE CORD/FOOT CONTROL
Connect the plug of the power line cord into
the cord socket (1) and your wall outlet (2)
as illustrated.
Connect the foot control plug (3) into the
machine socket.
POWER/LIGHT SWITCH
Your machine will not operate until the
power/light switch is turned on. The same
switch controls both the power and the light.
When servicing the machine, or changing
needles, etc., machine must be disconnected
from the power supply.
Always disconnect the machine from power
supply by removing the plug from the electrical
outlet.
NOTE: W h e n f o o t c o n t r o l i s
disconnected, the machine will not
operate.
Power line cord
电源线
Kabel saluran listrik
1
3
Foot control
脚踏控制器
Pedal / trap(injakan dinamo)
Machine socket
2
电源 / 灯源开关关闭 (OFF)
Saklar listrik / lampu
电源插座
Mesin soket
Pin plug
控制器插头
Soket
Set power/light switch at “OFF”
11
电源 / 灯源开关
只有电源 / 灯源开关打开时,机器才能正常运转。电源和车灯由
同一个开关控制。
当维修机器或更换机针等时,必须关闭电源开关。
MERANGKAI MESIN JAHIT ANDA
Pastikan area plat jarum bersih dari sisa minyak sebelum
mulai menggunakan mesin jahit anda.
Kabel saluran listrik/pedal/Trap (injakan dinamo)
Sambungkan steker kabel saluran listrik ke soket (1) dan
stopkontak dinding (2) seperti pada gambar.
Sambungkan steker pedal/Trap (injakan dinamo) (3) ke soket
mesin.
SAKLAR LISTRIK/LAMPU
Mesin jahit anda tidak akan beroperasi sampai saklar listrik/
lampu dinyalakan. Saklar yang sama mengendalikan listrik
maupun lampu.
Ketika memperbaiki mesin, atau mengganti jarum, dan lain-
lain, mesin harus diputus sambungannya dari catu daya.
Selalu putuskan aliran listrik mesin dari catu
daya dengan mencabut steker dari stopkontak
移动机器时,必须关闭电源开关,拔去电源插头。
提示 :脚踏控制器不连接到机器上时,机器不能进行操作。 CATATAN: Mesin tidak akan beroperasi jika pedal/Trap
(injakan dinamo) dicabut.
缝纫前的准备
在第一次使用机器前,请先清除针板上的多余机油。
电源线 / 脚踏控制器
将电源插头 (1) 插入机器的电源插座内,接通电源 (2)。
把脚踏控制器插头 (3) 插入机器的控制器插座内。


Specyfikacje produktu

Marka: Singer
Kategoria: maszyna do szycia
Model: 1

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Singer 1, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje maszyna do szycia Singer

Singer

Singer 4166 Instrukcja

11 Stycznia 2025
Singer

Singer HD6335M Instrukcja

6 Stycznia 2025
Singer

Singer 3333 Instrukcja

31 Grudnia 2025
Singer

Singer HD6330M Instrukcja

31 Grudnia 2025
Singer

Singer M1005 Instrukcja

31 Grudnia 2025
Singer

Singer Ditto Instrukcja

24 Grudnia 2024
Singer

Singer 20E Instrukcja

24 Grudnia 2024
Singer

Singer 457K Instrukcja

24 Grudnia 2024
Singer

Singer 22 Instrukcja

24 Grudnia 2024
Singer

Singer 191E Instrukcja

24 Grudnia 2024

Instrukcje maszyna do szycia

Najnowsze instrukcje dla maszyna do szycia

Pfaff

Pfaff 463H Instrukcja

15 Stycznia 2025
Elna

Elna Lotus ZZ Instrukcja

14 Stycznia 2025
Juki

Juki MS-1190 Instrukcja

12 Stycznia 2025
Pfaff

Pfaff 295-1 Instrukcja

12 Stycznia 2025
Alfa

Alfa 1412 Instrukcja

11 Stycznia 2025