Instrukcja obsługi Sanyo EM-S1000

Sanyo Magnetostrykcja EM-S1000

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Sanyo EM-S1000 (18 stron) w kategorii Magnetostrykcja. Ta instrukcja była pomocna dla 15 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/18
Read these instructions carefully before use.
If you follow these instructions, your Microwave Oven will serve you long and well.
INSTRUCTION MANUAL
Power Source 230V AC, 50Hz
Max. Output Power 1000 Watts
Cavity Size 0.8 cu-ft
Overall Dimensions
(WxDxH) 520mm x 412mm x 296mm
Net Weight Approx. 17 kgs
EM-S1000
Commercial Microwave Oven
EUK/ECO
English
Description Of Oven Parts 2
Installation 3
How To Use Your Microwave Oven Safely 4-5
Care of Your Microwave Oven 5
Oven Control Panel 6
Microwave Oven Cooking Know-How 7
Operating Instructions 7-10
Power Level List 11
Program (2 Stage) Cooking 12-13
Precautions While Heating 14
Usable Cooking Utensils And Materials 14
Checking Accumulative Cooking Time, Number Of Door Operations And
Control Of The Buzzer Sound 15
How To Confirm The Frequency Of Each Course Used 16
Care And Cleaning 17
What To Do If Repairs Are Needed 17
TABLE OF CONTENTS
2
DESCRIPTION OF OVEN PARTS
1. CERAMIC TRAY
2. CONTROL PANEL
3. VENTS
4. SAFETY INTERLOCK SYSTEM
5. CAVITY COVER
1
3
2
4
5
EM-S1000
CONNECTING TO THE MAINS
Before you use your oven, check that the voltage shown
on the data label located on the face of the oven con-
firms with your mains supply. The mains lead is fitted
with a non-removable moulded-on 13 amp plug contain-
ing a 13 amp fuse. If the fuse requires replacing at any
time, the fuse cover should be removed using a small
screwdriver to lever it out. The old fuse should be
replaced by a 13 amp ASTA approved BS1362 fuse and
the fuse cover must be refitted before the plug is used
again.
If the plug supplied on the mains lead is not suitable for
the socket in your home, it should be cut off and dis-
posed of safety, or destroyed, to avoid any possible
shock hazard resulting from the plug being inserted into a
13 ampsocket elsewhere in hte house. A suitable
replacement plug should then be fittd as given below. (If
a 13 amp plug and socket are not used, the circuit sup-
plying the ovenshould contain a 13 amp fuse.)
If the fuse cover is lost or damaged, the plug must not be
used until a replacement is obtained. Replacement fuse
covers are available from Sanyo Service Centres. It is
important that the colour of the replacement fuse cover
corresponds with the coloured insert or as embossed in
words on the base of the plug.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT The wires in this mains lead are coloured
in accordance with the following code:
Green-and-yellow: Earth. Blue: Neutral. Brown: Live
As the colours of the wires in the mains lead of this appli-
ance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol or coloured
green or green-and-yellow.
The wire which is coloured blue must be connected to
the terminalwhich is marked with the letter N or coloured
black.
The wire which is coloured brown must be connected to
the terminal which marked with the letter L or coloured
red.
FUSE The appliance must be protected by a 13-amp
fuse, fitted to the 13-amp mains plug (BS1363).
POSITIONING THE OVEN
1. Install the oven on a flat, level surface sttong enough
to safely bear the weight of the oven.
2. Do not locate the oven near areas where heat and
moisture are generated as this may lower oven efficiency.
3. Covering the air vents may lead to the malfunction-
ing, therefore a minimum of 5 cm is required above, to
each side and to the rear of the oven.
4. This oven conforms to EEC Radio interference
Directive 87/308/EEC, however some interference may
occur if it is placed too close to a radio or TV, so keep
them as far apart as possible.
5. A minimum free space of 17 cm above the oven
should be present.
INSTALLATION
3
SAVE THESE INSTRUCTIONS
WARNING
(a) Do not adjust or repair microwave oven yourself. Do not operate the oven if it is dam aged,
until it has been repaired by a service enginer trained by the manufacturer.
(b) It is dangerous for anyone other than a properly qualified engineer trained by the manufac-
turer to carry out adjustments or repairs.
(c) If the power supply cord is damaged, it must be relaced by the manufacturer, as a specially
prepared cord is required.
(d) On no account remove or interfere with any parts or screws.
THIS COULD PROVE VERY DANGEROUS.

Specyfikacje produktu

Marka: Sanyo
Kategoria: Magnetostrykcja
Model: EM-S1000

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Sanyo EM-S1000, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Magnetostrykcja Sanyo

Sanyo

Sanyo ems 1055 g Instrukcja

17 Grudnia 2024
Sanyo

Sanyo EM-604TW Instrukcja

3 Października 2024
Sanyo

Sanyo EM-S156AS Instrukcja

30 Września 2024
Sanyo

Sanyo EM-5710 Instrukcja

30 Września 2024
Sanyo

Sanyo EM-710F Instrukcja

29 Września 2024
Sanyo

Sanyo emd9552 Instrukcja

28 Września 2024
Sanyo

Sanyo EM-S120W-B Instrukcja

27 Września 2024
Sanyo

Sanyo emd9553n Instrukcja

27 Września 2024
Sanyo

Sanyo EM-S9000 Instrukcja

27 Września 2024
Sanyo

Sanyo em g2052 Instrukcja

27 Września 2024

Instrukcje Magnetostrykcja

Najnowsze instrukcje dla Magnetostrykcja

ACP

ACP JET19 Instrukcja

15 Stycznia 2025
Whirlpool

Whirlpool AMW 594 IX Instrukcja

15 Stycznia 2025
Medion

Medion MD 10482 Instrukcja

15 Stycznia 2025
Candy

Candy CMG 9523 DB Instrukcja

15 Stycznia 2025
Atag

Atag mc 111 f Instrukcja

15 Stycznia 2025
Samsung

Samsung MG11H2020CT Instrukcja

15 Stycznia 2025
Daewoo

Daewoo KOR 63 MDC Instrukcja

15 Stycznia 2025
Siemens

Siemens HF 85961 Instrukcja

15 Stycznia 2025
Whirlpool

Whirlpool AVM 687 IX RVS Instrukcja

15 Stycznia 2025
Daewoo

Daewoo KOR9GQR Instrukcja

15 Stycznia 2025