Instrukcja obsługi Sanus VM1

Sanus Niesklasyfikowane VM1

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Sanus VM1 (18 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/18

ESPAÑOL DEUTSCH FRANÇAIS ITALIANO PYCCKO

Spanish German French Italian Russian Japanese Mandarin

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.05.05

Customer Service: (800) 359-5520 • (651) 484-7988 • fax (651) 636-0367

Customer Service Europe: 31 (0)20 5708938 • fax 31 (0)20 5708989

See complementary Sanus products at www.sanus.com

中文

ENGLISH

International Assembly Instructions for models VM1

ENGLISH

Assembly Instructions for Model: VM1

Thank you for choosing Sanus Systems Vision Mount. This product is designed to

mount VESA 75/100 compatible LCD televisions up to 50 pounds onto a vertical wall.

It allows you to effortlessly tilt and swivel your new television up to 15° in either

direction without the use of tools. Check carefully to make sure there are no missing

or defective parts. Never use defective parts. Improper installation may cause dam-

age or serious injury. If you do not understand these directions, or have any doubts

about the safety of the installation, please call a qualied contractor or contact Sanus

at 800.359.5520 or www.sanus.com. We can quickly assist you with installation ques-

tions and missing or damaged parts. Replacement parts for Sanus products purchased

through authorized dealers will be shipped directly to you.

Required Tools: Drill with 3/16” bit, Phillips screw driver

Parts and Hardware: *Not shown as actual size

(1) Allen Key - b

(1) Monitor Mount - a* (1) Wall Plate - c*

(2) Lag Bolt - d

(4) M4 x 10 Bolt - e (4) Knob Replacement Bolt - f

(1) Large Washer - g (1) Cap - h (1) Small Washer - i (1) Knob - j

Step 1 - Attaching to the Television: Attach the Monitor Mount (a) to the back of your LCD television using the M4 x 10 Bolt (e) as shown in Diagram 1. Place 4 bolts through the

Monitor Mount and tighten snugly into the VESA bolt mounting pattern on the back of the television. Make sure the large side of the tapered hole on the Monitor Mount faces toward

the bottom of the television.

Step 2 - Attaching to the Wall: Hardware for mounting is provided. For all other mounting applications contact a local contractor or hardware store. Use a high quality wood stud

stud sensor to locate a stud. It is a good idea to verify the stud location with an awl or thin nail as shown in Diagram 2a. Use the Wall Plate (c) as a template to mark the two hole loca-

tions on the wall. Make sure these holes are aligned vertically and centered over the stud. Pre-drill the two holes to a depth of 2.5” using a 3/16” drill bit. Attach the Wall Plate to the

wall using the two Lag Bolts (d) as shown in Diagram 2b. Tighten the Lag Bolts rmly with the Allen Key (b).