Instrukcja obsługi Samson Q4

Samson mikrofon Q4

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Samson Q4 (4 stron) w kategorii mikrofon. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

D Y N A M I C M I C R O P H O N E

O W N E R ' S M A N U A L

Thank you for purchasing the Samson Q4 Dynamic Microphone. The Q4 dynamic microphone

brings a high level of accuracy and audio performance to vocal miking applications thanks to its

low mass, neodymium element.

The Q4 is a hand held, dynamic microphone that excels in both live performance and recording

applications. Equipped with a linear frequency response for superior reproduction, it is also

designed to withstand high sound pressure levels. Extremely sensitive, it employs a tight super

cardioid pattern to reduce feedback. A special shock-mounted element minimizes handling

noise and provides additional protection.

In this manual you'll find a detailed description of the features of the Q4 microphone, as well as

instructions for using your Q4, and full specifications. You'll also find a warranty card enclosed-

don't forget to fill it out and send it in! This will enable you to receive online technical support

and will allow us to send you updated information about other Samson products.

Should your Q4 ever require servicing, a Return Authorization (RA) number must be

obtained before shipping your unit to Samson. Without this number, the unit will not be

accepted. Please visit samsontech.com/ra or contact us at support@samsontech.com for

an RA number prior to shipping your unit. Please retain the original packing materials

and, if possible, return the unit in its original carton. If your Q4 was purchased outside

of the United States, contact your local distributor for warranty details and service

information.

Features

The Samson Q4 utilizes state-of-the-art

microphone technology and is

engineered to the finest detail. Here are

some of its main features:

• Ultra sensitive element picks up all of

the nuances of any performance.

• Super cardioid polar pattern minimiz-

es feedback problems and effectively

rejects signals not originating directly

in front of the mic capsule.

• Extended range frequency response

for optimum reproduction and

exceptionally clear, crisp sound.

• Handy ON/OFF switch for on-stage

control.

Samson Technologies Corp.

278-B Duffy Avenue

Hicksville, NY 11801

Phone: 1-800-3-SAMSON (1-800-372-6766)

www.samsontech.com

• Special shock-mounting allows move-

ment of the mic element to greatly

reduce handling noise.

• Rugged zinc alloy die-casting case

ensures reliable performance in even

the most demanding environments.

• The Q4 can be mounted on any stan-

dard microphone stand (using the

included mic clip).

• Withstands high SPLs lending itself to a

wide range of miking

situations.

• Low impedance output lets the Q4 send

a strong full bandwidth signal over long

cable runs.

• Gold plated XLR Connector.

Microphone Placement and Tone Quality

Listed are some common microphone placement techniques. Use these suggestions as a

guide and let your ears determine what works best in your situation.

• Sound source less than 6 inches away from mic—Full sound, pronounced bass,

increased isolation from background noise.

• Sound source 6 inches to 2 feet away from mic—Balanced natural sound, less bass,

some background noise.

• Sound source 3 to 6 feet away from mic—Thinner ambient sound.

Guidelines for Microphone Use

• Aim the microphone at the desired source. Keep unwanted sound sources at a 135°

angle from the front of the microphone (see polar pattern).

• Place the microphone as close to the sound source as possible.

• Use the proximity effect to your advantage: The closer the mic is to the sound

source, the more emphasized the bass response will be.

• When operating outdoors, use a foam windscreen to suppress unwanted wind

noise.

• Never cup your hand over the microphone grill.

Operating Notes

• The Q4 will boost bass frequencies when the microphone is between 0—6 inch-

es from the sound source. As you move the sound source further away from the

microphone, the bass response will gradually roll off.

• The Q4 has a built-in wind screen which protects against most wind and breathing

noise. Under adverse conditions, such as high winds, an optional foam windscreen

(Samson part number, WS5) can be used.

• For maximum signal handling capability and minimal distortion, a minimum load

impedance of 800 ohms should be used. A reduction in output signal strength and

output clipping level will result with the load at 150 ohms.

Q4 Hook-up and Mounting

The Q4 can be connected to any mixer, mixer/amplifier, or mic preamp using a standard

microphone cable. Connect the female XLR end directly to the Q4’s gold-plated connec-

tor and the other end (normally a male XLR end, although some mixers use 1/4" connec-

tors) to the mixer, mixer/amplifier, or mic preamp. Detailed wiring diagrams for XLR and

XLR to 1/4 cables can be found on the back page of this manual.

The Q4 can be mounted to any standard microphone stand (using the included mic clip) or

can be handheld; due to its unique mic element shock mounting, it generates significantly

less handling noise than most other microphones. If handheld, take care not to cover the

any part of the head grille with your hand. Be aware of a phenomenon called the proxim-

ity effect which causes a noticeable increase in low frequencies (bass response) when a

microphone is close to the audio source. This can have positive impact—for example, it will

cause your voice to sound much fuller when you sing close to the mic than when you sing

at a distance. The Q4 is specially designed to be used up close, since it provides a built-in

windscreen for removal of pops, sibilance and on stage noise. The key to developing the

best mic technique is experimentation, along with awareness of the general principle that,

the closer your Q4 is to a signal source, the greater the bass response.

Q4 Polar Pattern

Every microphone has a characteristic polar

pattern that determines how well it accepts

or rejects signal coming from various areas

around the microphone. For example, omnidi-

rectional mics accept all signals regardless of

wherever those signals originate (in front of the

mic, behind it, to the side, etc.).

In contrast, unidirectional, or cardioid, mics are

specifically designed to accept mostly signal

coming from directly in front, and to reject

signal coming from behind or from the side.

The super cardioid pattern is utilized by the

Q4 (as shown in the illustration below). For

this reason, the Q4 excels in environments where there is a good deal of unwanted ambi-

ent sound—it delivers those signals originating directly in front of the mic capsule itself

while rejecting those that originate from behind.

The polar pattern also determines how prone a particular mic is to inducing feedback.

Feedback is that characteristic nasty howling sound that occurs when a mic is placed too

close to a loudspeaker—the signal from the loudspeaker is fed into the mic, then into the

loudspeaker, then into the mic, over and over again until an oscillating tone is generated.

Because the super cardioid pattern utilized by the Q4 is so good at rejecting signal not

coming from directly in front of the mic, you’ll find that use of the Q4 greatly minimizes

feedback problems.

Q4 Polar Pattern

Specyfikacje produktu

Marka:	Samson
Kategoria:	mikrofon
Model:	Q4

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Samson Q4, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje mikrofon Samson

Samson AirLine Micro ESm Instrukcja

30 Stycznia 2025

Samson Rubicon R10S Instrukcja

3 Stycznia 2025

Samson HXD1 Instrukcja

7 Października 2024

Samson AirLine XDm Instrukcja

5 Października 2024

Samson AirLine XD Instrukcja

4 Października 2024

Samson Qe Instrukcja

3 Października 2024

Samson Concert 88 Camera Instrukcja

29 Września 2024

Samson DEU1 Instrukcja

23 Września 2024

Samson CR77 Receiver Instrukcja

23 Września 2024

Samson Go Mic Mobile HXD2 Instrukcja

16 Września 2024

Instrukcje mikrofon

Najnowsze instrukcje dla mikrofon

MXL Forge Instrukcja

22 Marca 2025

Austrian Audio OC16 Instrukcja

19 Marca 2025

Kenwood KMC-66 Instrukcja

18 Marca 2025

Kenwood KMC-70 Instrukcja

18 Marca 2025

Kenwood KMC-32 Instrukcja

18 Marca 2025

Comica Vimo C2 Instrukcja

12 Marca 2025

Louroe Electronics Verifact B Instrukcja

10 Marca 2025

Louroe Electronics Verifact C Instrukcja

10 Marca 2025

Louroe Electronics Verifact K Instrukcja

10 Marca 2025

Louroe Electronics C-ML Instrukcja

10 Marca 2025