Instrukcja obsługi Pyle PRJELMT76


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pyle PRJELMT76 (2 stron) w kategorii Ekran projekcyjny. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/2
INSTALLATION AND USAGE OF ELECTRIC SCREEN:
When you need to hang projection
screen on the ceiling, you should
install two pieces of pothooks at
the corresponding position on the
ceiling rst, then latch on hanging
hook which is on the end cap of
projection screen.
CEILING MOUNT:
Press the button to raise the UP
screen and the button to DOWN
lower the screen for viewing. Press
STOP at any point to position the
screen anywhere in between its
highest and lowest position
* NOTE: Screen can be controlled by both wired and
wireless controllers
REMOTE USAGE:
WALL MOUNT:
There is a key ring on the bracket
at both ends of the screen, when
you need to hang projection
screen on the wall, you should
hammer down nails or install
screws at the corresponding
position on the wall rst, then
hang up the screen.
Carefully remove the screen after opening the box. Be careful
not to damage the surface of the screen or its housing during
this process.
According to projecting requirements, x up the wall shelf
securely. (Note that the two wall shelves must be at the same
height, otherwise screen surface will be slanted to one side)
Carefully hang the screen on the wall shelf.
Once installation is complete, a red light will show on the switch box
when the screen is powered on. Press the and switch on UP DOWN
the switch box to make sure the screen functions normally.
Use either the wired, or included wireless remote to control the
screen according to your preference.
1.
2.
3.
4.
5.
NAIL
WALL
SCREEN DIRECTION
SCREEN
HOUSING
SCREEN DIRECTION
SCREEN
HOUSING
CEILING
POTHOOK
HANGING
HOOK
SCREEN
HOUSING
WIRED
REMOTE
HANGING
HOOK
Models:
PRJELMT76
PRJELMT86
PRJELMT106
Motorized Projector Screen
w/ Remote Control
Specications
Troubleshooting
PRJELMT106PRJELMT86PRJELMT76MODEL
68.9’ x 80.7’60.2’ x 68.9’52.8’ x 59.1’
TOTAL SCREEN SIZE
100 in. Diagonal
(59.1’’ x 78.7’’)
84 in. Diagonal
(50.4’’ x 67.0’’)
72 in. Diagonal
(42.9’’ x 57.0’’)
VIEWING AREA
91.0’79.1’69.3’
HOUSING WIDTH
Aspect Ratio: 4:3/HD
Viewing Area: 128cm *170cm
Screen Gain: 1.3, Triple layered
Surface: Matte white, washable
Borders: Standard 4 black masking borders
Casing Color: White
Operation: Wired controller, Wireless remote control
Power: 120V, AC
YELLOW HOLE:
Adjust the max retraction position if screen does
not stop where it should when being retracted into
the housing. Adjust clockwise and counterclockwise
until you reach your desired position.
GREY HOLE:
Adjust the if screen does not stop max drop position
where it should when being lowered for viewing.
Adjust clockwise and counterclockwise until you
reach your desired position.
FIXING THE MIN/MAX POSITION
Every screen is factory set to an adequate xed position before packaging, however
due to movement during transportation, this position may shift. This is entirely normal
and can easily be remiedied by adjusting the two holes as detailed below:


Specyfikacje produktu

Marka: Pyle
Kategoria: Ekran projekcyjny
Model: PRJELMT76

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Pyle PRJELMT76, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Ekran projekcyjny Pyle

Pyle

Pyle PRJSM1006 Instrukcja

20 Września 2024
Pyle

Pyle PRJTP102 Instrukcja

11 Września 2024
Pyle

Pyle PRJTP52 Instrukcja

8 Września 2024
Pyle

Pyle PRJTP72 Instrukcja

31 Sierpnia 2024
Pyle

Pyle PRJOS80 Instrukcja

30 Sierpnia 2024
Pyle

Pyle PRJTP103 Instrukcja

29 Sierpnia 2024
Pyle

Pyle PRJTPOTS71 Instrukcja

26 Sierpnia 2024
Pyle

Pyle PRJOS120 Instrukcja

26 Sierpnia 2024
Pyle

Pyle PRJTP53 Instrukcja

25 Sierpnia 2024
Pyle

Pyle PRJTPFL102 Instrukcja

22 Sierpnia 2024

Instrukcje Ekran projekcyjny

Najnowsze instrukcje dla Ekran projekcyjny