Instrukcja obsługi Philips Series 7000 BT7206
Philips
Trymer do brody
Series 7000 BT7206
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Philips Series 7000 BT7206 (6 stron) w kategorii Trymer do brody. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/6
BT7206
© 2017 Koninklijke Philips N.V.
All rights reserved
保留所有权利
4222.002.8831.1 (13/2/2017)
> 75% 循环再造纸
2
3
4
5
3.0
10
0.5
6
7
8
9
10
11
12
13
14
15
16
17
18
>75% recycled paper >75%
papier recyclé
English
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
General description (Fig.1)
1 Cutting element
2 Vacuum system
3 Length settings
4 Zoom wheel
5 On/off button
6 Battery status indicator
7 Cleaning sponge
8 Cleaning brush
9 Small plug
10 Supply unit
11 Beard and stubble comb
Important safety information
Read this important information carefully before
you use the appliance and its accessories and save
it for future reference. The accessories supplied
may vary for different products.
Danger
- Keep the supply unit dry (Fig. 2).
Warning
- To charge the battery, only use the detachable
supply unit (HQ8505) provided with the
appliance.
- The supply unit contains a transformer. Do not
cut off the supply unit to replace it with another
plug, as this causes a hazardous situation.
- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by
children without supervision.
- Always check the appliance before you use it.
Do not use the appliance if it is damaged, as
this may cause injury. Always replace a
damaged part with one of the original type.
- Do not open the appliance to replace the
rechargeable battery.
Caution
- This appliance is not washable. Never immerse
the appliance in water and do not rinse it under
the tap (Fig. 2).
- Only use this appliance for its intended purpose
as shown in the user manual.
- For hygienic reasons, the appliance should only
be used by one person.
- Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the
appliance.
- Do not use the supply unit in or near wall
sockets that contain an electric air freshener to
prevent irreparable damage to the supply unit.
Electromagnetic fields (EMF)
- This Philips appliance complies with all
applicable standards and regulations regarding
exposure to electromagnetic fields.
General
- The appliance is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
Display
Battery status indicator
- When the battery is almost empty, the battery
charge indicator flashes orange (Fig. 3).
- When the appliance is charging, the battery
charge indicator flashes white (Fig. 4).
- When the battery is fully charged, the battery
charge indicator lights up white continuously
(Fig. 5).
Note: The lights switch off automatically after 30
minutes.
3.0
1
2
3
4
5
6
9
8
7
10
11
1
Length settings
The selected hair length setting will show above
the zoom wheel when you select the desired
length setting with the zoom wheel (Fig. 6).
Charging
Charging takes approx. 1 hour. Charge the
appliance before first use and when the bottom
light of the battery status indicator flashes orange.
1 Make sure the appliance is switched off.
2 Put the supply unit in the wall socket and put
the small plug in the appliance (Fig. 7).
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
When the appliance is fully charged, it has a
cordless operating time of up to 60 minutes.
Using the appliance
Note: This appliance can be used without cord or
directly from the wall socket.
You can use this appliance for a stubble beard and
a short beard. This appliance has an integrated
vacuum system that catches cut beard hair for
a less messy trimming experience.
The vacuum system is activated automatically as
soon as you switch on the appliance.
Note: Switch off and clean the appliance after each
use.
Switching the appliance on and off
Press the on/off button once to switch the
appliance on or off (Fig. 8).
Trimming without comb
- You can use the appliance without beard and
stubble comb to trim hair close to the skin or to
contour the neckline and sideburns. To trim hair
close to the skin, place the flat side of the
trimming head against your skin and make
strokes in the desired direction (Fig. 9).
- For contouring, hold the trimming head
perpendicular to the skin and move the
trimming head upwards or downwards with
gentle pressure (Fig. 10).
Trimming with comb
Note: When you trim for the first time, start at the
highest length setting to familiarise yourself with
the appliance.
You can use the beard and stubble comb attached
to the cutting element to groom your beard and
moustache in your preferred style. For the beard
and stubble comb, you can turn the zoom wheel to
choose from 20 length settings ranging from
0.5mm to 10mm in steps of 0.5mm.
Note: Switch off and clean the appliance after each
use.
1 Attach the comb onto the appliance (Fig. 11).
2 Turn the zoom wheel to select the desired
length setting (Fig. 6).
Note: When you trim for the first time, start at
the highest length setting to familiarize yourself
with the appliance.
3 Switch on the appliance.
4 To trim most effectively, move the appliance
against the hair growth direction. Make sure that
the surface of the comb always stays in contact
with the skin (Fig. 12).
Cleaning and maintenance
Cleaning the appliance
Note: Only the cutting element and the comb can
be cleaned with water.
We advise you to empty the hair-collection
chamber after each trimming session. When you
trim long, dense beards, it may also be necessary
to empty the hair-collection chamber during the
trimming session in order to maintain optimal
suction performance.
1 Switch off the appliance and disconnect it from
the wall socket.
2 Wipe the housing of the appliance with a dry
cloth.
3 Remove the comb (Fig. 13) and clean it with the
cleaning brush and/or rinse it under the tap
(Fig. 14).
4 Remove the cutting element and clean it under
the tap (Fig. 15). Carefully shake off excess
water and let the cutting element air-dry
completely.
Caution: Never dry the cutting element with a
towel or tissue, as this may damage the trimming
teeth.
5 Shake out the hairs that have collected in the
hair chamber.
6 Brush out the hairs with the cleaning brush (Fig.
16) or cleaning sponge (Fig. 17) supplied.
7 After cleaning, reattach the cutting element (Fig.
18) and comb (Fig. 11) to the appliance.
Recycling
- Do not throw away the product with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this, you help to preserve the
environment.
- This product contains a built-in rechargeable
battery which shall not be disposed of with
normal household waste. We strongly advise
you to take your product to an official collection
point or a Philips service centre to have a
professional remove the rechargeable battery.
- Follow your country’s rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.
Removing the rechargeable battery
Only remove the rechargeable battery when
you discard the appliance. Before you remove
the battery, make sure that the appliance is
Specyfikacje produktu
Marka: | Philips |
Kategoria: | Trymer do brody |
Model: | Series 7000 BT7206 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Philips Series 7000 BT7206, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Trymer do brody Philips
3 Października 2024
3 Października 2024
3 Października 2024
2 Października 2024
2 Października 2024
2 Października 2024
2 Października 2024
28 Września 2024
28 Września 2024
28 Września 2024
Instrukcje Trymer do brody
- Trymer do brody Beurer
- Trymer do brody Braun
- Trymer do brody Livoo
- Trymer do brody SilverCrest
- Trymer do brody Stihl
- Trymer do brody Severin
- Trymer do brody Panasonic
- Trymer do brody BaByliss
- Trymer do brody Domo
- Trymer do brody Conair
- Trymer do brody Taurus
- Trymer do brody Grundig
- Trymer do brody Remington
- Trymer do brody Hyundai
- Trymer do brody Rowenta
- Trymer do brody Unold
- Trymer do brody Trisa
- Trymer do brody Zelmer
- Trymer do brody Teesa
- Trymer do brody Emerio
- Trymer do brody Arzum
- Trymer do brody Melissa
- Trymer do brody Fagor
- Trymer do brody Koenic
- Trymer do brody Izzy
- Trymer do brody Wahl
- Trymer do brody Eta
- Trymer do brody Scarlett
- Trymer do brody TriStar
- Trymer do brody Aurora
- Trymer do brody DCG
- Trymer do brody G3 Ferrari
- Trymer do brody Ferrari
- Trymer do brody Princess
- Trymer do brody Innoliving
- Trymer do brody Solac
- Trymer do brody GA.MA
- Trymer do brody Moser
- Trymer do brody Lanaform
- Trymer do brody Sencor
- Trymer do brody ProfiCare
- Trymer do brody Vitek
- Trymer do brody Alpina
- Trymer do brody Sinbo
- Trymer do brody Jata
- Trymer do brody Termozeta
- Trymer do brody Palson
- Trymer do brody Imetec
- Trymer do brody Efbe-schott
- Trymer do brody Coline
- Trymer do brody Carmen
- Trymer do brody Andis
- Trymer do brody Steamery
- Trymer do brody Girmi
- Trymer do brody VS Sassoon
Najnowsze instrukcje dla Trymer do brody
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
8 Października 2024
8 Października 2024
6 Października 2024
6 Października 2024