Instrukcja obsługi Panasonic PT-40LC12

Panasonic Telewizja PT-40LC12

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Panasonic PT-40LC12 (72 stron) w kategorii Telewizja. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/72

Models No. PT-40LC12/PT-45LC12

For assistance, please call :

1-888-VIEW PTV(843-9788)

or send e-mail to :

consumerproducts@panasonic.com

or visit us at www.panasonic.com

For assistance, please call :

787-750-4300

or visit us at www.panasonic.com

LSQT0583A

Multi-Media Projection Display

Operating Instructions

(USA)

(Puerto Rico)

Three Important Reasons to Register Your Product Immediately!

1 Protect Your New Investment...

your new projection display is stolen.

2 Product safety notification...

Registering your product can help us to contact you in the unlikely

event a safety notification is required under the Consumer Product

Safety Act.

3 Improved Product Development...

Help us continue to design products that meet your needs.

For assistance, please call : 1-888-VIEW PTV(843-9788)

Important Safety Instructions

This symbol warns the user

that uninsulated voltage within

the unit may have sufficient

magnitude to cause electric

shock.

Therefore, it is dangerous to

make any kind of contact with

any inside part of this unit.

This symbol alerts the user that

important literature concerning

the operation and maintenance

of this unit has been included.

Therefore, it should be read

carefully in order to avoid any

problems.

The pictorial representation of

a hot surface within a triangle

is intended to tell the user that

parts inside the product are a

risk of burns to persons.

Note to CATV System Installer: This reminder is provided to call the CATV system installer’s attention to Article

820–40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall

be connected to the grounding system of the building, as close to the point of cable entry as practical.

Important Safety Instructions For Projection display

WARNING: To reduce the risk of electric shock, do not remove cover or back. No

user-serviceable parts inside. Refer servicing to qualified service personnel.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

1. Read and apply the operating instructions provided with your projection display.

2. Read all of the instructions given here and retain them for later use.

3. Follow all warnings and instructions marked on the projection display.

4. Unplug this projection display from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a

damp cloth for cleaning.

5. Do not use attachments / accessories not recommended by the projection display manufacturer as they may cause

hazards.

6. Do not use this projection display near water. For example: Avoid placing it near a bathtub, washbowl, kitchen sink,

or laundry tub, in a wet basement, or near a swimming pool, etc.

7. Do not place this projection display on an unstable cart, stand or table. The projection display may fall,

causing serious injury to a child or adult, and serious damage to the appliance. Use only with a cart or

stand recommended by the manufacturer, or sold with the projection display.

7A. An appliance and cart combination shall be moved with care. Quick stops, excessive force, and uneven

surfaces may cause the appliance and cart combination to overturn.

8. Slots and openings in the cabinet and the back are provided for ventilation, to ensure reliable operation of the

projection display and to protect it from overheating. These openings must not be blocked or covered. There shall

be at least 10 cm of space from these openings. The openings shall never be blocked by placing the projection

display on a bed, sofa, rug or other similar surface. This projection display shall never be placed near or over a

radiator or heat register. This projection display shall not be placed in a built-in installation such as a bookcase

unless proper ventilation is provided.

9. Operate only from the type of power source indicated on the marking label. If you are not sure of the type of power

supplied to your home consult your television dealer or local power company.

10. This projection display is equipped with a polarized alternating-current line plug

(a plug having one blade wider than the other). This plug will fit into the power

outlet only one way. This is a safety feature. If you are unable to insert the plug

fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact

your electrician to replace your obsolete outlet. Do not defeat the safety purpose

of the polarized plug.

11. Do not allow anything to rest and to pinch on the power cord. Do not locate this

projection display where the power cord will walked on.

12. Do not overload wall outlets and extension cords as this can result in fire or electric shock.

13. Never push objects of any kind into this projection display through cabinet slots as they may touch dangerous

voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the

projection display.

Getting Started

Important Safety Instructions

This product has a High Intensity Discharge (HID) lamp that contains a small amount of mercury. It also contains

lead in some components.

Disposal of these materials may be regulated in your community due to environmental considerations.

For disposal or recycling information please contact your local authorities, or the Electronics Industries Alliance:

<http://www.eiae.org.>

14. If an outside antenna is connected to the television equipment, be sure the antenna system is grounded so as to

provide some protection against voltage surges and built up static charges. In the U.S.Selection 810 of the National

Electrical Code provides information with respect to proper grounding of the mast and supporting structure,

grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-

discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See Figure.

15. For added protection for this projection display during a lightning storm, or when it is left unattended and unused for

long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the

receiver due to lightning and power-line surges.

16. An outside antenna system shall not be located in the vicinity of overhead power lines or other electric light or

power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system

extreme care shall be taken to keep from touching such power lines or circuits as contact with them might be fatal.

17. Unplug this projection display from the wall outlet, and refer servicing to qualified service personnel under the

following conditions:

a. When the power cord or plug is damaged or frayed.

b. If liquid has been spilled into the projection display.

c. If the projection display has been exposed to rain or water.

d. If the projection display does not operate normally by following the operating instructions. Adjust only those

controls that are covered by the operating instructions as improper adjustment of other controls may result in

damage and will often require extensive work by a qualified technician to restore the projection display to normal

operation.

e. If the projection display has been dropped or the cabinet has been damaged.

f. When the projection display exhibits a distinct change in performance - this indicates a need for service.

18. Do not attempt to service this projection display yourself as opening or removing covers may expose you to

dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19. When replacement parts are required, be sure the service technician has used replacement parts specified by the

manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire,

electric shock, or other hazards.

20. Upon completion of any service or repairs to this projection display, ask the service technician to perform routine

safety checks to determine that the projection display is in safe operating condition.

21. WARNING: To prevent fire or shock hazard, do not expose this appliance to rain or moisture.

22. WARNING: Because the temperature of the lamp unit is elevated immediately after its use, directly touching it

may cause burns. After the lamp has cooled enough, replace the lamp unit.

23. CAUTION: To prevent electric shock, match wide blade of plug to wide slot of AC outlet and fully insert. Do not

use this (polarized) plug with a receptacle or other outlet unless the blade can be fully inserted to

prevent blade exposure.

Clean the air filter regularly. Not cleaning the air filter could shorten the life of the set.

The lamp has a maximum life of about 5 000 hours.

If use exceeds this figure, the possibility of lamp damage becomes greater.

The lamp should be changed as soon as possible once the lamp warning message appears.

If the lamp is damaged, please contact your nearest dealer.

When VIEWING MODE is set to CINEMA, brightness will be reduced, but the life of the LCD panel can be

prolonged. Therefore, the CINEMA setting is recommended when possible.

Specyfikacje produktu

Marka:	Panasonic
Kategoria:	Telewizja
Model:	PT-40LC12
Kolor produktu:	Ciemnoszary
Waga produktu:	4640 g
Wymiary produktu (SxGxW):	184 x 336 x 322 mm
Bieg wsteczny:	Tak
Rozdrabniacz:	Rozdrabnianie krzyżowe
Niszczenie zszywek:	Tak
Szerokość szczeliny wejściowej:	230 mm
Niszczenie płyt CD:	Nie
Niszczenie papieru:	Tak
Niszczenie kart kredytowych:	Tak
Poziom ochrony:	3
Ilość arkuszy niszczonych jednocześnie:	7 ark.
Wymiary ścinek:	4 x 46 mm
Prędkość niszczenia:	3600 mm/min
Pojemność kosza:	17 l