Instrukcja obsługi Onkyo TX-8030

Onkyo odbiornik TX-8030

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Onkyo TX-8030 (40 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/40

Stereo Receiver

TX-8030

Instruction Manual

Thank you for purchasing an Onkyo Stereo Receiver.

Please read this manual thoroughly before making

connections and plugging in the unit.

Following the instructions in this manual will enable

you to obtain optimum performance and listening

enjoyment from your new Stereo Receiver.

Please retain this manual for future reference.

Contents

Introduction ..................................En-2

Connections.................................En-9

Enjoying Audio Sources...... En-17

Appendix

Troubleshooting..................... En-37

Specifications ......................... En-39

En-2

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in

accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radia-

tors, heat registers, stoves, or other apparatus

(including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or

grounding-type plug. A polarized plug has two

blades with one wider than the other. A grounding

type plug has two blades and a third grounding

prong. The wide blade or the third prong are pro-

vided for your safety. If the provided plug does not

fit into your outlet, consult an electrician for

replacement of the obsolete outlet.

10. Protect the power cord from being walked on or

pinched particularly at plugs, convenience recepta-

cles, and the point where they exit from the appara-

tus.

11. Only use attachments/accessories specified by the

manufacturer.

12.

Use only with the cart, stand,

tripod, bracket, or table spec-

ified by the manufacturer, or

sold with the apparatus.

When a cart is used, use cau-

tion when moving the cart/

apparatus combination to

avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or

when unused for long periods of time.

14. Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been

damaged in any way, such as power-supply cord or

plug is damaged, liquid has been spilled or objects

have fallen into the apparatus, the apparatus has

been exposed to rain or moisture, does not operate

normally, or has been dropped.

15. Damage Requiring Service

Unplug the apparatus from the wall outlet and refer

servicing to qualified service personnel under the

following conditions:

A. When the power-supply cord or plug is damaged,

B. If liquid has been spilled, or objects have fallen

into the apparatus,

C. If the apparatus has been exposed to rain or

water,

D. If the apparatus does not operate normally by

following the operating instructions. Adjust only

those controls that are covered by the operating

instructions as an improper adjustment of other

controls may result in damage and will often

require extensive work by a qualified technician

to restore the apparatus to its normal operation,

E. If the apparatus has been dropped or damaged in

any way, and

F. When the apparatus exhibits a distinct change in

performance this indicates a need for service.

16. Object and Liquid Entry

Never push objects of any kind into the apparatus

through openings as they may touch dangerous volt-

age points or short-out parts that could result in a

fire or electric shock.

The apparatus shall not be exposed to dripping or

splashing and no objects filled with liquids, such as

vases shall be placed on the apparatus.

Don’t put candles or other burning objects on top of

this unit.

17. Batteries

Always consider the environmental issues and fol-

low local regulations when disposing of batteries.

18. If you install the apparatus in a built-in installation,

such as a bookcase or rack, ensure that there is ade-

quate ventilation.

Leave 20 cm (8") of free space at the top and sides

and 10 cm (4") at the rear. The rear edge of the shelf

or board above the apparatus shall be set 10 cm (4")

away from the rear panel or wall, creating a flue-

like gap for warm air to escape.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPARATUS

TO RAIN OR MOISTURE.

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK). NO

USER-SERVICEABLE PARTS INSIDE. REFER

SERVICING TO QUALIFIED SERVICE

PERSONNEL.

The lightning flash with arrowhead symbol, within an

equilateral triangle, is intended to alert the user to the

presence of uninsulated “dangerous voltage” within

the product’s enclosure that may be of sufficient

magnitude to constitute a risk of electric shock to

persons.

The exclamation point within an equilateral triangle is

intended to alert the user to the presence of important

operating and maintenance (servicing) instructions in

the literature accompanying the appliance.

WARNING

RISK OF ELECTRIC SHOCK

DO NOT OPEN

RISQUE DE CHOC ELECTRIQUE

NE PAS OUVRIR

AVIS

PORTABLE CART WARNING

S3125A

En-3

Precautions

1. Recording Copyright—Unless it’s for personal use

only, recording copyrighted material is illegal with-

out the permission of the copyright holder.

2. AC Fuse—The AC fuse inside the unit is not user-

serviceable. If you cannot turn on the unit, contact

your Onkyo dealer.

3. Care—Occasionally you should dust the unit all

over with a soft cloth. For stubborn stains, use a soft

cloth dampened with a weak solution of mild

detergent and water. Dry the unit immediately

afterwards with a clean cloth. Don’t use abrasive

cloths, thinners, alcohol, or other chemical solvents,

because they may damage the finish or remove the

panel lettering.

4. Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE

FIRST TIME, READ THE FOLLOWING SEC-

TION CAREFULLY.

AC outlet voltages vary from country to country.

Make sure that the voltage in your area meets the

voltage requirements printed on the unit’s rear panel

(e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit

from the AC power source. Make sure that the plug

is readily operable (easily accessible) at all times.

Pressing ON/STANDBY to select Standby mode

does not fully disconnect from the mains. If you do

not intend to use the unit for an extended period,

remove the power cord from the AC outlet.

5. Preventing Hearing Loss

Caution

Excessive sound pressure from earphones and head-

phones can cause hearing loss.

6. Batteries and Heat Exposure

Warning

Batteries (battery pack or batteries installed) shall

not be exposed to excessive heat as sunshine, fire or

the like.

7. Never Touch this Unit with Wet Hands—Never

handle this unit or its power cord while your hands

are wet or damp. If water or any other liquid gets

inside this unit, have it checked by your Onkyo

dealer.

8. Handling Notes

• If you need to transport this unit, use the original

packaging to pack it how it was when you origi-

nally bought it.

• Do not leave rubber or plastic items on this unit

for a long time, because they may leave marks on

the case.

• This unit’s top and rear panels may get warm

after prolonged use. This is normal.

• If you do not use this unit for a long time, it may

not work properly the next time you turn it on, so

be sure to use it occasionally.

For British models

Replacement and mounting of an AC plug on the power

supply cord of this unit should be performed only by

qualified service personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance

with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured mark-

ings identifying the terminals in your plug, proceed as

follows:

The wire which is coloured blue must be connected to

the terminal which is marked with the letter N or

coloured black.

The wire which is coloured brown must be connected to

the terminal which is marked with the letter L or

coloured red.

IMPORTANT

The plug is fitted with an appropriate fuse. If the fuse

needs to be replaced, the replacement fuse must

approved by ASTA or BSI to BS1362 and have the

same ampere rating as that indicated on the plug. Check

for the ASTA mark or the BSI mark on the body of the

fuse.

If the power cord’s plug is not suitable for your socket

outlets, cut it off and fit a suitable plug. Fit a suitable

fuse in the plug.

For European Models

Declaration of Conformity

We, ONKYO EUROPE

ELECTRONICS GmbH

LIEGNITZERSTRASSE 6,

82194 GROEBENZELL,

GERMANY

GROEBENZELL, GERMANY

ONKYO EUROPE ELECTRONICS GmbH

K. MIYAGI

declare in own responsibility, that the ONKYO product

described in this instruction manual is in compliance with the

corresponding technical standards such as EN60065,

EN55013, EN55020 and EN61000-3-2, -3-3.

Specyfikacje produktu

Marka:	Onkyo
Kategoria:	odbiornik
Model:	TX-8030
Kolor produktu:	Srebrny
Częstotliwość wejściowa AC:	50 Hz
Napięcie wejściowe AC:	230 V
Wysokość produktu:	151 mm
Szerokość produktu:	435 mm
Głębokość produktu:	328 mm
Waga produktu:	8800 g
W zestawie pilot zdalnego sterowania:	Tak
Podręcznik użytkownika:	Tak
Technologia łączności:	Przewodowa
Impedancja:	16 Ω
Moc wyjściowa (RMS):	260 W
Wi-Fi:	Nie
Moc wyjściowa na kanał (20-20kHz @ 8 Ohm):	130 W
Kanały wyjścia audio:	2.0 kan.
Wejscie Audio (L,P):	6
Przewodowa sieć LAN:	Nie
Zakresy tunera:	AM, FM
Ilość stacji:	40
Napęd optyczny dołączone:	Nie
Pobór mocy:	278 W
Waga wraz z opakowaniem:	11300 g
Baterie w zestawie:	Tak
Wyście mocy ac:	Tak
Wymiary opakowania (SxGxW):	572 x 419 x 264 mm
Współczynnik zawartości harmonicznych:	0.08 %
Stosunek sygnału do szumu:	106 dB
Regulacja głośności:	obrotowy
Kompatybilność dokowania produktów Apple:	iPhone, iPod
Moc dynamiczna na kanał (3 Ohm):	180 W
Moc dynamiczna na kanał (4 Ohm):	160 W
Moc dynamiczna na kanał (8 Ohm):	100 W
Czułość wejścia:	200 mV
Poziom wyjścia:	200 mV
Impedancja wejściowa:	47000 Ω
Impedencja wyjścia:	2200 Ω
Maksymalny poziom na wejściu:	2 V
Złożone wejście wideo:	1
Zdalne wejście IR:	1
Zespolony sygnał wizji:	1
Wyjście audio (prawe/lewe):	2
Typ podłączenia głośników:	Złącze bananowe
Ilość portów anteny AM:	1
Ilość portów anteny FM:	1
Złącze banan:	8
Dołączony tuner RDS:	Tak
RDS:	PS, PTY, RT, TP
Pasmo AM:	522 - 1611 kHz
Pasmo FM:	87.5 - 108 MHz
Regulacja poziomu tonów niskich:	Tak
Regulacja poziomu tonów wysokich:	Tak
Wyzwalacz 12V:	Tak
Ilość portów 12V:	1
Wejścia Phono (RCA):	1